1997 FORD CROWN VICTORIA headlamp

118 %
*
[CF64400( GV)05/96]
Battery Saver
*
[CF64500( GV)12/95]
When the ignition is turned off, the vehicle will
turn off battery voltage to the vehicle lamps as
follows:
*
[CF64600( GV)12/95]
q
Courtesy lights (lights which come on when a
door is opened): after 10 minutes.
[CF64700( GV)12/95]
q
Map/Glove compartment/Trunk/Hood
lamps: after 30 minutes.
[CF64800( GV)12/95]
q
Headlamps/Park lamps (only if headlamp
switch is left in Headlamp position): after 10
minutes.
*
[CF64900( GV)05/96]
This will prevent draining of the battery if those
lights have been left on inadvertently or if a
door is not completely closed. Battery voltage to
these lamps will be restored when the keyless
entry keypad is used, the remote entry
transmitter is used, any door is opened, the
trunk is opened, or the ignition key is turned to
the ON position.
*
[CF65000( ALL)05/96]
Remote Entry System
(If equipped)
*
[CF65100( ALL)05/96]
If your vehicle has the remote entry system, you
can lock and unlock the vehicle doors and open
the trunk without using a key. The remote also
has a personal alarm feature. The controls for
the system are located on the hand held
transmitter(s) that came with your vehicle.
*
[CF65200( ALL)01/96]
The system will work with up to four
transmitters. Your vehicle came with two
transmitters. Additional transmitters can be
ordered from your dealer.
[CF65400( GV)12/95]
The remote entry features only operate with the
transmission in P (Park) or N (Neutral).
File:05rccfv.ex
Update:Thu Mar 27 07:20:00 1997

155
Starting
%*
[TO00200( ALL)01/96]
Fuel-Injected Engines
*
[TO00300( ALL)01/96]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
*
[TO00400( ALL)01/96]
Starting Your Vehicle
%*
[TO00500( ALL)01/96]
Preparing to Start Your Vehicle
*
[TO00600( ALL)02/96]
RWARNING
Do not start your vehicle in a closed
garage or in other enclosed areas. Exhaust
fumes can be toxic. Always open the
garage door before you start the engine.
*
[TO00700( ALL)01/96]
Before you start your vehicle, do the following:
*
[TO00800( ALL)01/96]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[TO00900( ALL)01/96]
2. Make sure the headlamps and other
accessories are turned off when starting.
*
[TO01200( BCGV)01/96]
3. Make sure that the gearshift is in P (Park)
and the parking brake is set before you turn
the key.
File:08rctov.ex
Update:Tue Jun 11 15:23:28 1996

188 %
*
[ER06400( ALL)05/96]
Circuit Breakers
*
[ER06500( ALL)05/96]
If you need to check a circuit breaker that is on
the fuse panel, seeChecking and replacing fusesin
this chapter to find out how to locate the fuse
panel.
[ER06600( ALL)12/95]
Circuit breakers will reset themselves and allow
the electrical parts to work again once the
overload on the circuit is removed. If the circuit
breakers continue to cut off electricity, have your
vehicle's electrical system checked.
*
[ER06700( ALL)01/96]
Diagnostic equipment is needed to check circuit
breakers. Refer to the manufacturer's
instructions.
*
[ER06800( ALL)05/96]
If you replace a circuit breaker, use one with the
same amperage rating. To remove a circuit
breaker mounted in the fuse panel, grip it with
your finger and thumb and pull it straight out
of its socket.
[ER06900(M GV)05/96]
Since the circuit breaker for the headlamps is
mounted in the headlamp switch, you must
replace the entire switch to install a new circuit
breaker.
File:10rcerv.ex
Update:Wed Jun 19 10:32:02 1996

248
%*
[MC41200( ALL)03/96]
Lights and Bulb Replacement
*
[MC41300( ALL)01/96]
It is a good idea to check the operation of the
following lights frequently:
*
[MC41400( ALL)01/96]
q
headlamps
*
[MC41500( ALL)01/96]
q
tail lamps
*
[MC41600( ALL)01/96]
q
brakelamps
*
[MC41700( ALL)01/96]
q
hazard flasher
*
[MC41800( ALL)01/96]
q
high-mount brakelamp
*
[MC41900( ALL)01/96]
q
turn signals
*
[MC42000( GV)01/96]
q
side markers
*
[MC42100( ALL)05/96]
q
license plate lamps
%*
[MC42300( ALL)01/96]
The alignment of your headlamps should be
checked if:
*
[MC42400( ALL)01/96]
q
oncoming motorists frequently signal you to
turn off your vehicle's high beams when you
do not have the high beams on
*
[MC42500( ALL)01/96]
q
the headlamps do not seem to give you
enough light to see clearly at night
*
[MC42600( ALL)01/96]
q
the headlamp beams are pointed substantially
away from a position slightly down and to
the right
File:11rcmcv.ex
Update:Thu Jun 20 11:05:52 1996

249 %
*
[MC42700( ALL)01/96]
Headlamp Bulb
*
[MC42800( ALL)03/96]
The headlamps on your vehicle use replaceable
bulbs. When the lamp burns out, simply replace
the bulb, rather than the whole lamp.
*
[MC42900( ALL)01/96]
RWARNING
Handle a halogen headlamp bulb carefully
and keep out of children's reach. Grasp
the bulb only by its plastic base and do
not touch the glass. The oil from your
hand could cause the bulb to break the
next time the headlamps are operated.
*
[MC43000( ALL)01/96]
Do not remove the burned-out bulb unless you
can immediately replace it with a new one. If a
bulb is removed for an extended period of time,
contaminants may enter the headlamp housing
and affect its performance.
[MC43300( GV)12/95]
one third page art:0010432-B
Headlamp bulb removal
File:11rcmcv.ex
Update:Thu Jun 20 11:05:52 1996

250
*
[MC43400( ALL)03/96]
Removing the headlamp bulb
*
[MC43500( ALL)01/96]
1. Make sure that the headlamp switch is in
the OFF position.
*
[MC43900( GV)12/95]
2. Lift the hood, open access panel above
headlamp and find the bulb in the headlamp
socket.
*
[MC44200( GV)12/95]
3. Remove the electrical connector by pulling
off the bulb base.
*
[MC44500( GV)12/95]
4. Remove the bulb by turning it 1/4 of a turn
to free it from the socket.
*
[MC44800( ALL)03/96]
Installing the headlamp bulb
*
[MC44900( GV)12/95]
1. Insert the glass envelope of the bulb into the
socket while aligning the locking tabs.
*
[MC45100( GV)12/95]
2. Rotate the bulb 1/4 turn to lock.
*
[MC45300( ALL)01/96]
3. Push the electrical connector into the rear of
the plastic base until it snaps, locking it into
position.
*
[MC45500( GV)12/95]
4. Close the access panel.
%*
[MC45700( BCGV)01/96]
High-Mount Brakelamp Bulbs
[MC45800( BCGV)12/95]
Your vehicle has a brakelamp mounted in the
rear window, called a high-mount brakelamp.
You may need to remove this lamp at times to
replace the brakelamp bulb or to clean the rear
window.
File:11rcmcv.ex
Update:Thu Jun 20 11:05:52 1996

296 Index
Appeals (see Dispute settlement board) . . 268
Ashtray(s)................ 90
Assistance (see Customer assistance).... 265
Audio system (see Electronic
sound system)............. 45
Autolamp system (see Headlamps)..... 86
Automatic transmission
driving an automatic overdrive . . . 168, 171
fluid, adding............. 229
fluid, checking............ 228
fluid, refill capacities......... 258
fluid, specification........... 259
Axle
lubricant specifications......... 259
refill capacities............ 258
traction lok.............. 165
B
Basic vehicle warranty........... 4
Battery................. 230
acid, treating emergencies.....202, 231
battery saver............. 118
charging system warning light.... 13,26
disconnecting...........206, 231
how to service............ 230
jumping a disabled battery....... 202
maintenance-free........... 230
proper disposal, recycling....... 231
replacement, specifications....... 257
servicing............... 230
voltage gauge.............. 13
when storing your vehicle....... 261
Brake fluid............... 218
brake warning light......... 10,42
checking and adding......... 218
description.............. 218
specifications...........218, 259
File:rcixv.ex
Update:Tue Jun 11 15:30:31 1996

Index 297
Brakelamp............... 250
bulb replacement.........250, 252
high-mount brakelamp........ 250
Brakes................. 161
adjustment.............. 161
anti-lock............... 161
anti-lock brake system (ABS)
warning light.......... 11,41
applying the brakes.......... 161
brake warning light......... 10,42
fluid, checking and adding...... 218
fluid, refill capacities.......218, 258
fluid, specifications........218, 259
front disc.............. 161
if brakes do not grip well....... 161
master cylinder............ 218
new brake linings............ 6
noise................ 162
parking............... 163
power braking............ 161
servicing............... 218
stopping distances.......... 175
when storing your vehicle....... 262
Brake-shift interlock........... 168
Break-in period.............. 6
Brights (high beams)......... 15,25
Bulbs, replacing............. 248
halogen............... 249
headlamps.............. 249
high-mount brakelamp........ 250
specifications............. 252
C
Canada, customer assistance....... 273
Canada, warranty information....... 4
Canadian Motor Vehicle Arbitration Plan
(CAMVAP).............. 273
Capacities for refilling fluids....... 258
Carbon monoxide in exhaust....... 159
File:rcixv.ex
Update:Tue Jun 11 15:30:31 1996