1997 FORD AEROSTAR instrument panel

69
%*
[CF00650(ALL)03/96]
Rear Window Defroster
(If equipped)
*
[CF00660(ALL)03/96]
The defroster for the rear window clears frost,
fog, or thin ice from both the inside and outside
of the rear window.
*
[CF00670(ALL)03/96]
The control switch is located on the instrument
panel to the right of the steering column.
[CF00680(ALL)01/96]
one third page art:0020899-A
Rear window defroster switch
*
[CF00690(ALL)03/96]
To defrost the rear window:
*
[CF00700(ALL)03/96]
1. Clear any snow or ice from the rear
window.
*
[CF00710(ALL)03/96]
2. Get in your vehicle and start the engine.
[CF00720(ALL)04/96]
3. Press the switch. The indicator light will turn
on.
[CF00730(ALL)04/96]
The defroster turns off automatically after
approximately 10 minutes. If the window is not
clear, turn on the defroster again. It will also
automatically shut off any time the engine is
shut off.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

70 %
*
[CF00740(ALL)03/96]
NOTE: Never use sharp instruments or
window cleaners with abrasives to
clean the inside of your rear window.
If you do, you may damage the heating
elements that are bonded to the inside
of the rear window and cause damage
to the rear window defroster.
[CF00750(ALL)03/96]Rear Window Wiper and
Washer (If equipped)
[CF00760(ALL)01/96]
The rear window wiper control switch is located
on the instrument panel to the right of the
steering column.
[CF00770(ALL)01/96]
To wash and wipe the rear window:
[CF00780(ALL)01/96]
1. Push the top of the switch to turn on the
wipers.
[CF00790(ALL)01/96]
2. Push and hold the WASH control switch for
a constant spray.
[CF00800(ALL)01/96]
3. Release to the outer position. The spray will
stop and the wipers will remain running.
[CF00810(ALL)01/96]
4. Push the top of the switch to stop the
wipers.
[CF00820(ALL)01/96]
quarter page art:0020116-E
Rear window wiper/washer control button
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

72 %
*
[CF01060(ALL)03/96]
Daytime Running Light System
*
[CF01070(ALL)03/96]
(Canadian vehicles only)
*
[CF01080(ALL)03/96]
The Daytime Running Light (DRL) system turns
the high beam headlamps on, with a reduced
light output, when:
*
[CF01090(ALL)03/96]
q
The headlamp system is in the OFF position,
and
*
[CF01100(ALL)01/96]
q
The vehicle is running, and
*
[CF01110(ALL)03/96]
q
The vehicle has a fully released parking
brake.
*
[CF01120(ALL)01/96]
NOTE: You may notice that the lights flicker
when the vehicle is turned on or off.
This is a normal condition.
*
[CF01130(ALL)03/96]
RWARNING
The Daytime Running Light (DRL) system
will not illuminate the tail lamps and
parking lamps. Turn on your headlamps
at dusk. Failure to do so may result in a
collision.
*
[CF01140(ALL)01/96]
Instrument Panel Illumination
*
[CF01190(ALL)03/96]
The instrument panel lights can be turned on by
pulling the headlamp switch toward you to
either the first or outer position. You can
brighten or dim the instrument panel lights by
rotating the headlamp switch knob.
% [CF01230(ALL)04/96]
High-mount Brakelamp
[CF01235(ALL)01/96]
The high-mount brakelamp is located above the
rear window on liftgate models, and on the roof
above the rear doors on dual rear door models.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

75
make sure they work before you start the
engine. The key returns to the ON position once
the engine is started and remains in this position
while the engine runs.
*
[CF02180(ALL)01/96]
START cranks the engine. Release the key once
the engine starts so that you do not damage the
starter. The key should return to ON when you
release it. The START position also allows you
to test the brake warning light.
%
*
[CF02500(ALL)02/96]
The Turn Signal Lever
*
[CF02510(ALL)02/96]
You can use the turn signal lever on the left side
of the steering column to:
*
[CF02520(ALL)02/96]
q
operate the turn signals and cornering lamps
*
[CF02530(ALL)03/96]
q
turn the high beams on/off
*
[CF02540(ALL)03/96]
q
flash the lamps
*
[CF02550(ALL)03/96]
q
turn the windshield wipers and washer
on/off
%*
[CF02560(ALL)01/96]
Turn Signals
[CF02570(ALL)01/96]
one third page art:0095013-A
Turn signal operation
*
[CF02580(ALL)08/95]
If the turn indicator light in the instrument
panel does not illuminate or remains on (doesn't
flash) when you signal a turn, the turn signaling
system is malfunctioning. Have this condition
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

76corrected as soon as possible, but make sure that
you use the accepted hand signals in the
meantime.
*
[CF03200(ALL)08/95]
High Beams and Flashing the Lamps
[CF03800(ALL)01/96]
one third page art:0095014-A
Headlamp high beam and flash-to-pass operation
%*
[CF04400(ALL)01/96]
Windshield Wipers and Washer
*
[CF04500(ALL)04/96]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[CF04950(ALL)01/96]
one third page art:0095015-A
Interval wiper on turn signal lever Ð wiper and washer
operation
*
[CF05000(ALL)08/95]
To set the interval wipers, rotate the knob at the
end of the turn signal lever toward or away
from the instrument panel to the interval
operation you desire.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

153
Starting
%*
[TO04800(ALL)01/96]
Fuel-Injected Engines
*
[TO04900(ALL)01/96]
When starting a fuel-injected engine,the most
important thing to remember is to avoid
pressing down on the accelerator before or
during starting. Only use the accelerator when
you have problems getting your vehicle started.
SeeStarting Your Enginein this chapter for
details about when to use the accelerator while
you start your vehicle.
*
[TO05150(ALL)01/96]
Starting Your Vehicle
%*
[TO05200(ALL)01/96]
Preparing to Start Your Vehicle
*
[TO05300(ALL)02/96]
RWARNING
Do not start your vehicle in a closed
garage or in other enclosed areas. Exhaust
fumes can be toxic. Always open the
garage door before you start the engine.
*
[TO05400(ALL)01/96]
Before you start your vehicle, do the following:
*
[TO05500(ALL)01/96]
1. Make sure all occupants in the vehicle
buckle their safety belts. SeeSafety Restraints
in the Index for more details.
*
[TO05600(ALL)01/96]
2. Make sure the headlamps and other
accessories are turned off when starting.
*
[TO05750(ALL)01/96]
3. Make sure that the gearshift is in P (Park)
and the parking brake is set before you turn
the key.
*
[TO06015(ALL)02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
File:08cptoa.ex
Update:Thu Jun 6 14:43:40 1996

172
*
[GF12500(ALL)05/96]
4. Apply the brake pedal and shift to N
(Neutral). (If the vehicle is shifted back to P
[Park], you must repeat the previous steps.)
*
[GF12600(ALL)05/96]
5. Start the vehicle.
*
[GF12700(ALL)05/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledRoadside Emergenciesin
this Owner Guide for instructions on checking
and replacing fuses.
*
[GF12800(ALL)05/96]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
*
[GF12820(ALL)05/96]
P (Park)
[GF12830(ALL)03/96]
Always come to a complete stop before you shift
into P (Park). This position locks the
transmission and prevents the rear wheels from
turning.
[GF12840(ALL)03/96]
To securely latch the gearshift in the P (Park)
position, pull it toward you, push it completely
counterclockwise against the stop, and then push
it toward the instrument panel.
*
[GF12850(ALL)06/96]
The gearshift is securely latched in P (Park) if
you cannot rotate it in a clockwise direction
without lifting it toward you.
*
[GF12860(ALL)05/96]
RWARNING
Always set the parking brake fully and
make sure the gearshift is latched in P
(Park). Turn off the ignition whenever you
leave your vehicle.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

203 [ER00425(ALL)01/96]
full page art:0020516-I
Fuses and their location (under instrument panel on
driver's side)
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996