Page 13 of 256

Downloaded from www.Manualslib.com manuals search engine DIODE REPLACEMENT
(1) Disconnect the battery.
(2) Locate the diode in the harness, and remove
the protective covering.
(3) Remove the diode from the harness, pay atten-
tion to the current flow direction (Fig. 23).
(4) Remove the insulation from the wires in the
harness. Only remove enough insulation to solder in
the new diode.
(5) Install the new diode in the harness, making
sure current flow is correct. If necessary refer to the
appropriate wiring diagram for current flow.
(6) Solder the connection together using rosin core
type solder only.Do not use acid core solder.
(7) Tape the diode to the harness using electrical
tape making, sure the diode is completely sealed
from the elements.
(8) Re-connect the battery, and test affected sys-
tems.
SPECIAL TOOLS
WIRING/TERMINAL
Fig. 23 Diode Identification
Probing Tool Package 6807
Terminal Pick 6680
Terminal Removing Tool 6932
Terminal Removing Tool 6934
PL8W - 01 GENERAL INFORMATION 8W - 01 - 11
SERVICE PROCEDURES (Continued)
Page 17 of 256
Downloaded from www.Manualslib.com manuals search engine 8W-02 COMPONENT INDEX
GENERAL INFORMATION
INTRODUCTION
This section provides an alphabetical listing of all
the components covered in group 8W. For information
on system operation, refer to the appropriate section
of the wiring diagrams.
PL8W - 02 COMPONENT INDEX 8W - 02 - 3
Page 31 of 256
Downloaded from www.Manualslib.com manuals search engine 8W-10 POWER DISTRIBUTION
DESCRIPTION AND OPERATION
This section covers the power distribution center
and all circuits involved with it. For additional infor-
mation on system operation, refer to the appropriate
wiring diagrams.
PL8W - 10 POWER DISTRIBUTION 8W - 10 - 13
Page 46 of 256
Downloaded from www.Manualslib.com manuals search engine 8W-11 FUSE/FUSE BLOCK
DESCRIPTION AND OPERATION
This section covers the fuse block and all circuits
involved with it. For additional information on sys-
tem operation, please refer to the appropriate section
of the wiring diagrams.
8W - 11 - 14 8W - 11 FUSE/FUSE BLOCKPL
Page 56 of 256
Downloaded from www.Manualslib.com manuals search engine 8W-15 GROUND DISTRIBUTION
GENERAL INFORMATION
This section identifies the grounds, splices that
connect to those grounds, and the components that
connect those grounds. For additional information on
system operation, refer to the appropriate section ofthe wiring diagrams. For an illustration of the phys-
ical location of each ground, refer to group 8W-90.
8W - 15 - 10 8W - 15 GROUND DISTRIBUTIONPL
Page 247 of 256

Downloaded from www.Manualslib.com manuals search engine 8W-95 SPLICE LOCATIONS
DESCRIPTION AND OPERATION
INTRODUCTION
This section provides illustrations identifying the
general location of the splices in this vehicle. A splice
index is provided. Use the wiring diagrams in each
section for splice number identification. Refer to the
index for the proper splice number.
SPLICE LOCATIONS
The following index covers all splices shown in the
wiring diagrams. If a splice is not shown in this sec-
tion, a N/S will be in the Fig. column.
Spllice Location Fig.
S101 Near Dat Link T/O 1
S102 In CAB T/O 1
S103 Near CAB Connector 1
S104 Right Strut Tower 1
S105 Near Right Cowl Top Grommet N/S
S106 Near PCM T/O 1
S107 Before T/O for Left Headlamp 2
S108 Before T/O for Left Headlamp 2
S109 Before T/O for Left Headlamp 2
S110 In PCM T/O 1
S111 In PCM T/O 1
S112 Near T/O for Left Headlamp 2
S113 Near T/O for Left Headlamp 2
S114 Near T/O for Left Headlamp 2
S115 Neat T/O for Radiator Fan Motor 2
S116 Near T/O for Left Fog Lamp 2
S117 Near EVAP/Purge Sol T/O 2
S118 Between O2S and Crank Sensor
T/O3
S119 Between O2S and VSS T/O 3
S120 Between INJ #3 and #4 T/O 3
S121 Between INJ #1 and #2 T/O 3
S122 Near T/O for EGR Sol 3
S123 Near HD/LP and Dash Connector 3
S124 Between Cam Sensor and Coil
T/O's3
S125 Near Starter 3
S126 Near PCM T/O 1
S127 Near Ignition Coil 3
S128 Near A/C Compressor Clutch T/O N/S
S129 In PCM T/O 1
S201 Near T/O for Center Console N/S
S202 Near T/O for PAB 5
S203 Near T/O for HVAC 5Spllice Location Fig.
S204 Near HVAC Connector 5
S205 Near Center Stack T/O 5
S206 Near Center Stack T/O 5
S207 Top Center of I.P. 4
S208 Top Center of I.P. 4
S209 Top Center of I.P. 4
S210 Top Center of I.P. 4
S211 Between RT and LT Cluster T/O's 4
S212 Between RT and LT Cluster T/O's 4
S213 Near T/O for Fuseblock 4
S214 Near T/O for Fuseblock 4
S217 Near T/O for Fuseblock 4
S218 Between RT and LT Cluster T/O's 4
S220 Near Fuseblock T/O 4
S221 Top Right of I.P. 5
S301 Near LT B-Pillar T/O 6
S302 Near LT B-Pillar T/O 6
S303 Near LT B-Pillar T/O 6
S304 Near Fuel Tank T/O 6
S305 Near Right Rear Body Ground T/O 7
S306 Near Fuel Tank T/O 7
S307 Between LR Body Ground and LT
Tail Lamp T/O6
S308 Near LR Body Ground 6
S309 Near Top of A-Pillar, Left Side N/S
S310 Near DR/LK SW and PWR Mirro
T/O8
S311 Near LR Wheel House T/O 6
S312 On RR Wheel House 7
S313 Near T/O for Sunroof Slide SW N/S
S314 Near T/O for Sunroof Slide Switch N/S
S316 Near Fuel Tank T/O 6
S317 Near Fuel Tank T/O 7
S318 Near DR/LK Switch T/O 8
PL8W - 95 SPLICE LOCATIONS 8W - 95 - 1