1997 RENAULT KANGOO lights

IMMOBILISER
Coded key immobiliser system
82
Removal - Refitting
The dashboard must be partially removed to re-
move the decoder unit.
Remove:
- the steering wheel with the wheels straight,
- the half cowlings under the steering wheel,
- the knee protector under the steering column,
- the lights and wiper controls,
- the instrument panel surround,
- the instrument panel,
- the ashtray, its mounting and the two dash-
board mounting bolts on the heating unit,
- the trim at the bottom of the dashboard on the
driver’s side,
- the two speaker grilles on the dashboard,
- the dashboard mountings.
13065R1
Move the dashboard as far back as possible, dis-
connect the decoder unit and remove the two
mounting bolts (B) using a small ratchet fitted
with a Torx 20 socket.
•A red immobiliser warning light on the instru-
ment panel used to :
- indicate activation of the engine immobiliser
system,
- signal a fault in the system for vehicles with a
coded solenoid valve (diesel) or non-
recognition of the key,
- signal entry into the door locking remote
control resynchronisation mode (depending
on equipment).
• An injection warning light (petrol vehicle)
which indicates a fault in the:
- injection,
- engine immobiliser system when the engine
is running (flashes during deceleration and
at idle speed).
82-4

INSTRUMENT PANEL
Instrument panel
83
Connector N (black)
Track Allocation
1 Not used
2 Brake pad wear warning light
3 ABS warning light
4Handbrake / brake info warning light
(NIVOCODE)
5 Immobiliser warning light
6 Not used
7 Not used
8 Speed signal
9 Oil level sensor
10 Oil level sensor earth
Connector G (grey)
Track Allocation
1 Earth
2 Not used
3 Not used
4 Low fuel level warning light
5 Coolant temperature warning light
6 Oil pressure warning light
7 Battery charge warning light
8 Rear fog light tell-tale
9 Front fog lights tell-tale
10 Right hand indicator tell-tale
83-9

CONTROLS - SIGNALS
Lights stalk
REMOVAL - REFITTING
Disconnect the battery.
Remove the two half cowlings under the steering
wheel.
Remove the two mounting bolts (B) for the lights
stalk.
Release the stalk from its mounting and dis-
connect the connector.
84
CONNECTION
12970R1
NOTE : the steering wheel does not have to be re-
moved.
13062R
Track Allocation
A1 Front fog lights
A2 Not used
A3 Rear fog light
A4 Horn
A5 Right hand indicators
A6 Central flasher unit
A7 Left hand indicators
B1 Side lights
B2 + before ignition, side lights
B3 + before ignition, dipped headlights
B4 Not used
B5 Dipped headlights
B6 + before ignition, main beam headlights
B7 Main beam headlights
84-2

ELECTRICAL ASSISTANCE EQUIPMENT
Relay plate
POSITION AND ALLOCATION
(Most complete plate)
87
12965R
The relays are located above the fuse board at the
bottom of the dashboard. To reach them, open
the fuse box cover.
1 Lights on reminder buzzer
2 Front wiper timer
3 Flasher unit
4 Rear wiper timer
5 Heated rear screen relay
6 After ignition relay (electric window feed)
7 Front fog lights relay
87-1

ELECTRICAL ASSISTANCE EQUIPMENT
Relay plate
87
LIGHTS ON REMINDER BUZZER
Track Allocation
C + after ignition feed
E Door switch
L + side lights
95182R4
CONNECTION
NOTE : The track numbers are as for the compo-
nent.
FRONT WIPER TIMER
95182R2
Track Allocation
1 + timer
2 Earth
4 Wiper control
5 Wiper park
6 + after ignition feed
8 + washer pump
CONNECTION
NOTE : The track numbers are as for the compo-
nent.
8
5
2 1 46E
CL
87-2

ELECTRICAL ASSISTANCE EQUIPMENT
Relay plate
87
FRONT FOG LIGHTS RELAY
Track Allocation
85 + relay control
86 Earth
30 + before ignition feed
87a Not used
87 Front fog lights
13058R
CONNECTION
NOTE : The track numbers are as for the compo-
nent.
87-5

WIRING
Remote control for door locking
88
Ignition off:
1.Press and hold the central door locking button
for a few seconds until the doors lock and un-
lock.
From this moment, the operator has 10 se-
conds to carry out the next operation.
NOTE: The 10 seconds are shown by the illu-
mination of the red immobiliser warning light
(if fitted) and bargraph 17 LH on the XR25
(code
D56, fiche n° 56).
2.Press the remote control twice (the doors lock
and unlock and the red warning light extin-
guishes, if fitted).
NOTE : If both remote controls (if fitted) are
desynchronised, two resynchronisation proce-
dures will have to be carried out (one for each
remote control).
IMPORTANT: To ensure that the infrared code
is correctly transmitted it is essential to direct
the transmitter correctly towards the receiver.
If the procedure fails it will be necessary to
restart from the beginning (infrared remote
control only).
3.The procedure is complete - check that the
doors lock correctly.
Removal - Refitting
The dashboard must be partially removed to re-
move the decoder unit.
Remove:
- the steering wheel with the wheels straight,
- the half cowlings under the steering wheel,
- the knee protector under the steering column,
- the lights and wiper controls,
- the instrument panel surround,
- the instrument panel,
- the ashtray, its mounting and the two dash-
board mounting bolts on the heating unit,
- the trim at the bottom of the dashboard on the
driver’s side,
- the two speaker grilles on the dashboard,
- the dashboard mountings.
THE DECODER UNIT
The decoder unit is located in the left hand side of
the dashboard (A).
12967R
88-5