1997 PONTIAC FIREBIRD ECU

7. To tighten the belt, pull up on the shoulder belt while
8. Push and pull the child restraint in different
you push down on the child restraint.
directions
to be sure it is secure.
To remove the child restraint, just unbuckle the vehicle’s
safety belt and let
it go back all the way. The safety belt
will move freely again and be ready to work for an adult
or larger child passenger.
Larger Children
Children who have outgrown child restraints should
wear the vehicle’s safety belts.
Accident
statistics show that children are safer if they
are restrained in the rear seat. But they need to use the
safety belts properly.
Children who aren’t buckled up can be thrown out in
Children who aren’t buckled up can strike other
a crash.
people who
are.
1-38

0
0
0
Check the location. Other vehicles or objects
may be blocking the signal. Take a few steps to
the right or left.
You may have to synchronize your transmitter
to the receiver in your vehicle. See instructions
for synchronization.
You may have to match the transmitters to your
vehicle. See instructions.
If none of the above apply, see your dealer or
qualified technician for service.
Synchronization
Synchronization may be necessary due to the security
metho’d used
by the Remote Keyless Entry system. The
transmitter does not send the same signal twice to the
receiver.
The receiver will not respond to a signal it has
been s’ent previously.
This prevents anyone from recoding
and playing
back the signal fiom the transmitter. To
resynchronize the transmitter with the receiver:
While standing close to your vehicle, simultaneously
press and hold the
LOCK and UNLOCK buttons on
the transmitter for eight seconds. The door locks
should cycle and parking lamps flash
to confirm
synchronization. If this does not happen, you may
need
to replace the battery in your transmitter.
Transmitter Verification (I€ Equipped)
This feature provides feedback to the holder of the remote
keyless entry transmitter that a command has been
received by the keyless entry receiver.
The parking larnps
will
flash on every lock and unlock command and the horn
will sound only if the
LOCK button is pushed twice within
five seconds.
This allows for silent operation of locking
and unloclung unless
a confirming horn chxp is desired.
Other options may be selected for
this feature (see
“Feature Custornization” in the Index).
Matching Transmitter(s) To Your Vehicle
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your vehicle.
If a transmitter is lost or stolen, a replacement can be
purchased through your dealer. Remember to bring any
remaining transmitters with you when you go to your
dealer. When the dealer matches the replacement
transmitter to your vehicle,
any remaining transmitters
must also be matched. Once your dealer
has coded the
new transmitter, the lost transmitter will not unlock your
vehicle. Each vehicle can have up
to four transmitters
matched to it.

PASS-Key’ I1
Your vehicle is equipped
with the PASS-Key
11
(Personalized Automotive
Security System)
theft-deterrent system.
PASS-Key
I1 is a passive
theft-deterrent system.
It
works when you insert os
remove the key from
the ignition.
PASS-Key I1 uses a resistor pellet in the ignition key
that matches a decoder
in your vehicle.
When the PASS-Key I1 system senses that someone is
using the wrong key, it shuts down the vehicle’s starter
and fuel systems. For about three minutes, the starter
won’t work and fuel won’t go to the engine. If someone
tries to start your vehicle again
or uses another key
during this time, the vehicle will not start.
This
discourages someone from randomly trying different
keys with different resistor pellets
in an attempt to make
a match.
The ignition key must be clean and dry before it’s
inserted
in the ignitio’n or the engine may not start. If the
engine
does not start and the SECURITY light stays on
when you try to start the vehicle, the key may be dirty or
wet,
Turn the ignition off.
2-16

Clean and dry the key. Wait about three minutes and try
again. The SECURITY light may remain on during this
time. If the starter still won’t work, and the key appears
to be clean and dry, wait about three minutes and try
another ignition key. At this time, you may also want to
check the fuses (see “Fuses and Circuit Breakers” in the
Index). If the starter won’t work with the other key, your
vehicle needs service.
If your vehicle do’es start, the first
ignition key may be faulty. See your Pontiac dealer or a
locksmith who can service the PASS-Key
11.
If you accidentally use a key that has a damaged or
missing resistor pellet, the starter won’t work, and the
SECURITY light will flash. But you don’t have to wait
three minutes before trying another ignition key.
See your Pontiac dealer or
a locksmith who can service
the PASS-Key
I1 to have a new key made.
If you’re ever driving and the SECUFUTY light comes on and
stays on, you will be able to restart your engine if you
turn it
off. Your PASS-Key II system, however, is not working
properly and must be serviced by your Pontiac dealer. Your
vehicle is not protected by the PASS-Key
II system.
If
you lose or damage a PASS-Key I1 ignition key, see
your Pontiac dealer or a locksmith who can service
PASS-Key
I1 to have a new key made. In an emergency,
call the Pontiac Roadside Assistance Program at
1-800-ROADSIm or 1-800-762-3743.
Feature Customization (If Equipped)
Your Pontiac’s locks and lighting systems can be
programmed with several different features. The
features you can program depend upon the options that
came with your vehicle. The following list
tells you the
features that can be programmed. Listed next to each
feature is the option you need to have
on your vehicle in
order to be able to program that particular feature.
0
0
0
0
0
0
0
0
0
Exit Lighting (available for all)
Delayed Illumination (available for all)
Last Door Closed Locking (if equipped with power
door locks)
Lockout Prevention
(if equipped with power door locks)
Remote Lock Control Verification (if equipped with
Vehicle and Content Theft-Deterrent System)
Theft-Deterrent Arming Method
(if equipped with
Vehicle and Content Theft-Deterrent System)
Theft-Deterrent Arming Verification
(if equipped
with Vehicle and Content Theft-Deterrent System)
Driver’s Door Alarm Delay (if equipped with
Vehicle and Content Theft-Deterrent System)
Shock Sensor Enable (if equipped with Vehicle and
Content Theft-Deterrent System)

AUTOMATIC OVERDRIVE (0): This position is for
normal driving.
If you need more power for passing,
and you’re:
- Going less than about 35 mph (56 kdln), push your
accelerator pedal about halfway down.
accelerator all the way down.
You’ll shift down to
the next gear and have
more power.
- Going about 35 mph (56 kdh) or more, push the
THIRD (3): This position is also used for normal
driving, however, it
offers more power and lower fuel
economy than
AUTOMATIC OVERDRIVE (@).
Here are some times you might choose THIRD (3)
instead of AUTOMATIC OVERDRIVE (0);
- When driving on hilly, winding roads.
- When towing a trailer, so there is less shifting
between gears.
- When going down a steep hill.
SECOND (2): This position gives you more power but
lower
fuel economy. You can use SECOND (2) on hills.
It
can help control your speed as you go down steep
mountain roads, but then you would also want to use
your brakes
off and 0n.
Don’t drive in SECOND (2) for more
than
25 miles (40 km), or at speeds over 55 mph
(88 km/h), or you can damage your transmission.
Use AUTOMATIC OVERDRIVE (@) or
THIRD (3) as much as possible.
Don’t shift into SECUND (2) unless you are going
slower than 65 mph (105 km/h), or you can
damage your engine.
2-30

Front Map Lamps
Your inside rearview mirror includes two map lamps.
Each lamp has its own switch. Use the switch closest to
the lamp to turn it on. The lamps will also
go on when a
door
is opened.
Retained Accessory Power (RAP)
Your vehicle is equipped with a Retained Accessory
Power (RAP) feature which will allow certain features
of your vehicle to continue to work up to
10 minutes
after the ignition key is turned to
OFF.
Your convertible top, power windows, and audio system
will work when the ignition key is in the
RUN or ACC
positions. Once the key is turned from RUN to OFF,
these features will continue to work for up to 10 minutes
or until either door is opened.
Your power door unlock and remote hatch release
features will work when the ignition key is in the RUN
or
ACC positions or if either door is open. Once the key
is turned to OFF, these features will continue to work €or
up to 10 minutes. If either door is open and the ignition
key
is OFF, these features will continue to work until
both doors have been closed for about
30 seconds or
until the theft-deterrent system arms. At that time, both
the power door unlock and remote hatch release features
will be disabled to enhance the security
of the vehicle.
The power door lock function will work at all times
except during Lockout Prevention (if this feature is
enabled). See “Lockout Prevention’’ in
the Index.
2-55

When carrying large or heavy items, it is a good idea to
open the panel and place the items in the rear area.
I An improperly stored close-out panel could be
thrown about the vehicle during
a collision or
sudden maneuver. You
or others could be
injured. If you remove the cover, always store it
outside your vehicle. When you put it back,
always be sure that it is securely reattached.
Ashtray and Lighter
Lift up the cover to open the ashtray. To remove it, lift
up on either side
of the ashtray. If you have an automatic
transmission, the ashtray
is near the front of your
console.
If you have a manual transmission, the ashtray
is near your cupholder.
I NOTICE:
Don’t put papers and other things that burn into
your ashtray.
If you do, cigarettes or other
smoking materials could set them on
fire,
causing damage.
To use the lighter, push it in all the way and let go.
When it’s ready, it will pop back by itself.
2-59

If the T-top panel is not stored properly, it could
be thrown about the vehicle in a crash or sudden
maneuver. People in the vehicle could be injured.
Whenever
you store the roof panel in the vehicle,
always be sure that
it is stored securely in the
correct storage slot with the T-top handle closed.
Open the close-out panel completely. Place the panel in
the correct slot
(DRIVER) or (PASSENGER) in the rear
area of your vehicle. Make sure the handle is open and
facing you when you put it in the storage slot.
2-63