Downloaded from www.Manualslib.com manuals search engine 48-53
Needle run-out max. 0.10 mm
If needle run-out is greater than 0.10 mm, screw
pressure piece slightly into housing
If the needle run-out is less than 0.10 mm, screw
pressure piece slightly out of housing
- Tighten lock nut
- Check needle run-out again, if necessary repeat
adjustment
- Remove gauge Close hole in adjusting screw with a stopper from
repair kit
Tie rods, installing - First install clip -2- with gasket -1- in the hole - Apply 1 drop sealing compound, Part No. AMV
188 001 02, in the hole of the clip -arrow- and
press plug -3- into the clip
- See tie rods, removing and installing (TRW and ZF steering gear), Page 48-77 Page 53 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
Downloaded from www.Manualslib.com manuals search engine 48-91
Maintenance Manual 5 - 20 Nm(15 ft Ib)
6 - Front swivel bracket
7 - 20 Nm (15 ft lb)
8 - Adjustment bracket
9 - 20 Nm (15 ft lb)
10 - Bracket
11 - V-belts 11.5 x 685 Gas engine 11.5 x 730 Diesel
engine 11.5 x 755 Gas engine with air conditioner 11.5 x 790 Diesel
engine with air
conditioner Tensioning Page 48-93 Checking condition 12 - 25 Nm (18 ft lb) Page 91 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
Downloaded from www.Manualslib.com manuals search engine 48-93
V-belts, tensioning (4-Cyl. engines) Specification: - Tension V-belts by turning adjustment bolt with
torque wrench -A- (VAG 1410 and VAG 1410/2). Used belts, 4 Nm (35 in. Ib) New belts, 7 Nm (62 in. Ib) Note:
Nut 4 - is only installed on gasoline engines. - Tighten adjustment clamping bolt -3- to 25 Nm (18
ft lb).
- Tighten bolt -1- to 45 Nm (33 ft lb). - Tighten bolt -2- and nut -4- to 25 Nm (18 ft lb). Page 93 of 99Steering12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.48.1
