1997 CHEVROLET S10 clock

Downloaded from www.Manualslib.com manuals search engine som-ething ignites it; y0.u could. be badly burned.
Gasoline
can spray out on you if you open the
fuel fiIler cap too quickly. This spray can happen
if your tank is nearly full, and is more likely in
hot weather. Open the fuel fiier cap slowly and
wait for;ang ‘ShW’ noise to stop. Then unscte-w
the cap all the way.
Be- careful .not to spill gasolina. C1e.m gasoline from
painted
surfaces-as- SOO~ as possible. Se-e “Clean-ing the
Out; e
o lam Vehicle” in- the Index.
When y0.u put the cap back on, twn it to the right
(clockwise) until you hear a cli.cking sound. Make sure
you -fully install the cap. The-dia.gn determine if the E~1.d cap has b-e-e,n left off DX .impr.~pesly
installed,
This would-allow fud to evaporate into the
atmos.phere.
See “Malfunction Indicator Lamp” in
the Index,
NOTICE:
If y0.u need .a new cap, be sure to get the right
type. Your dealer ean get. one for you. If you $-et
the wrong type, itmay not fit properly. This-may
cause your rnalfunctiori indicator lamp to
li.ght
and your fuel tank and emissions. system may be
damaged. S;ee “Malfunction Indicator Lamp” in
the
Index.
Checking Things Under the Ho
To open the hood, first pull
the handle- inside the vehicle
on the lower left side of the
instrument panel.

Downloaded from www.Manualslib.com manuals search engine 5. Turn the. bulb
countercl.ockrwise
to
remove it.
6. .Put-the new bulb into theheadlamp lens ass-ernbiy
7. PhLg in the e1ectric.al connector.
and turn it clockwise until it is tight.
8. P.ut the headlamp 1-ens assembly back into t.he
ve:hicle. Insrall and tighten the screws.
Front Turn Signal Lamps
If you. have fog.lamps, the fog lalizp bracket rnusE.De &H6v'ed
before you can rep1ac.e the front parking/!turn signal limps.
1, Rea.ch under the bumper and behind the parkin,g/turn
2. Push the tab on the socket, turn the socket
3. Holding the base of the bulb, pull the bulb straight
signal lamp
assembly.
counterclockwise and pull
it out,
out
of the socket.
4. Push the new bu1b.int.o the socket until it clicks.
5. Put the socket-back into lhe parkinghrn signal lamp
assembly and turn it clockwise until it locks into place.

Downloaded from www.Manualslib.com manuals search engine F.ront Sidemarker Lamps.
1.
2.
3.
4.
5.
6 ,.
7.
8.
9.
Remove the le-ns retaining screws.
Remove the sidenmker lens from the .radiator grille.
Turn the bulb and socket one-quarter of a-turn
counterclockwise,
Remove thebulb and socket fro'm the lens.
Install. the new:bulb and socket 10 the
sidemarker lens.
Rotate
the bulb and-socket one-quarter of-a
.turn ciockwise.
Install the sidemarker lens to the radiator grille.
Insert the tabs into.the locators-
Tnstall and tighten the screws.
Center High-Mounted- Stoplamp
1. Remove the lais i-.etairiing scre~s;
.2. Remove the lens.

Downloaded from www.Manualslib.com manuals search engine 4. Insrall a new bulb?
3. Remove. the bulb.
and tighten the screws.
If equipment--such as a cap or camper is installed on
your vehicle, a center high-mounted stoplamp feed wire
is provided along the driver's s.iid& rear fram-e. This wire
,-rshould be used to install a center high-mounted
'-stoplanip in the cap 'or c.mper;
Taillamps
1 .. Open the tailgate;
2. Re,move the-.screws fr~m
the lamp assembly nea
the tailgate latch..
3. Pull the assembly away from the pickup side. panel.
4. Turn the socket countexclockwise to remove it. Push
the tab. i-n while you turn the s,ocket.
5. Pull the bulb out.
,6. Push the new bulb into the socket-.
7. Put the scrcket into the assembly and.ttlrn the s:ocket
clockwk until it locks into-place-:
8. Rep1.ac-e-the assembly. Install and tighten the screws,
-9. Close the tailgate.
6-40

Downloaded from www.Manualslib.com manuals search engine Fuges and Circuit Breakers:
The wing circuits .in YWT v-ehicle ,are protegted ,from
short circuits-by a eo1Gbination :Qf fuses, cizcuit brre.akers
and fusible thermal Lid&. This greatly reduces the
cha-nce offires .caused by electrical problems.
Look
at the .silver-odored baml inside the fuse. If the
band is. broken.;oT melted, replace the- fuse. Be sure you
r.epl.ace a bad fuse with a new me of the identieallsize
.and rating.
If you ever-have a problem .on the road and don't have a
spare fuse, you can borrow one that has the same
amperage. Just pick some fkatwe of your vehicle that
,yuu cafi 'get alo~g withoul-- like the radio or cigarette
lightw- and use its fuse, if it is the corfect:amperage.
Replace
it as:soon as you can.
Instrument Panel Fuse Block
.The fuse b1o;ck.i~ at the
.driver 'k end of the
instrurhent panel.
Remove the cover by turning the -fastener
co~nterclockwise. Extra fuses and th-e-fuse extractor 'are
provided in the cover. To reinstall the fuse panel cover,
-push in and turn the fastener ctockwi.se.
6-64