STARTING AND DRIVING
132
HOW TO START THE ENGINE
Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in ªPº. If you need to restart the
engine while the vehicle is moving, put the selector lever in
ªNº. A starter safety device will prevent the starter from
operating if the selector lever is in any drive position.
4. Depress the brake pedal and hold it to the floor until you
are ready to drive off.
Starting the engine
Before starting the engine, be sure to follow the instructions
in ªBefore crankingº.
Normal starting procedure
The multiport fuel injection system/sequential multiport fuel
injection system in your engine automatically controls the
proper air±fuel mixture for starting. You can start a cold or hot
engine as follows:
1. With your foot off the accelerator pedal, crank the engine
by turning the key to ªSTARTº. Release it when the engine
starts.
2. After the engine runs for about 10 seconds, you are ready
to drive.If the weather is below freezing, let the engine warm up for
a few minutes before driving. Do not leave the vehicle while
the engine is warming up.
If the engine stalls...
Simply restart it, using the correct procedure given in normal
starting.
If the engine will not start
See ªIf your vehicle will not startº on page 162.
NOTICE
Do not crank for more than 30 seconds at a time.
This may overheat the starter and wiring system.
Do not race a cold engine.
If the engine becomes difficult to start or stalls
frequently, have the engine checked immediately.
STARTING AND DRIVING
144
TRACTION CONTROL SYSTEM
The traction control system automatically helps control
the spinning of the front wheels which may occur when
accelerating on slippery road surfaces, thus assisting
driver to control the driver to control the driving power
of the front wheels.
When you turn the ignition switch on, this system
always turns on. Leave the system on during ordinary
driving so that it can operate when needed. When
traction control is applied, the slip indicator light
blinks.
You can turn off the traction control system by pushing
the ªTRAC OFFº switch. The ªTRAC OFFº
indicator/warning light will then come on. Pushing the
ªTRAC OFFº switch a second time turns the system
back on and extingusihes the ªTRAC OFFº
indicator/warning light.
You may hear a slight clicking noise in the engine
compartment when the engine is started. This means that
the traction control system is in the self±check mode, and
does not indicate malfunction. When the traction control
system is operating, you may feel vibation or noise of your
vehicle, caused byoperation of the brakes. This indicates the
system is functioning properly.
When getting the vehicle out of the mud or new snow, etc.
the traction control system will help operate to prevent the
wheels from spinning.
