Page 188 of 321
190
*
[ER06900(M GV)12/95]
Since the circuit breaker for the headlamps is
mounted in the headlamp switch, you must
replace the entire switch to install a new circuit
breaker.
%
*
[ER07300( ALL)01/96]
If the Engine Cranks but Does
Not Start or Does Not Start After
a Collision
% [ER07400( ALL)12/95]
Fuel Pump Shut-off Switch
[ER07500( ALL)04/96]
If the engine cranks but does not start or does
not start after a collision, the fuel pump shut-off
switch may have been activated. The shut-off
switch is a device intended to stop the electric
fuel pump when your vehicle has been involved
in a substantial jolt.
[ER07700(M )04/96]
Once the shut-off switch is activated, you must
reset the switch by hand before you can start
your vehicle. The switch is on the left side of the
trunk near the left tail lamp.
[ER07800(M )12/95]
one third page art:0010012-D
The fuel pump shut-off switch
File:10rcerm.ex
Update:Tue Mar 4 10:01:28 1997
Page 254 of 321
256
%*
[MC41200( ALL)03/96]
Lights and Bulb Replacement
*
[MC41300( ALL)01/96]
It is a good idea to check the operation of the
following lights frequently:
*
[MC41400( ALL)01/96]
q
headlamps
*
[MC41500( ALL)01/96]
q
tail lamps
*
[MC41600( ALL)01/96]
q
brakelamps
*
[MC41700( ALL)01/96]
q
hazard flasher
*
[MC41800( ALL)01/96]
q
high-mount brakelamp
*
[MC41900( ALL)01/96]
q
turn signals
*
[MC42100( ALL)05/96]
q
license plate lamps
[MC42200(M )04/96]
q
fog lamps (if equipped)
%*
[MC42300( ALL)01/96]
The alignment of your headlamps should be
checked if:
*
[MC42400( ALL)01/96]
q
oncoming motorists frequently signal you to
turn off your vehicle's high beams when you
do not have the high beams on
*
[MC42500( ALL)01/96]
q
the headlamps do not seem to give you
enough light to see clearly at night
*
[MC42600( ALL)01/96]
q
the headlamp beams are pointed substantially
away from a position slightly down and to
the right
File:11rcmcm.ex
Update:Thu Apr 3 07:49:33 1997
Page 255 of 321
257 %
*
[MC42700( ALL)01/96]
Headlamp Bulb
*
[MC42800( ALL)03/96]
The headlamps on your vehicle use replaceable
bulbs. When the lamp burns out, simply replace
the bulb, rather than the whole lamp.
*
[MC42900( ALL)01/96]
RWARNING
Handle a halogen headlamp bulb carefully
and keep out of children's reach. Grasp
the bulb only by its plastic base and do
not touch the glass. The oil from your
hand could cause the bulb to break the
next time the headlamps are operated.
*
[MC43000( ALL)01/96]
Do not remove the burned-out bulb unless you
can immediately replace it with a new one. If a
bulb is removed for an extended period of time,
contaminants may enter the headlamp housing
and affect its performance.
[MC43200(M )12/95]
quarter page art:0010536-A
Parts of a headlamp
File:11rcmcm.ex
Update:Thu Apr 3 07:49:33 1997
Page 256 of 321
258
*
[MC43400( ALL)03/96]
Removing the headlamp bulb
*
[MC43500( ALL)01/96]
1. Make sure that the headlamp switch is in
the OFF position.
[MC43600(M )12/95]
2. Open the hood and locate the headlamp.
[MC43700(M )12/95]
quarter page art:0011232-C
Headlamp access covers
[MC44400(M )12/95]
3. Remove the electrical connector from the
bulb by lifting the connector clip upward
while pulling the connector rearward.
[MC44600(M )12/95]
4. Remove the retaining ring by turning
counterclockwise 1/8 of a turn to free it
from the socket. Then slide the ring off the
plastic base.Keep the ring.You must use it
again to hold the new bulb in place.
[MC44700(M )12/95]
5. Carefully remove the bulb assembly from its
socket by gently pulling it rearward without
turning.
File:11rcmcm.ex
Update:Thu Apr 3 07:49:33 1997
Page 257 of 321
![FORD MUSTANG 1997 4.G Owners Manual 259
*
[MC44800( ALL)03/96]
Installing the headlamp bulb
*
[MC45000(MBC )01/96]
1. With the flat side of the bulbs plastic base
facing upward, insert the glass end of the
bulb into the socket. You may FORD MUSTANG 1997 4.G Owners Manual 259
*
[MC44800( ALL)03/96]
Installing the headlamp bulb
*
[MC45000(MBC )01/96]
1. With the flat side of the bulbs plastic base
facing upward, insert the glass end of the
bulb into the socket. You may](/manual-img/11/5204/w960_5204-256.png)
259
*
[MC44800( ALL)03/96]
Installing the headlamp bulb
*
[MC45000(MBC )01/96]
1. With the flat side of the bulb's plastic base
facing upward, insert the glass end of the
bulb into the socket. You may need to turn
the bulb left or right to line up the grooves
in the plastic base with the tabs in the
socket. When the grooves are aligned, push
the bulb into the socket until the plastic base
contacts the rear of the socket.
*
[MC45200(MBC )01/96]
2. Slip the bulb retaining ring over the plastic
base until it contacts the rear of the socket.
Lock the ring into the socket by rotating it
clockwise until you feel a ªstop.º
*
[MC45300( ALL)01/96]
3. Push the electrical connector into the rear of
the plastic base until it snaps, locking it into
position.
*
[MC45400(MBC )01/96]
4. Turn the headlamps on and make sure that
they work properly. If the headlamp was
correctly aligned before you changed the
bulb, you should not need to align it again.
File:11rcmcm.ex
Update:Thu Apr 3 07:49:33 1997
Page 299 of 321

310 Index
Anti-theft system
arming the system........... 93
disarming an untriggered system..... 94
disarming a triggered system....... 95
triggering............. 92,94
Appeals (see Dispute settlement board) . . 278
Assistance (see Customer assistance).... 275
Audio system (see Electronic
sound system)............. 25
Autolamp system (see Headlamps)..... 59
Automatic transaxle
fluid, refill capacities......... 266
fluid, specification........... 267
Automatic transmission
driving an automatic overdrive . . . 162, 165
fluid, adding............. 236
fluid, checking............ 235
fluid, refill capacities......... 266
fluid, specification........... 267
Axle
lubricant specifications......... 267
refill capacities............ 266
traction lok.............. 161
B
Backing up.............164, 168
Basic vehicle warranty........... 4
Battery................. 237
acid, treating emergencies.....201, 238
battery saver............. 100
charging system warning light...... 15
disconnecting...........206, 238
how to service............ 237
jumping a disabled battery....... 200
maintenance-free........... 237
proper disposal, recycling....... 238
replacement, specifications....... 265
servicing............... 237
voltage gauge............ 15,21
when storing your vehicle....... 270
File:rcixm.ex
Update:Thu Apr 3 07:52:02 1997
Page 300 of 321

Index 311
Brake fluid............... 220
brake warning light........... 11
checking and adding......... 220
description.............. 220
specifications...........220, 267
Brakelamp, bulb replacement....... 260
Brakes................. 157
adjustment.............. 157
anti-lock............... 157
anti-lock brake system (ABS)
warning light............ 12
applying the brakes.......... 157
brake warning light........... 11
fluid, checking and adding...... 220
fluid, refill capacities.......220, 266
fluid, specifications........220, 267
front disc.............. 157
if brakes do not grip well....... 157
master cylinder............ 220
new brake linings............ 6
noise..............157, 159
parking............... 159
power braking............ 157
servicing............... 220
stopping distances.......... 177
trailer................ 175
when storing your vehicle....... 271
Brake-shift interlock........... 162
Break-in period.............. 6
Brights (high beams)........... 16
Bulbs, replacing............. 256
halogen............... 257
headlamps.............. 257
specifications............. 260
File:rcixm.ex
Update:Thu Apr 3 07:52:02 1997
Page 302 of 321

Index 313
Circuit breakers
checking and replacing........ 189
see also fuses............. 181
Cleaning your vehicle.......... 261
CD player and discs.......... 38
chrome and aluminum parts...... 262
engine compartment......... 264
exterior............... 261
exterior lamps............ 262
fabric................ 263
headlamps.............. 262
instrument panel.......... 55,262
instrument panel lens......... 263
interior............... 263
interior lamps............ 262
mirrors................ 82
plastic parts............. 262
polishing............... 261
rustproofing............. 262
safety belts.............. 262
tail lamps.............. 262
upholstery and interior trim...... 263
washing............... 261
waxing............... 261
wheels................ 264
Climate control system.......... 55
air conditioning............ 55
heating................ 55
heating only system........... 57
Clock.................. 62
Clutch................. 167
adjusting............... 222
fluid...............222, 237
fluid reservoir..........220, 222
operation while driving........ 167
recommended shift speeds....... 169
shifting the gears........... 168
specifications............. 267
File:rcixm.ex
Update:Thu Apr 3 07:52:02 1997