1997 Mercury Mountaineer low oil pressure

Instrument cluster warning and
indicator lights
DOOR
AJARilluminates when the ignition
key is turned to the ON or START
position and a door or liftgate is
opened.
CHECK
GAGEilluminates when the ignition is
turned to ON and the engine
temperature is high, the oil
pressure is low, or the fuel level is
near empty.
illuminates when there is a
problem with the generator or
charging system.
FUEL
RESETilluminates when the ignition
key is turned to ON and the fuel
pump shutoff switch has been
triggered. Refer toFuel pump
shutoff switchinRoadside
emergenciesfor more information.
illuminates when the air bag
system requires servicing.
0
20
1030405060
70
80
90
110
200000000
oooo
100

20406080100
120
140
160
180
0ABS
- +
P RND21
UNLEADED
FUEL ONLY
RPM x 1000
12345
6
- +
H
H
L L
4WD
LOW 4X4
H
C
F
E
!P
DOOR
AJAR
CHECK
GAGEFUEL
RESET
BRAKEMPH km/h
DOOR
AJAR
CHECK
GAGE
FUEL
RESET
Instrumentation
8

If you notice one or more of the
following, the emission system may
not be working properly. Have the
vehicle serviced as soon as
possible.
²Fluid leaks.
²The
andCHECK
ENGINElights
illuminate in the instrument
cluster and remain lit.
²Strange odors.
²Engine runs more than five
seconds after shut-off or engine
misfires, surges, stalls or
backfires.
²Loss of oil pressure.
When servicing your vehicle, never
use a metal exhaust collector. A
metal collector may heat or deform
plastic parts.
Important emission control
information
By law, anyone who manufactures,
repairs, services, sells, leases,
trades vehicles, or supervises a
fleet of vehicles is not permitted to
intentionally remove an emission
control device or prevent it from
working.
Do not make any unauthorized
changes to the vehicle or engine.
Changes that cause more
unburned fuel to reach the exhaust
system can increase the
temperature of the engine or
exhaust system.
Maintenance and care
170

Cleaning the engine
A clean engine is more efficient
than a dirty one because a buildup
of grease and dirt acts as an
insulator and keeps the engine
warmer than normal. Follow these
guidelines to clean your engine:
²Take care when using a power
washer to clean the engine. The
high pressure fluid could
penetrate the sealed parts and
cause damage.
²In order to avoid cracking the
engine block, do not spray with
cold water.
²The alternator, ignition coil
packs, and air intake must be
covered to prevent water
damage when cleaning the
engine.
²Never wash or rinse the engine
while it is running; water in the
running engine may cause
internal damage.
Cleaning the wiper blades
If the wiper blades do not wipe
properly, clean both the windshield
and the wiper blades using
undiluted windshield washer
solution or a mild detergent. Rinse
thoroughly with clean water. Do
not use fuel, kerosene, paint
thinner, or other solvents to clean
your wiper blades; these fluids will
damage your blades.
Maintenance and care
183