1997 PONTIAC FIREBIRD buttons

Fully Articulating Sport Seat (If Equipped)
If your Pontiac has these seats, the driver’s seat has the
four-way manual seat adjuster. See
“4-Way Manual
Seat” earlier in this
part. The passenger seat has the two
way manual seat adjuster. See “Manual Front Seat”
earlier in this part. The
two buttons without dot inflate
and deflate the
lumbar (lower back area
of the seatback) support. To
inflate, press the raised button. To deflate, press the
indented button.
Reclining Front Seatbacks
I
The switch pads on the outer side of the seats “inflate”
and “deflate”
parts of your seatback.
The two buttons that have
“dots” inflate and deflate the
side bolster
of the seatback. To inflate, press the raised
button.
To deflate, press the indented button.
To adjust the seatback, lift the lever on the outer side of
the seat. Release the lever to lock the seatback where
you want it. Pull up on the lever and the’seat will go to
its original upright position.
1-4

0
0
0
Check the location. Other vehicles or objects
may be blocking the signal. Take a few steps to
the right or left.
You may have to synchronize your transmitter
to the receiver in your vehicle. See instructions
for synchronization.
You may have to match the transmitters to your
vehicle. See instructions.
If none of the above apply, see your dealer or
qualified technician for service.
Synchronization
Synchronization may be necessary due to the security
metho’d used
by the Remote Keyless Entry system. The
transmitter does not send the same signal twice to the
receiver.
The receiver will not respond to a signal it has
been s’ent previously.
This prevents anyone from recoding
and playing
back the signal fiom the transmitter. To
resynchronize the transmitter with the receiver:
While standing close to your vehicle, simultaneously
press and hold the
LOCK and UNLOCK buttons on
the transmitter for eight seconds. The door locks
should cycle and parking lamps flash
to confirm
synchronization. If this does not happen, you may
need
to replace the battery in your transmitter.
Transmitter Verification (I€ Equipped)
This feature provides feedback to the holder of the remote
keyless entry transmitter that a command has been
received by the keyless entry receiver.
The parking larnps
will
flash on every lock and unlock command and the horn
will sound only if the
LOCK button is pushed twice within
five seconds.
This allows for silent operation of locking
and unloclung unless
a confirming horn chxp is desired.
Other options may be selected for
this feature (see
“Feature Custornization” in the Index).
Matching Transmitter(s) To Your Vehicle
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your vehicle.
If a transmitter is lost or stolen, a replacement can be
purchased through your dealer. Remember to bring any
remaining transmitters with you when you go to your
dealer. When the dealer matches the replacement
transmitter to your vehicle,
any remaining transmitters
must also be matched. Once your dealer
has coded the
new transmitter, the lost transmitter will not unlock your
vehicle. Each vehicle can have up
to four transmitters
matched to it.

Have each transmitter you intend to match ready for the
next steps. To match transmitters to your vehicle:
1. Turn the ignition switch to the RUN position then to
the
OFF position. This will disarm the Vehicle and
Content Theft-Deterrent System (if your vehicle has
this option).
2. Remove the RADIO fuse. This fuse is located in the
main fuse block, located on the left side of your
instrument panel. See “Fuses and Circuit Breakers”
in the Index.
3. Turn the ignition switch from the OFF to the RUN
position three times quickly (within five seconds).
The vehicle will respond by locking the doors,
unlocking the driver’s doors and releasing the hatch.
Your transmitter is now ready to match your vehicle.
4. Press and hold the LOCK and UNLOCK buttons on
the first transmitter for 15 seconds. The vehicle will
respond as in Step
3.
5. Repeat Step 4 for the remaining transmitters.
6. When you have finished matching all of your
7. Check that all transmitters work by pressing their buttons.
transmitters,
replace the
RADIO fuse.
If the transmitters don’t work, or if you’d rather not
match the transmitters yourself,
see your Pontiac dealer.
Battery Replacement
Under normal use, the battery in your key chain
transmitter should last about two years.
You can tell the battery is weak if the transmitter won’t
work at the normal range in any location.
If you have to
get close to your vehicle before the transmitter works,
it’s probably time to change the battery.
Use one battery, type
CR2032, or a similar type.
2-9

T-Top Sunshades
i
1,
2.
Start with the panel marked DRIVER FRONT.
Unlatch the driver’s side T-top, raise it halfway and
close the latch
handle.
With the top raised and resting on the center roof
rail, slide the flat edge of the sunshade panel (with
the vinyl side to the glass) between the glass and
plastic trim, making sure
the edge marked DRIVER
FRONT is pointing to the front of the vehicle.
3.
4,
Open the latch and close the T-top. Check to see if
there
are any gaps showing, Unlatch the T-top and
adjust the sunshade as required.
Once the sunshade is installed properly, you can
stick the Velcro@ buttons on the glass for a proper fit
every time you install the sunshades. To do this, first
remove the T-top with the sunshade installed and
place it upside down on a table
or bench, Take care
not
to scratch the glass.
2-66

5. Pull the sunshade back a little and remove the
backing paper from the Velcro
buttons. Push the
sunshade back into place, sticking the Velcro to
the glass.
6. Install the T-top, close the latch and lock the T-top.
Repeat the above steps for the passenger-side sunshade. You
can store the sunshades two different ways:
When the T-tops are in use, store the sunshades in their
storage area in the rear
of the vehicle, and make sure
the close-out panel is in its closed, upright position.
When you have the T-tops off and in their storage
slots, store the sunshades on
the T-tops, in their
installed positions.
2-67

AM-FM Stereo with Cassette Tape Player
(If Equipped)
Playing the Radio
VOL: Push this knob to turn the system on and off.
To increase volume, turn the knob clockwise. Turn it
counterclockwise to decrease volume.
RECALL: Display the time with the ignition off by
pressing this knob. When the radio is playing, press this
knob to recall the station frequency.
Finding a Station
AM-FM: Press this button to switch between AM, FM1
and FM2. The display shows your selection.
TUNE: Press this knob lightly so it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when
you’re not using it.
SEEK: Press the up or down arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite stations.
You can set up to
18 stations (six AM, six FM1 and six FM2). Just:
1. Turn the radio on.
2. Press AM-FM to select the band.
3. Tune in the desired station.
4. Press and hold one of the six numbered buttons until
SET appears on the display. Whenever you press that
numbered button, the station you set will return.
5. Repeat the steps for each pushbutton.
Setting the Tone
BASS: Slide the lever to the right or left to increase or
decrease bass.
TREBLE: Slide the lever to the right or left to increase
or decrease treble, If
a station is weak or noisy, you may
want to decrease the treble.
3-7

Playing the Radio
VOL: Push this knob to turn the system on and off. To
increase volume, turn the knob clockwise. Turn it
counterclockwise to decrease volume.
RECALL: Display the time with the ignition off by
pressing this knob. When the radio is playing, press this
knob to recall the station frequency.
Finding a Station
AM-FM:
Press this button to switch between AM, FM1
and FM2. The display shows your selection.
TUNE: Press this knob lightly so it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK: Press the up or down arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite stations.
You can set up to
18 stations (six AM, six FM1 and six FM2). Just:
1. Turn the radio on.
2. Press AM-FM to select the band.
3. Tune in the desired station.
4. Press and hold one of the six numbered buttons until
SET appears on the display. Whenever you press that
numbered button, the station you set will return.
5. Repeat the steps for each pushbutton.
Setting the Tone
EQUALIZER: A
seven band equalizer is part of your
audio system. Slide the levers up to boost or down
to
reduce frequency range.
Adjusting the Speakers
BAL: Press this knob lightly so it extends. Turn it to
move the sound to the left or right speakers. The middle
position balances
the sound between the speakers.
FADE: Press this knob lightly so it extends. Turn it to
move the sound to the front or rear speakers. The middle
position balances the sound between
the speakers.
Push these knobs back into their stored positions
when
you’re not using them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on e,ach side. Tapes longer than
that are so thin they may not work well in this play’er.
3-11

AM-FM Stereo with Compact Disc Player
and Equalizer (If Equipped)
Included with the AM-FM Stereo with Compact Disc Player
and Equalizer, are 10 high performance speakers and an
8 channel, 500 watt amplifier. See your dealer for details.
Playing the Radio
VOL: Push this knob to turn the system on and off.
To increase volume, turn the knob clockwise. Turn it
counterclockwise to decrease volume.
RECALL: Press this button briefly to recall the station
being played or to display the clock. If you press the
knob when the ignition is
off, the clock will show for a
few seconds.
Finding a Station
AM-FM: Press this button to switch between AM, FM1
and
FM2. The display shows your selection.
TUNE: Press this knob lightly so it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK: Press the up or down arrow to go to the next
higher
or lower station and stay there,
PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite stations. You can set up to
18 stations (six AM, six FM1 and six FM2). Just:
1. Turn the radio on.
2. Press AM-FM to select the band.
3. Tune in the desired station.
4. Press and hold one of the six numbered buttons until
SET appears on the display. Whenever you press that
numbered button, the station you set will return.
5. Repeat the steps for each pushbutton.
3-14