1997 FORD F SERIES MOTORHOME AND COMMERCIAL CHASSIS transmission

19 [IS11000( E M)01/96]
quarter page art:0020687-C
Engine coolant temperature gauge
%*
[IS11100( ALL)01/96]
Speedometer
*
[IS11200( ALL)01/96]
The speedometer tells you how many miles
(kilometers) per hour your vehicle is moving.
[IS11400( M)01/96]
Your vehicle contains a speedometer which
receives its input from a speed sensor. The
speedometer is also used to provide a speed
signal for correct operation of the vehicle's
Electronic Engine Control (EEC) module,
electronic transmission, and speed control (if so
equipped).
[IS11800( E M)01/96]
one third page art:0020872-B
Speedometer
File:03ltism.ex
Update:Fri Dec 13 11:17:22 1996

23
*
[CF24100( ALL)01/96]
Ignition
%*
[CF24110( ALL)01/96]
Understanding the Positions of the Ignition
*
[CF24120( ALL)01/96]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
*
[CF24130( ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[CF24140( ALL)01/96]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
*
[CF24150( ALL)01/96]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
[CF24170( E M)01/96]
LOCK locks the steering wheel. It also locks the
gearshift.
*
[CF24190( M)01/96]
RWARNING
Always set the parking brake fully and
make sure the gearshift is latched in P
(Park). Turn off the ignition whenever you
leave your vehicle.
File:05ltcfm.ex
Update:Thu Dec 12 13:31:05 1996

32
*
[CF33300( ALL)01/96]
NOTE: If your speed increases above your set
speed while driving inj(Overdrive)
on a downhill grade, you may want to
depress the transmission control switch
located on the shift lever to turn off
overdrive to reduce vehicle speed.
Speed control cannot reduce the vehicle
speed if it goes above your set speed
on a downhill grade. For the best fuel
economy during normal driving
conditions, leave the shift select inj
(Overdrive), or resume as soon as
practical.
*
[CF33400( ALL)01/96]
RWARNING
Do not use the speed control in heavy
traffic or on roads that are winding,
slippery, or unpaved.
*
[CF33500( ALL)01/96]
In mountainous areas, at higher elevations, or
when pulling a trailer, the speed control may
not be able to maintain the preset speed with
the transmission inj(Overdrive).
*
[CF33800( ALL)01/96]
RWARNING
Do not shift the transmission into N
(Neutral) with the speed control on.
*
[CF33900( ALL)01/96]
To maintain a preset speed under the above
conditions, with electronically controlled
transmissions Ð press the Transmission Control
Switch. The indicator light will turn on and
illuminate the word ªOFF.º This will cancel
ªOverdriveº. You can press the Transmission
Control Switch on or off at any speed. For the
best fuel economy during normal driving
conditions, press the Transmission Control
Switch to turn off the light. This allows
overdrive operation. After the vehicle has been
stopped and the engine has been restarted, the
File:05ltcfm.ex
Update:Thu Dec 12 13:31:05 1996

33
transmission will automatically reset with
overdrive operation. To cancel overdrive you
must press the Transmission Control Switch
again.
*
[CF34000( ALL)01/96]
quarter page art:0020771-C
Transmission control switch and Indicator light
%*
[CF34100( ALL)01/96]
Accelerating With the Speed Control
Operating
*
[CF34200( ALL)01/96]
You can use the accelerator pedal to speed up
momentarily. When you take your foot off the
accelerator, the vehicle will return to the set
speed.
%*
[CF34300( ALL)01/96]
Resetting the Speed Control
*
[CF34400( ALL)01/96]
To reset the speed control to alower speed,
press and hold the COAST switch. Let your
vehicle slow down to the desired speed and
release the COAST switch.
*
[CF34500( ALL)01/96]
Your vehicle has a ªtap-downº feature that
allows you to decrease your current speed in
increments of 1 mph (1.6 km/h) by a
momentary tap of the COAST switch. Multiple
taps of the COAST switch will decrease your
vehicle speed 1 mph (1.6 km/h) for each tap.
For example, if you are currently set at 65 mph
(104 km/h) and tap the COAST switch 5 times
your vehicle speed will decrease and set at
60 mph (96 km/h).
File:05ltcfm.ex
Update:Thu Dec 12 13:31:05 1996

34
*
[CF34600( ALL)01/96]
To reset the speed control to ahigher speed,
you can follow any of these procedures:
*
[CF34700( ALL)01/96]
q
Accelerate to the desired speed using the
accelerator pedal, then press the SET ACCEL
switch and release it immediately.
*
[CF34800( ALL)01/96]
q
Press and hold the SET ACCEL switch until
the vehicle accelerates to the desired speed,
then release the switch.
*
[CF35000( ALL)01/96]
Turning the Speed Control Off
*
[CF35100( ALL)01/96]
You can cancel the speed control while you are
driving.
*
[CF35200( ALL)01/96]
q
Press the OFF switch. The speed control is
off. If you want to resume speed control,
press the ON switch and reset the speed
control by pressing the SET ACCEL button.
[CF35400( ALL)01/96]
q
Press the brake pedal slightly. The speed
control is suspended, but you can reset it by
pressing SET ACCEL or return to the
previous set speed with the RESUME switch.
*
[CF35500(BE M)01/96]
In addition, the speed control is turned off each
time you turn the vehicle ignition off.
*
[CF35600( ALL)01/96]
Driving uphill or on a steep grade
*
[CF35700( ALL)01/96]
When the speed control is on, your vehicle may
significantly drop speed when driving uphill,
especially with a heavy load. If the speed drops
more than 8 to 14 mph (15 - 25 km/h) the
automatic speed control will, by design, be
canceled. You may have to temporarily resume
manual speed control while driving up a steep
grade in order to maintain the speed you desire.
*
[CF35800( ALL)01/96]
Frequent shifting of an automatic transmission or
speed loss during speed control operation can be
eliminated by shifting out of overdrive into
drive (or by pressing the Transmission Control
Switch, if equipped). These conditions could
occur in hilly terrain or at higher elevations.
File:05ltcfm.ex
Update:Thu Dec 12 13:31:05 1996

48
*
[GF04000(B FM)01/96]
one third page art:0020893-A
Parking Brake
*
[GF04250( E M)01/96]
RWARNING
Always set the parking brake fully and
make sure the gearshift is latched in P
(Park). Turn off the ignition whenever you
leave your vehicle.
*
[GF04400(B FM)01/96]
To release the parking brake, press the service
brake pedal with your right foot and pull the
parking brake release lever.
*
[GF04500( ALL)01/96]
RWARNING
If the parking brake is fully released, but
the Brake System light remains on, have
the brakes checked immediately. They
may not be working properly.
[GF04600( M)01/96]
The parking brake is not designed to stop a
moving vehicle, but you can use the parking
brake to stop your vehicle in an emergency if
the normal brakes fail. However, since the
parking brake applies only the transmission
mounted parking brake assembly, the stopping
distance will increase greatly and the handling
of your vehicle will be adversely affected.
File:09ltgfm.ex
Update:Fri Dec 13 11:22:54 1996

49 [GF04650( M)01/96]
Checking Parking Brake and Transmission
Park Mechanism
[GF04700( M)01/96]
Periodically check the holding ability of the
parking brake by stopping on a steep hill and
restraining the vehicle by using only the parking
brake with the transmission in N (Neutral).
Check the holding ability of the P (Park)
mechanism (automatic transmissions) by
releasing all brakes after moving the
transmission selector lever to the P (Park)
position.
%
*
[GF05200( ALL)01/96]
Steering Your Vehicle
%*
[GF05300( ALL)01/96]
Your vehicle comes with power steering. Power
steering uses energy from the engine to help
steer your vehicle.
%*
[GF05350( ALL)01/96]
If the amount of effort needed to steer your
vehicle changes at a constant vehicle speed, have
the power steering system checked. If the power
steering system breaks down (or if the engine is
turned off), you can steer the vehicle manually
but it takes more effort.
*
[GF05400( ALL)01/96]
Never hold the steering wheel to the extreme
right or left for more than five seconds if the
engine is running. This can damage the power
steering pump.
*
[GF05450( ALL)01/96]
NOTE: After any severe impact such as
striking large potholes, sliding into
curbs on icy roads, or a collision
involving the front end, observe the
steering wheel alignment. If the spokes
of the steering wheel seem to be in a
different position while going straight
down the road, have the front
suspension and steering checked for
possible damage.
File:09ltgfm.ex
Update:Fri Dec 13 11:22:54 1996

50
% [GF07450( M)01/96]
Automatic Transmission
Operation (E4OD)
[GF07500( M)01/96]
The E4OD transmission is an electronically
controlled four speed automatic transmission
with overdrive. Transmission operation is
controlled by the Powertrain Control Module
(PCM).
*
[GF07525( ALL)01/96]
The PCM will automatically adjust transmission
operation to make up for varying conditions.
Several sensors located on the engine and
transmission such as Throttle Position, Engine
Speed, Vehicle Speed and Transmission
Temperature are used by the PCM to shift the
transmission into a higher or lower gear when
required for the best performance and fuel
economy. For example, you may notice that the
transmission will upshift to a higher gear more
quickly when the vehicle is first driven and has
not reached normal operating temperature.
*
[GF07550( ALL)01/96]
The PCM also controls the transmission's Torque
Converter Clutch to further raise vehicle
performance and fuel economy. The Torque
Converter Clutch will engage when the
transmission operating temperature and other
conditions determined by the PCM have been
met. Engagement of the clutch may be noted as
a decrease in engine speed after an upshift has
completed or when the driver has depressed the
throttle while driving at a steady road speed.
[GF07575( ALL)01/96]
To help in troubleshooting, the PCM continually
performs self-tests on the electronic control
system and if any faults are detected, will store
them in memory. The Transmission Control
Indicator Light (TCIL), which is located on the
gearshift lever, may flash steadily if a
malfunction has been detected. If the TCIL is
flashing, contact your Ford dealer as soon as
possible. If this condition persists, damage to the
transmission could occur.
File:09ltgfm.ex
Update:Fri Dec 13 11:22:54 1996