1997 LINCOLN TOWN CAR wipers

73
Ashtray and CupholderYour vehicle has an ashtray/cupholder mounted to
the lower center of the instrument panel.
To open the ashtray, pull out the bottom edge of
the drawer until it stops.
To close, remove cup(s) and push drawer forward
until closed.Power Point Electrical OutletThe power point outlet is located under the
instrument panel to the right of the ashtray. This
outlet should be used in place of the cigarette
lighter for optional electrical accessories.
NOTE:Do not plug optional electrical accessories
into the cigarette lighter. Electrical system damage
could occur.
To access the outlet, pull the cap off.
IgnitionUnderstanding the Positions of the
IgnitionThe positions of the key in the ignitionACC allows some of your vehicle's electrical
accessories such as the radio and the windshield
wipers to operate while the engine is not running.
File:05fncft.ex
Update:Mon Jun 17 13:49:49 1996

77
Windshield Wipers and WasherTo turn on the windshield wipers, the ignition key
must be turned to the ON or ACC position.
Rotate the knob towards ªSº to activate the wipers.
The first seven detents are interval wipe positions,
the eighth detent is the LO position and the ninth
detent is the HI position.
To turn the wipers off, turn the knob to the OFF
position.Variable Interval WipersIn addition to two speed wipers, your vehicle has
wipers that you can set to operate at varying
intervals. For example, you can set the interval so
they wipe less often when it drizzles or more often
in heavier rain.
To set the interval wipers, turn the knob at the end
of the turn signal lever between ªSº (slow) and ªFº
(fast) until the desired interval between wipes is
achieved.
File:05fncft.ex
Update:Mon Jun 17 13:49:49 1996

233
vehicle. Let the engine idle for at least one minute.
(Engine must be warm in order to ªlearn.º) Also,
allow approximately 10 miles (16 km) of stop and
go traffic for your vehicle's engine to completely
ªrelearnº its idle.
If you do not let the engine relearn its idle, the idle
quality of your vehicle may be adversely affected
until the idle is relearned. Your vehicle will
eventually relearn its idle while you drive it, but it
takes much longer than if you use the previous
procedure.Wiper BladesCheck the windshield wiper blades at least twice a
year. Also check them whenever they seem less
effective than usual. Substances such as tree sap
and some hot wax treatments used by commercial
car washes reduce the effectiveness of wiper blades.
If the blades do not wipe properly, clean both the
windshield and the wiper blades. Use undiluted
windshield washer solution or a mild detergent.Rinse thoroughly with clear water. Do not use fuel,
kerosene, paint thinner, or other solvents to clean
your wiper blades. These will damage your blades.
To make reaching the wiper blades easy, simply
turn the ignition to the ACC position and turn your
wipers on. Wait for them to reach a vertical
position and turn the ignition to the OFF position.
Do not move the wipers manually. Manually
moving the wipers across the windshield may
damage them.
Wiper blade replacementIf the wiper blades still do not work properly after
you clean them, you may need to replace the wiper
blade assembly or the blade element. When
replacing the wiper blade assembly, blade refill, or
wiper arm always use a Motorcraft part or
equivalent. To replace the blades, follow the
instructions that come with them.
File:11fnmct.ex
Update:Mon Jun 17 13:54:56 1996

304High beams (continued)
operation.............. 76
Hood................. 215
latch location............ 215
lubrication specifications....... 259
release lever............. 215
working under the hood....... 213
Horn................. 79
I
Idle, relearning..........208, 213
Ignition
chime............... 75
positions of the ignition........ 73
removing the key.......... 75
Infant seats (see Safety seats)....... 141
Instrument cluster, electronic....... 9
Instrument panel............. 7
Interval wipers............. 77
J
Jack.................. 193
operation.............. 196
positioning............. 196
storage............... 193
Jump-starting your vehicle
attaching cables........... 206
disconnecting cables......... 208
K
Keyless entry system
locking and unlocking doors...... 107
programming entry code....... 109
Keys
key in ignition chime......... 75
positions of the ignition........ 73
removing from the ignition...... 75
stuck in lock position......... 75
File:fnixt.ex
Update:Mon Jun 17 13:58:01 1996

311
Transmission
automatic operation......... 173
fluid, checking and adding (automatic) . 230
fluid, refill capacities......... 258
lubricant specifications........ 259
Transmission control switch....... 175
Trunk
trunk ajar warning light........ 32
using the keys to open........ 104
using the remote entry system to open . 111
Tune-up specifications (VECI)...... 246
Turn signal.............. 75
indicator lights............ 17
lever................ 75
U
Used engine oil, disposal........ 212
V
Variable interval wipers......... 77
VECI (Vehicle Emission Control Information)
decal................ 246
Vehicle loading
automatic transmissions........ 178
calculating the load.......... 178
understanding loading information . . . 177
Vehicle storage............. 260
Ventilating your vehicle
(see Climate control)......... 55
Viscosity (see Engine oil)........ 218
Visor (see Sun visor).......... 90
File:fnixt.ex
Update:Mon Jun 17 13:58:01 1996

313
Windshield washer fluid and wipers
checking and adding fluid....... 222
checking and replacing wiper blades . . 233
low washer fluid light........ 31
operation.............. 77reservoir.............. 222
variable interval wipers........ 77
Windshield wipers and washer...... 77
Wrecker towing............ 209
File:fnixt.ex
Update:Mon Jun 17 13:58:01 1996