1997 FORD WINDSTAR oil dipstick

Maintenance and Care
287
%*
[MC04900(ALL)03/96
]
Engine oils with anSAE 5W-30viscosity arePREFERREDfor
your vehicle. They provide the best engine performance, fuel
economy and engine protection for all climates down to-15ÊF
(-25ÊC).
%*
[MC05000(ALL)03/96
]
Synthetic engine oils which are CERTIFIED and of the preferred
viscosity may be used in your engine. The engine oil and oil
filter must still be changed according to the maintenance
schedule.
%*
[MC05100(ALL)01/96
]
Checking and Adding Engine Oil
*
[MC05200(ALL)01/96]
Since the proper amount of engine oil is important for safe
engine operation, check the oil using the dipstick each time you
put fuel in your vehicle. Remember the engine must be off, the
oil must be warm and the vehicle must be parked on level
ground.
%*
[MC05300(ALL)01/96
]
Checking the engine oil level:
*
[MC05400(ALL)01/96]1.
Turn the engine off after it has warmed up and allow a few
minutes for the engine oil to drain back into the oil pan.
*
[MC05500(ALL)01/96]2.
Set the parking brake, making sure the gearshift is securely
latched in P (Park).
*
[MC05600(ALL)01/96]3.
Open the hood. Protect yourself from engine heat.
[MC05700(ALL)01/96]4.
Locate the dipstick labelled ªEngine Oilº and carefully pull it
out of the engine.
*
[MC05800(ALL)01/96]5.
Wipe the dipstick clean and put it back into position, making
sure it is fully seated.
File:11wnmcs.ex
Update:Mon Jul 8 14:29:32 1996

288
[MC05900(ALL)01/96]
7-1/2 pica art:0050073-D
Engine oil dipstick
*
[MC06000(ALL)01/96]6.
Carefully, pull the dipstick out again. If the oil level is below
the ªADD 1 QT.º line, add engine oil as necessary. If the oil
level is beyond the letter ªFº in FULL, engine damage or
high oil consumption may occur and some oil must be
removed from the engine.
*
[MC06100(ALL)01/96]7.
Put the dipstick back in and make sure it is fully seated.
*
[MC06200(ALL)01/96]
It may be necessary to add some oil between oil changes. Make
sure you use a CERTIFIED engine oil of the preferred viscosity.
Your vehicle's warranty coverage may not apply if engine
damage is caused by the use of improper engine oil.
*
[MC06300(ALL)01/96]
Add engine oil through the oil filler cap highlighted in yellow.
To add oil, remove the filler cap and use a funnel to pour oil
into the opening. Be careful not to overfill the engine. Recheck
the oil level after you finish adding oil.
%*
[MC06400(ALL)01/96
]
Changing the Engine Oil and the Oil Filter
*
[MC06500(ALL)05/96]
Refer to theMaintenance Schedulebooklet for additional
information.
%*
[MC06600(ALL)05/96
]
NOTE: Always dispose of used automotive fluids in a
responsible manner. Follow your community's
standards for disposing of these types of fluids. Call
your local recycling center to find out about recycling
automotive fluids.
File:11wnmcs.ex
Update:Mon Jul 8 14:29:32 1996

372
Coolant (see Engine coolant) (continued)
refill capacities................... 334
specifications..................293, 335
temperature gauge................ 21,29
warnings...................... 292
Cooling fan...................... 279
Cupholder(s)...................... 99
Customer Assistance Center, Ford (U.S.)......... 342
Customer Assistance Centre, Ford of Canada...... 349
D
Daytime running light system.............. 97
Defrost
rear window..................... 93
windshield...................... 85
Dipstick....................... 287
automatic transaxle fluid............... 298
engine oil..................... 287
Disabled vehicle (see Towing)............. 278
Dispute Settlement Board............... 344
Doors........................ 121
door ajar warning light................ 16
lubricant specifications................ 335
Driving under special conditions
bad weather.................... 243
heavy load..................... 245
high speed..................... 243
high water..................... 244
slippery roads................... 243
tips for safe driving................. 242
towing a trailer................... 246
File:wnixs.ex
Update:Thu Aug 1 08:57:39 1996

374
Engine coolant
checking and adding................ 292
checking hoses................... 296
disposal..................288, 295, 300
drain and flush................... 296
preparing for storage................ 338
proper solution...............288, 294, 300
recovery reservoir................283, 292
specifications.................... 335
temperature gauge................ 21,29
Engine coolant temperature gauge
description.................... 21,29
mechanical...................... 21
Engine fan...................... 279
Engine knocking................... 313
Engine oil
changing oil and oil filter.............. 288
checking and adding................ 287
dipstick...................... 287
disposal..................288, 295, 300
engine oil pressure warning light.......... 15,25
filter, specifications................. 333
refill capacities................... 334
specifications.................... 286
synthetic oil.................... 286
ªbreak-inº oils.................... 4
viscosity...................... 287
Entry system
illuminated..................... 143
keyless....................... 136
remote....................... 139
Exhaust fumes.................... 220
Extended Service Plan, Ford............... 4
File:wnixs.ex
Update:Thu Aug 1 08:57:39 1996