Mot. 1264
Mot. 1264-01
Mot. 1265
Mot. 1265-01Wrench for removing sender unit nut
Pliers for removing quick-release unions
INSTRUMENT PANEL
Fuel level sensor
83
97163R6
Disconnect the battery.
Lift the rear bench seat (depending on
equipment).
Remove the pump and sender unit steel cover.
Disconnect the electrical connector (1).
Release the clips (2).
Then disconnect the fuel supply pipe (3) (green
marking on the quick-release union) and the fuel
return pipe (4) (red marking on the quick-release
union) using the special pliers Mot. 1265 or Mot.
1265-01.
IMPORTANT: When the pipes are removed, fuel
may be splashed out due to the residual pressure
in the pipes. Take appropriate precautions.
IMPORTANT :
During any operation on the fuel level sensor
you must observe the following precautions:
- Do not smoke.
- Keep all flames or incandescent objects away
from the working area.
REMOVAL OF THE PUMP - SENDER ASSEMBLY
The pump and sender unit assembly may be
removed through the inspection cover under the
rear bench seat and the fuel tank does not have to
be removed.
96420R2
SPECIAL TOOLING REQUIRED
TIGHTENING TORQUES (in daN.m)
Sender unit nut 7
83-10
