REAR AXLE
Rear axle assembly
TIGHTENING TORQUES (in daN.m)
Bearing mounting nut 11
Wheel bolt 9
Shock absorber base bolt 8.5
REMOVAL
Put the vehicle on a two post lift.
Fit the pedal press.
Remove:
- the two lower shock absorber mountings,
- the brake pipes,
- the compensator control,
- the central heat shield,
- the handbrake cables, disconnecting them
from the central control,
Unclip the cables from the fuel tank.
Support the rear axle assembly and remove the
nuts ( 1 ).
Remove the rear axle assembly.
NOTE : the bolts can be reached under the rear
bench seat (depending on version) after
removing the blanking covers.
REFITTING
Refitting is the reverse of removal.
Bleed the brake circuit.
Adjust the handbrake (see section 37).
Check and if necessary adjust the braking
compensator ( see section 37 ).
33
13132R
33-1
