Page 42 of 44
38-42
      
Wiring harness in transmission, 
removing and installing
 
     
Removing  
     
-  Removing valve body   page 38
-22
 .
    
Only for Park/Neutral Position (PNP) Switch -E17-  -  Lever out retainer straps of connectors at solenoid valves using a small 
screwdriver and disconnect connectors -A- in sequence. 
-  Unhook wiring harness at side retainer straps -B- of valve body.
    
-  Turn valve body on its back side and loosen connector at Sensor for 
transmission RPM -1-. 
-  Remove retaining clip (arrow A) and unclip wiring harness from 
retaining clip (arrow B). 
-  Disconnect connector -2- from Solenoid Valve 4 -N91-.
Pa
ge 42 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
     
        
        Page 43 of 44
38-43
      
Only for transmission with hydraulic control 
E18/2 
    
Installing, valid for all:  
Installation is reverse of removal, noting the following:  -  Turn valve body on its back side and loosen connector at Sensor for 
transmission RPM -1-. 
-  Remove retaining clip (arrow A) and unclip wiring harness from 
retaining clip (arrow B). 
-  When installing, connect connectors of wiring harness to the 
corresponding solenoid valves. 
-  Clip wiring harness into the respective retaining clips. In case of 
deviations, the wiring harness can be pinched during installation of the 
valve body. 
- Installing valve body   page 38
-25
 .
-  Fill up ATF   page 37
-140
 .
Pa
ge 43 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
     
        
        Page 44 of 44
38-44
      
Transmission Fluid Temperature Sensor 
-G93-, replacing
 
     
Note:  
     Transmission Fluid Temperature Sensor -G93- is 
integrated in the transmission wiring harness. 
     
Removing  
     
-  Remove wiring harness in transmission   page 
38
-42
 . 
     
Installing  
      Installation is the reverse of removal. Also carry 
out the following procedure.  
     
-  Replace wiring harness with a new one.
Pa
ge 44 of 44 Oil 
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1 
     
        
          
   
    
    Page:  
    < prev   1-8  9-16   17-24