1997 FORD CONTOUR engine

2225 mph [20 and 40 km/h] for vehicles equipped with the
traction control system). The system turns on the ABS pump
motor for approximately 1/2 second. At this time, a mechanical
noise may be heard and felt. This is a normal part of the
self-check feature. If a malfunction is found during this check
the anti-lock light will come on.
[IS10100(ALL)12/95]
6 pica art:0001210-A% [IS10200(ALL)12/95]
Low Coolant Light (If equipped)
*
[IS10300(ALL)03/96]
This light indicates that the level of the engine coolant is low
inside the coolant recovery bottle and that you should add more
coolant. SeeEngine Coolantin the Index.
[IS10400(ALL)12/95]
6 pica art:0001214-B[IS10500(ALL)12/95]
This light comes on for a few seconds when the ignition is
turned to the START position, but should turn off when the
engine starts. If this light stays on, check the level of coolant
inside the recovery bottle. The level may be slightly above the
MIN line because the light is an ªearly warning.º
File:03cdiso.ex
Update:Thu Sep 12 10:58:17 1996

50
[CF03200(ALL)12/95]
Air conditioning
*
[CF03300(ALL)01/96]
A/C
[CF03400(ALL)12/95]
Select A/C to get refrigerated outside air through the
instrument panel registers. The A/C position is used for cooling
except when extremely hot or fast cooling of the vehicle is
needed. Then, select MAX A/C for fast cooling and return to
A/C when you are comfortable.
*
[CF03500(ALL)03/96]
MAX A/C
[CF03600(ALL)03/96]
The MAX A/C position produces cool air more rapidly to
provide faster cooling of your vehicle. This is possible because
cooler air is drawn from inside the passenger area and
refrigerated again instead of using warmer outside air. Using
inside air will also make the fan sound louder, which is normal
when using MAX A/C. The air flow will be from the
instrument panel registers.
[CF03700(ALL)12/95]
Comfort tips
[CF03800(ALL)04/96]
The following tips will help you to get the most satisfaction
from your climate control system.
[CF03900(ALL)12/95]
n
In humid weather, selectVDEF before starting your
engine. This will help to prevent windshield fogging. After a
few minutes of operation, you may select another function.
[CF04000(ALL)12/95]
n
To prevent humidity buildup inside your vehicle, always
drive with the climate control system turned on.
*
[CF04100(ALL)01/96]
n
Do not put objects under the front seats that interfere with
the flow of air to the back seat area.
[CF04200(ALL)12/95]
n
Remove any snow, ice, or leaves from the air intake area of
your heater and air conditioner system which could block
the air intake. The intake area is located at the bottom of the
windshield.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

Controls and Features
51
[CF04300(ALL)12/95]
Passenger Compartment Air Filter (if equipped)
[CF04400(ALL)04/96]
Your vehicle may have an air filter that removes pollen and
road dust from outside air before it is directed to the interior of
the vehicle. For maintenance of this filter, see theMaintenance
and Carechapter.
% [CF04500(ALL)03/96]
Rear Window Defroster (If equipped)
[CF04600(ALL)04/96]
The defroster for the rear window clears frost, fog, or thin ice
from both the inside and outside of the rear window.
[CF04700(ALL)12/95]
The button for the rear window defroster is on the instrument
panel, to the right of the steering wheel.
[CF04800(ALL)12/95]
6 pica art:0001180-C
The rear window defroster and heated side view mirrors
[CF04900(ALL)12/95]
Clear away any snow that is on the rear window before using
the defroster. With the engine running, push the defroster
button.
*
[CF05000(ALL)01/96]
After approximately 10 minutes, the defroster will turn off. If
the window is still not clear, turn the defroster on again.
*
[CF05100(ALL)01/96]
The defroster will turn off when the ignition key is turned to
the OFF or START position.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

Controls and Features
57
[CF09900(ALL)12/95]
ACCESSORY allows some of your vehicle's electrical accessories
to operate while the engine is not running. For example, you
can use ACCESSORY to turn on the radio without starting the
engine.
*
[CF10000(ALL)01/96]
ON allows you to test your vehicle's warning lights (except the
brake system warning light) to make sure they work before you
start the engine. The key returns to the ON position once the
engine is started and remains in this position while the engine
runs.
*
[CF10100(ALL)01/96]
START cranks the engine. Release the key once the engine starts
so that you do not damage the starter. The key should return to
ON when you release it. The START position also allows you to
test the brake warning light.
%*
[CF10200(ALL)03/96]
Removing the Key From the Ignition
[CF10300(ALL)04/96]
Procedures for removing your key from the ignition vary,
depending on whether your vehicle has an automatic or manual
transaxle.
[CF10400(ALL)04/96]
If your vehicle has an automatic transaxle:
*
[CF10500(ALL)01/96]1.
Put the gearshift lever in P (Park).
*
[CF10600(ALL)01/96]2.
Set the parking brake fully.
[CF10700(ALL)12/95]3.
Rotate the ignition key to the LOCK position.
[CF10800(ALL)12/95]4.
Remove the key from the ignition.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

Controls and Features
65
*
[CF16300(ALL)05/96]
If you drive up or down a steep hill, your vehicle may
momentarily slow down or speed up, even though the speed
control is on. This is normal.
[CF16400(ALL)02/96]
NOTE: If your vehicle is equipped with an automatic
transaxle, and if your speed increases above your set
speed while driving in Overdrive on a downhill
grade, you may want to turn the Overdrive off and
use Drive. You may turn the Overdrive off by
pressing the Transaxle Control Switch on the left side
of the gearshift lever. This will reduce vehicle speed
if it goes above your set speed on a downhill grade.
[CF16500(ALL)01/96]
NOTE: If your vehicle is equipped with a 5-speed manual
transaxle, and if your speed increases above your set
speed while driving in 5 (Fifth) gear on a downhill
grade, you may want to shift to 4 (Fourth) gear to
reduce vehicle speed. Depressing the clutch pedal
cancels speed control, therefore speed control must be
reset by pressing the SET/ACC or RES buttons. Speed
control cannot reduce the vehicle speed if it goes
above your set speed on a downhill grade.
[CF16700(ALL)05/96]
To Speed Up
[CF16801(ALL)05/96]
Hold the Set Accel switch down and the vehicle will speed up
without the need to depress the accelerator. When the switch is
released, the system will maintain the speed reached. This speed
becomes the new stored speed.
[CF16901(ALL)05/96]
The vehicle speed can also be increased by momentarily
depressing the Set Accel switch (Tap up). Each tap will increase
the speed by approximately 1 mph (1.6 km/h).
[CF17001(ALL)05/96]
To Slow Down
[CF17101(ALL)05/96]
Hold the Coast switch down and the vehicle will slow down
under normal engine braking. When the switch is released, the
system will maintain the speed reached. This speed becomes the
new stored speed.
File:05cdcfo.ex
Update:Fri Sep 13 08:48:17 1996

117
Starting
%*
[TO00200(ALL)01/96]
Fuel-Injected Engines
*
[TO00300(ALL)01/96]
When starting a fuel-injected engine,the most important thing
to remember is to avoid pressing down on the accelerator
before or during starting. Only use the accelerator when you
have problems getting your vehicle started. SeeStarting Your
Enginein this chapter for details about when to use the
accelerator while you start your vehicle.
*
[TO00400(ALL)01/96]
Starting Your Vehicle
%*
[TO00500(ALL)01/96]
Preparing to Start Your Vehicle
*
[TO00600(ALL)02/96]
RWARNING
Do not start your vehicle in a closed garage or in other
enclosed areas. Exhaust fumes can be toxic. Always open
the garage door before you start the engine.
*
[TO00700(ALL)01/96]
Before you start your vehicle, do the following:
*
[TO00800(ALL)01/96]1.
Make sure all occupants in the vehicle buckle their safety
belts. SeeSafety Restraintsin the Index for more details.
*
[TO00900(ALL)12/95]2.
Make sure your headlamps and other accessories are turned
off and the parking brake is set.
[TO01000(ALL)12/95]3.
If you have a manual transaxle,make sure that the parking
brake is fully set, push the clutch pedal to the floor, and put
the gearshift into Neutral before you turn the key.
(Remember, the starter will operate only if the clutch pedal
is pushed all the way to the floor.)
[TO02000(ALL)12/95]
If you have an automatic transaxle,make sure that the
gearshift is in P (Park) and the parking brake is set before
you turn the key.
*
[TO02100(ALL)02/96]
Before you start your vehicle, you should test the warning lights
on the instrument panel to make sure that they work. Refer to
theInstrumentationchapter.
File:08cdtoo.ex
Update:Thu Sep 12 11:03:39 1996

118
%*
[TO02200(ALL)01/96]
Starting Your Engine
*
[TO02300(ALL)01/96]
To start your engine:
*
[TO02400(ALL)01/96]1.
Follow the steps underPreparing to Start Your Vehicleat the
beginning of this section.
*
[TO02500(ALL)01/96]2.
Keep your foot on the brake pedal and turn the ignition key
to the ON position.
*
[TO02600(ALL)01/96]3.
DO NOT depress the accelerator pedal when starting your
engine. DO NOT use the accelerator while the vehicle is
parked.
*
[TO02700(ALL)01/96]4.
Turn the key to the START position (cranking) until the
engine starts. Allow the key to return to the ON position
after the engine has started.
*
[TO02800(ALL)01/96]
If you have difficulty in turning the key, rotate the steering
wheel slightly because it may be binding.
%*
[TO02900(ALL)01/96]
For a cold engine:
[TO03000(ALL)12/95]
2.0L engine:
[TO03100(ALL)12/95]
n
At temperaturesbelow-10ÊF (-23ÊC):Turn the key to ON,
crank the engine and depress the accelerator about 1/4 of
the way down and hold that position forfive (5) seconds.If
the engine fails to start, continue to crank with the
accelerator depressed about 1/4 of the way down and hold
that position until the engine starts.DO NOT crank for
more than 30 seconds,or you could damage the starter. If
the engine fails to start on the first try, turn the key to OFF
and wait two (2) minutes before trying again. Allow engine
to warm up for a few minutes before putting transaxle into
gear.
File:08cdtoo.ex
Update:Thu Sep 12 11:03:39 1996

Starting
119
[TO03200(ALL)12/95]
n
At temperaturesbetween-10ÊF (-23ÊC) and 10ÊF(-12ÊC):
Turn the key to ON, and crank the engine forfive (5)
seconds.If the engine fails to start, continue to crank and
depress the accelerator about 1/4 of the way down and hold
that position until the engine starts.DO NOT crank for
more than 30 seconds,or you could damage the starter. If
the engine fails to start on the first try, turn the key to OFF
and wait two (2) minutes before trying again.
[TO03300(ALL)12/95]
n
At temperaturesbetween10ÊF (-12ÊC) and 32ÊF (0ÊC):If the
engine does not start infifteen (15) secondson first try, turn
the key to OFF, then try again.
[TO03400(ALL)12/95]
n
At temperaturesabove32ÊF (0ÊC):If the engine does not
start infive (5) secondson the first try, turn the key to OFF,
then try again.
[TO03500(ALL)12/95]
If you have the 4-cylinder 2.0L engine and are not using an
engine block heater, warm up the engine for a minute or two
before putting the transaxle in gear. Depressing the accelerator
slightly will also help with cold starts.
[TO03600(ALL)12/95]
2.5L engine:
*
[TO03700(ALL)01/96]
n
At temperatures10ÊF (-12ÊC) andbelow:If the engine does
not start infifteen (15) secondson the first try, turn the key
to OFF, wait approximately ten (10) seconds so you do not
flood the engine, then try again.
[TO03800(ALL)12/95]
n
At temperaturesabove10ÊF(-12ÊC):If the engine does not
start infive (5) secondson the first try, wait approximately
ten (10) seconds so you do not flood the engine, then try
again.
File:08cdtoo.ex
Update:Thu Sep 12 11:03:39 1996