Page 199 of 369
Downloaded from www.Manualslib.com manuals search engine 46-3
   
 Repair Manual, Maintenance  5 - Brake pad  With brake pad wear 
indicator  Always replace on 
both sides  Removing and 
installing  Page 46-6  Pad thickness: non-
ventilated brake disc, 
14 mm  Pad thickness: 
ventilated brake disc, 
11 mm  Checking thickness  Wear limit: 7 mm 
(including backplate) 
6 - Hub  Removing and 
installing  from  
Page 40-14 7 - Wheel speed sensor 
rotor  Only on vehicles with 
ABS 
8 - Hex bolt, 10 Nm (7 ft lb) 9 - Splash plate Page 3 of 7Front brakes, servicing (Girling caliper)12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.46.1  
     
        
        Page 204 of 369
Downloaded from www.Manualslib.com manuals search engine 46-8
   
Front brakes, 
servicing 
(Teves/Ate) 
 Repair Manual, Maintenance  1 - Screw 
2 - Brake disc  When worn always 
replace on both sides  Remove brake caliper 
prior to removing  Ventilated brake disc 
diameter: 288 mm  Brake disc thickness: 
25 mm  Wear limit: 23 mm 3 - Brake pads  Always replace on 
both sides  Pads are different; pad on piston side has 
retaining spring  Removing and 
installing  Page 46-12  Pad thickness: 14 mm  Checking thickness  Wear limit: 7 mm 
(including backing 
plate) Page 1 of 7Front brakes, servicing (Teves/Ate)12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.46.2  
     
        
        Page 216 of 369
Downloaded from www.Manualslib.com manuals search engine 46-20
   
 Repair Manual, Maintenance  4 - Upper return spring  Unhook with pliers 5 - Lower return spring  Lubricate contact 
points with G 000 650 
paste 
6 - Wedge spring 
7 - Brake shoe  Removing and 
installing  Page 46-23  Minimum lining 
thickness 2.5 mm  Checking thickness 8 - Cap  Remove to check 
brake lining thickness 
9 - Pin 
10 - Wheel speed sensor  Only on vehicles with 
ABS Page 2 of 8Rear wheel brakes, servicing12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.46.4  
     
        
        Page 225 of 369
Downloaded from www.Manualslib.com manuals search engine 46-29
   
 Repair Manual, Maintenance  11 - Brake carrier with 
guide pins and 
protective cap  Supplied as 
replacement part 
assembled with 
sufficient grease on 
guide pins  If protective caps or 
guide pins are 
damaged use repair 
kit. Use grease packet 
supplied to lubricate 
guide pins. 
12 - Brake pads  Thickness: 12 mm  Checking thickness:  Wear limit: 7mm 
(including backing 
plate)  Always replace on 
both sides  Removing and 
installing  Page 46-33 13 - Brake caliper  Servicing  Page 47-15 Page 3 of 10Rear wheel brakes, servicing (disc brakes)12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.46.5  
     
        
        Page 268 of 369
Downloaded from www.Manualslib.com manuals search engine 47-27
 
    
Brake system, bleeding 
    
Brake system, bleeding (vehicles with 
and without ABS, ABS/EDL)  
    
Changing brake fluid  
     Repair Manual, Maintenance     
Note:  
     Bleeding the brake system on vehicles with 
ABS, ABS/EDL is performed as for vehicles 
with conventional braking systems. 
     Only use new brake fluid conforming to US 
standard FMVSS 116 DOT 4. 
     Genuine VW/Audi brake fluid conforms to this 
specification. 
     Brake fluid is poisonous. Also due to its 
corrosive effect brake fluid must not come into 
contact with paintwork. 
     Brake fluid is hygroscopic, which means it 
absorbs moisture from the ambient air and 
should always be stored in air tight containers. 
     Rinse off spillages using plenty of water.      Repair Manual, Brake System On Board Diagnostic (OBD), Repair Group 01 Page 1 of 3Brake system, bleeding12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.47.6  
     
        
        Page 270 of 369
Downloaded from www.Manualslib.com manuals search engine 47-29
     
Brake system, bleeding (without 
pressure bleeder)  
    Opening the hydraulic unit bleed screws on 
vehicles with ABS, ABS/EDL is not permitted!  
    
- Build-up brake pressure in brake system by 
pumping the brake pedal. 
    
- Attach bleeder bottle hose and open bleeder 
screw. 
    
- With brake pedal held down, close bleeder 
screw. 
    
- Repeat operation until no air is present.     Bleeding sequence  Page 47-28       Changing brake fluid  
     Repair Manual, Maintenance Page 3 of 3Brake system, bleeding12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.47.6  
     
        
        Page 292 of 369
Downloaded from www.Manualslib.com manuals search engine 48-22
   
 Repair Manual, Maintenance  9 - Steering gear  Removing and 
installing  Page 48-15  Adjusting  Page 48-24 10 - Tie rod end  Separating  Page 48-16  Checking: 11 - Hex nut 30 Nm (22 ft lb) 12 - Universal joint Page 22 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1  
     
        
        Page 328 of 369
Downloaded from www.Manualslib.com manuals search engine 48-58
   
 Repair Manual, Maintenance  7 - Lock nut, 50 Nm (37 ft 
lb) 
8 - Tie rod ball joint  Splitting  Page 48-16  Checking: 9 - Pressure balance pipe 
10 - 30 Nm (22 ft lb) 
11 - Clamp 
12 - Rubber mounting  Internal diameter ZF: 
50 mm TRW: 44 mm 
13 - Data plate and 
company initials Page 58 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1