Downloaded from www.Manualslib.com manuals search engine 48-70
Sealing ring on toothed rod, replacing When the sealing rod is replaced it must be replaced
with a new one of the same color
Note the matching of the O-ring to the sealing ring - Press pliers together with slight pressure on the
sealing ring
- Pry out sealing ring and O-ring A - Needle nose pliers (standard commercial) O-ring 30.0 x 1.78/ white sealing ring O-ring 31.0 x 1.5/black sealing ring - Slide mounting sleeve 3315/19 onto toothed rod - Pull O-ring over the tool and insert in the groove of
the piston Page 70 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
Downloaded from www.Manualslib.com manuals search engine 48-71
Power steering gear, assembling
Note: The sealing lip (arrow) of the sealing ring points
upward toward the teeth 1 on the valve body
For better viewing, the illustration shows the body
housing in cross section with installed valve body.
The valve body is shown slightly raised for better
viewing
Inner sealing rod for toothed rod, installing Lubricate the sealing rings with hydraulic oil
before installing
- Note correct installation position of the sealing ring - Place sealing ring for valve body on the tool and
drive in to stop. For installation position, see next
illustration
- Drive center roller bearing for valve body into stop The sealing lip (arrow) of sealing ring -3- points
toward cylinder -4-.
For better illustration, the drawing shows the housing
in cross section. 1 - Valve body 2 - Support ring 3 - Sealing ring 4 - Cylinder Page 71 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
