Page 46 of 184
43
3. To remove the infant seat, press thebuckle-release button.(B) CONVERTIBLE SEAT INSTALLA-TION
A convertible seat is used in forward
facing and rear-facing position de-
pending on the child's age and size.
When installing, follow the manuf-ac-
turer 's instructions about the applica-
ble child's age and size as well as di-
rection of a child restraint system.
CAUTION!
Do not use a rear-facing child re-
straint system in the rear seat if it in-
terferes with the lock mechanism of
the front seats. This can cause se-
vere injury to the child and front
passenger in case of sudden brak-
ing or a collision.
Page 47 of 184
44
1. Run the center lap belt through oraround the convertible seat following the instructions provided by its man-
ufacturer and insert the tab into the
buckle taking care not to twist the lapbelt.
CAUTION!
After inserting the tab, make sure
the tab and buckle are locked and
that the lap belt is not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent
you from properly latching the tab
and buckle.
If the seat belt does not function
normally, it cannot protect your
child from injury. Contact your
Toyota dealer immediately. Do not
use the seat until the seat belt isfixed.
2. While pressing the convertible seat
firmly against the seat cushion and
seatback, tighten the lap belt by pulling
its free end to hold the convertible seat
securely.
Page 48 of 184
45
CAUTION!
Push and pull the child restraint
system in different directions to be sure it is secure. Follow all theinstallation instructions provided
by its manufacturer.
3. To remove the convertible seat, press the buckle-release button.(A) INFANT SEAT INSTALLATION
An infant seat is used in rear-facing
position only.
ÐInstallation with 3-point
type seat belt
Page 49 of 184