1997 TOYOTA RAV4 door lock

14
1. To open the fuel filler door, pull thelever up.
CAUTION!
Do not smoke, cause sparks or al-
low open flames when refuelling.
The fumes are flammable.
When opening the cap, do not re-
move the cap quickly. In hot weath-
er, fuel under pressure could cause
injury by spraying out of the filler
neck if the cap is suddenly re- moved.
2. To remove the fuel tank cap, turn
the cap slowly counterclockwise,
then pause slightly before remov-
ing it. After removing the cap, hang
it on the cap hanger.
It is not unusual to hear a slight swoosh
when the cap is opened. When installing,
turn the cap clockwise till you hear a click.
If the cap is not tightened securely, themalfunction indicator lamp comes on.
Make sure the cap is tightened securely.
The indicator lamp goes off after driving several times. If the indicator lamp does
not go off, contact your Toyota dealer as soon as possible.
CAUTION!
Make sure the cap is tightened se-
curely to prevent fuel spillage in
case of an accident.
Use only a genuine Toyota fuel tankcap for replacement. It has a built incheck valve to reduce fuel tank vac- uum.
Fuel tank cap

18
Install the removed sun roof panels on
the back door as follows.
If the rear seats are reclined, return
them to the upright position before
closing the back door. Otherwise,they will interfere with the installed sun roof panels, possibly damagingthem.
NOTICE
1. Remove the holder from the back door by turning the bolts counter- clockwise.
The upper holder is for the front sun roof
panel and the lower one is for the rear panel.2. Set the front edge of the sun roof panel into the holders.
The fore part of holders is for the front sun roof panel and the back part is for the rearpanel.
ÐStowing

19
3. Place the removed holder over thesun roof handle.4. Secure the holder by turning thebolts clockwise.
NOTICE
Do not drive the vehicle without checking that the roof panels are
securely attached to the back door.
1. Insert the flat hinges of the sun roof
panel into the hinge cases on the
body. Then slowly lower it while
holding the roof with your hands.
Make sure both flat hinges are inserted into the hinge cases.
ÐInstalling

23
For easy access to the rear seat, do this.
1. Lift the seatback angle adjusting leveror press the pedal behind the seat- back.
The seat will slide forward slightly.
2. Move the seat to the front-most posi- tion.
After passengers are in, lift up the seat- back and return the seat until it locks.
CAUTION!
After putting back the seat, try
pushing the seat forward and rear-
ward to make sure it is secured inplace.
Never allow anyone to rest their
foot on the release pedal while the
vehicle is moving.
Lean forward and pull the lock release
lever. Then lean back to the desired
angle and release the lever.
ÐMoving passenger's seat for rear seat entry (2-door models)
Rear seatsÐ ÐAdjusting seatback angle

24
CAUTION!
Adjustments should not be made while the vehicle is moving.
To reduce the risk of sliding under
the lap belt during a collision,
avoid reclining the seatback any
more than needed. The seat belts
provide maximum protection
when the passengers are sitting up straight and well back in the
seats. If you are reclined, the lap
belt may slide past your hips and
apply restraint forces directly to
the abdomen. Therefore, in the
event of a frontal collision, the risk
of personal injury may increase
with increasing recline of the seat-
back.
After adjusting the seatback, exert
body pressure to make sure it is
locked in position.
1. Remove the head restraint. Unlock
the seatback and fold it down.
Folding up the rear seats will enlarge the
luggage compartment. See Luggagestowage precautionsº in Part 2 for precau-
tions to observe in loading luggage.2. Unlock the seat cushion. Swing the
whole seat up and forward.
ÐFolding up rear seats (2-door models)

26
BEFORE FOLDING REAR SEAT
Stow the rear seat belts as shown in
the illustration.
This prevents the belts from falling out
when you fold the seatbacks.
NOTICE
The seat belts must be stowed before you fold the seatback.
FOLDING REAR SEAT
1. Remove the head restraint. Unlock the seatback and fold it down.
Folding up the rear seats will enlarge the
luggage compartment. See Luggage stowage precautionsº in Part 2 for precau-
tions to observe in loading luggage.2. Unlock the seat cushion. Swing the
whole seat up and forward.
ÐFolding up rear seats (4-door models)

28
Rear seats
Front seatsRear
seats: Remove the head restraint.
Then pull out the strap to unlock the
seatback, and push down the seat-back.
Front seats: Remove the head re-
straint and slide the seat to the front-
most position. Then unlock the seat- back and push it down.
CAUTION!
Do not allow passengers to ride on
the flattened seat while driving;
use the seat in the normal position.
After putting back the seat, try
pushing the seatback forward and
rearward to make sure it is secured
in place. Be certain to replace headrestraint.
Before closing the back door, make
sure the rear headrests are removed
from the flattened seats.
NOTICE
Rear seats
Front seats
Flattening seatbacks (2-door models)
Flattening seatbacks(4-door models)

34
Sit up straight and well back in the
seat. To fasten your belt, insert the tab
into the buckle.
You will hear a click when the tab locks into the buckle.
If the belt is not long enough for you, hold the tab at a right angle to the belt and pull
on the tab.
CAUTION!
After inserting the tab, make sure
the tab and buckle are locked and
that the belt is not twisted.
Do not insert coins, clips, etc. in the
buckle as this may prevent you
from properly latching the tab and buckle.
If the seat belt does not function
normally, immediately contact your
Toyota dealer. Do not use the seat
until the seat belt is fixed. It cannot
protect an adult occupant or your
child from injury.
Remove excess length of the belt and adjust the belt position.
To shorten the belt, pull the free end of the belt. Position the lap belt as low as possible on your hips-not on your waist, then adjust it
to a snug fit.
CAUTION!
High-positioned and loose-fitting
lap belts could cause severe injuries due to sliding under the lap belt dur-
ing a collision. Keep the lap belt
positioned as low on hips as pos-sible.
ÐRear center seat belt (4-door models)