1997 FORD EXPLORER child seat

5. If connected, disconnect the
chest clip and buckles.
6. Place the child in the seat and
position the left shoulder belt over
the child's left shoulder first, then
place the right shoulder belt over
the child's right shoulder.
7. Insert the left and right safety
belt tongues into the left and right
slots of the crotch buckle. Verify
that the indicator window on each
tongue is green to ensure proper
safety belt connections.
Seating and safety restraints
105

If both tongues do not
latch in the buckle, do not
use the child seat. See your
dealer for repairs.
8. Fasten the right and left chest
clip halves together and adjust the
clip to comfortably hold the
shoulder belts in place over the
child's chest.
The chest clip is designed to easily
pull apart in a collision. the clip
helps to keep belts snug on a
sleeping or squirming child.
9. Pull on the safety belt tongues
to ensure that they are both
securely latched. If they are not
properly latched, repeat steps
seven and eight.
If necessary, the shoulder belt may
be put in automatic locking mode
(ALR) to limit the child's
movement in the seat. The ALR
mode should be used if the child is
sleeping or attempting to get out
of the seat.
If not placed in ALR mode, the
child seat shoulder belts are in
vehicle sensitive (emergency
locking) mode, which allow some
movement of the shoulder belts
(like adult shoulder belts).
In emergency locking mode, the
shoulder belts of the child seat will
lock in response to hard braking,
hard cornering or if your vehicle is
involved in a collision with an
impact of 8 km/h (5 mph) or more.
uno_alr_in_seat
Seating and safety restraints
106

Activating the automatic locking
mode (ALR) on the built-in child
safety seat
1. Fully extend the right shoulder
belt.
2. Allow the belts to tighten snugly
against the child's shoulders.
Deactivating the automatic
locking mode (ALR) on the
built-in child safety seat
1. Disconnect the chest clip and
remove the left and right safety
belt tongues from the crotch
buckle.
2. Allow the shoulder belts to fully
retract.
Removing your child from the
built-in child safety seat
1. Disconnect the chest clip by
squeezing the release tabs together
and pulling the two sides apart.
2. Press the release button on the
crotch buckle.
3. Slide the shoulder belts off the
child's shoulders and remove the
child from the seat.
²If ALR is activated, hold either
left or right shoulder belt out
fully while helping the child
slide arms out of the belts.
uno_canceling_alr_in_seat
uno_removing_child_from_seat
Seating and safety restraints
107

4. Fold the cushion protector flap
onto the child seat cushion. Slide
the belt tongues up and out of the
way of the cushion, then return
the child seat cushion to the
stowed (upright) position.
5. Slide the Velcrotstraps through
the D-rings on the child seat
cushion and attach.
6. Slide the head restraint down
until the top of the head restraint
is flush with the top of the adult
seat back.
7. Press firmly on the top center of
the built-in child safety seat head
restraint to ensure it is stowed
properly.
Inspecting the built-in child
safety seat after a collision
Ford recommends that all
safety belt assemblies and
attaching hardware should be
inspected by a qualified
technician after any collision.
Safety belt assemblies not in use
during a collision should also be
inspected and replaced if either
damage or improper operation is
noted.
uno_inspecting_seat
Seating and safety restraints
108

All built-in child restraints,
including seats, buckles,
retractors, seat latches,
interlocks, and attaching
hardware should be inspected by
a qualified dealer technician after
any collision.
Seating and safety restraints
109

vinyl cleaner or a mild soap.
Cleaning and maintaining the
safety belts
Clean the safety belts with a mild
soap solution recommended for
cleaning upholstery or carpets. Do
not bleach or dye the belts,
because these actions may weaken
the belt webbing.
All safety belt assemblies,
including retractors, buckles, front
seat belt buckle support assemblies
(slide bar) (if equipped), shoulder
belt height adjusters (if equipped),
child safety seat tether bracket
assemblies (if equipped) and
attaching hardware should be
inspected after any collision. Ford
recommends that all safety belt
assemblies used in vehicles
involved in a collision be replaced.
However, if the collision was minor
and a qualified technician finds
that the belts do not show damage
and continue to operate properly,
they do not need to be replaced.
Safety belt assemblies not in use
during a collision should also be
inspected and replaced if either
damage or improper operation is
noted.
Cleaning the built-in child seat
(if equipped)
Clean the built-in child seat with
mild soap and water. Do not use
household cleaning products
because they may weaken the
safety belt webbing or damage the
vinyl parts of the seat.
com_safety_belts_cleaning.01
com_child-seat_cleaning.01
Maintenance and care
220

The child seat liner is removable
and may be machine-washed and
air dried.
Maintenance and care
221

Air bag supplemental restraint
system
and child safety seats ..............90
description ................................89
disposal ......................................94
indicator light ...........................93
passenger air bag .....................91
Air cleaner filter .......................192
replacing ..................................193
Air conditioning
manual heating and air
conditioning
system ...................28,29,30,31,32
Air suspension ...........................119
All wheel drive (AWD) .............134
Anti-theft system ........................65
arming the system ....................66
disarming a triggered system ..68
disarming an untriggered
system .......................................68
warning light .............................67
Autolamp system (see
Headlamps) .................................49
Automatic dimming mirror ...47,48
Battery .......................................188
battery saver ...........................192
servicing ....................188,189,190
Brakes
adjustment ..............................117
anti-lock ...................................117
fluid, checking and adding ....177
parking ....................................118
Break-in period .............................2
Built-in child seat .......102,107,108
Bulbs,
replacing ........208,210,211,212,213
specifications ..........................213
Capacities for refilling fluids ....225
Cargo area shade ........................64
Childproof locks ..........................55
Cleaning your vehicle ...............215
built-in child seat ...................220engine compartment ..............216
fabric ........................................219
instrument panel ....................219
plastic parts ............................218
safety belts ..............................220
tail lamps .................................218
washing ....................................215
waxing .....................................215
wheels ......................................216
Climate control system ..............28
automatic temperature
control ...................32,33,34,35,36
defrosting .............................59,60
Clutch
fluid ..........................................177
Compass, electronic ....................50
calibration .................................51
set zone adjustment .................51
Console, description ..............58,61
Control trac 4WD system .........128
Controls ..................................58,59
Coolant (see Engine coolant)
proper solution .......................181
Daytime running light system ...26
Differential fluid ........................187
Driveline universal joint and
slip yoke .............................176,187
Driving under special
conditions ..................................130
high water ...............................131
slippery roads ..................132,133
towing a trailer .......................144
Emission control system ..........206
Engine .................................228,231
service points ............170,171,172
Engine block heater .................116
Engine coolant
checking and adding .......180,183
checking hoses .......................184
disposal ....................................182
refill capacities ........................182
Index
233