13
Mark floor pan through center of rivet and bolt
locations (12, 13) for anchor mounting plate (2)
Only for those positions at which anchor
rings will be installed.
14
Remove template (1)
15
At marks, drill Ø=9.5 mm hole (10) for anchor
bolt and Ø=4 mm holes (11) for rivets
Model 163.174: To avoid damaging
auxiliary fuel tank, do not drill more than 5mm
through floor pan for 2nd row center anchor
ring.
16
Smooth rough edges of holes on underside of
floor pan
17
Clean, prime, and paint holes
18
Using an assistant, place mounting plate (2)
into position from underneath vehicle and
secure with bolt (8)
Plate should be flush with surface of body.
19
Rivet plate into position from inside vehicle,
then remove bolt (8)
20
Seal underbody at plate location
Body seam sealant
*BR00.45-Z-1004-01A
Installing
21
Install load compartment floor covering
Do NOT install internal spare on Model
163.174 at this time.
f
AR68.20-P-4810GH
22
Loosely install trim plate (5) to observe fit to
floor covering
Straight edge of plate (5) towards front of
vehicle.
23
Remove trim plate (5) and relieve floor
covering so that plate, when installed, is
completely flush with floor covering
Use caution to avoid making hole too
large for trim plate to cover hole completely.
Square off hole at front. Relieve only down to
foam.
24
Install anchor ring (6) and related components
Use short spacer (4) on 3rd row rings.
Use long spacer (3) on 2nd row outboard
rings. Use short bolt (8) and no spacer on 2nd
row center ring.
Torx bit set
*000589011000
*BA68.50-P-1001-02A
25
Reinstall rear axle carrier
Model 163.174 only.
f
AR35.10-P-0020-01GH
26
Reinstall internal spare tire and carrier
Model 163.174 only.
f
AR68.30-P-4610GH
27
Reinstall compact spare tire
See Owner's Manual.
Luggage nets
Number
Designation
Model 163
BA68.50-P-1001-02A
Screw for cargo anchoring mount on load
compartment floor
Nm
24
163 589 06 63 00
Template
Internal Torx set
000 589 01 10 00
Repair products
Number
Designation
Order number
BR00.45-Z-1004-01A
MB body sealant for sealing seams (can be painted over/310 ml tube)
001 989 63 20
Parts ordering notes
Copyright DaimlerChrysler AG 14.06.2006 CD-Ausgabe G/10/04 . This WIS print-out will not be recorde
d by Modification services.
Page 2
