1997 VOLKSWAGEN PASSAT brakes

[x] Cancel search: brakes

Page 155 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-59
   
Wheel bearings, 
servicing - disc 
brakes (four wheel 
drive vehicles) 
Note:  
If a vehicle has to be moved 
after removing the driv

Page 156 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-60
   
 Repair Manual, Suspension, Wheels, Brakes, Steering, Repair Group 46 
 Repair Manual, Suspension, Wheels,Brakes, Steering, Repair Gr

Page 157 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-61
   
 Repair Manual, Suspension, Wheels, Brakes, Steering, Repair Group 46  12 - Self-locking hex nut  Always  Tighten to 90 Nm (66 ft lb)

Page 158 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-62
   
16 - Circlip  Ensure seated 
correctly 
17 - Wheel bearing  72 mm diameter  Pressing out  Page 42-64  Pressing in  page.  Page 42-65

Page 159 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-63
   
24 - Drive shaft with speed 
sensor rotor  Removing and 
installing drive shaft  
Page 42-37 and  
Page 42-38  Removing and 
installi

Page 160 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-64
     Fig. 1 Hub, pressing out     Fig. 2 Wheel bearing, pressing out Page 6 of 8Wheel bearings, servicing - disc brakes (four wheel drive

Page 161 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-65
     Note:  
Only use puller with leg clamp e.g. Kukko 204-2 
(commercial type).  Fig. 3 Inner race, pulling off of hub     Note:  
First

Page 162 of 369

VOLKSWAGEN PASSAT 1997 B3, B4 / 3.G Service Workshop Manual Downloaded from www.Manualslib.com manuals search engine 42-66
     Note:  
First install backing plate on control arm. 
Tightening torque: 10 Nm (7 ft lb)  Fig. 5 Hub, pressing in     Fig. 6 Speed se
Page:   < prev 1-8 9-16 17-24 25-32 33-40 41-48 49-56 ... 72 next >