1997 CADILLAC DEVILLE driver seat adjustment

Downloaded from www.Manualslib.com manuals search engine Power Lumbar Control (If Equipped)
The LUMBAR control is
located on the outboard side
of each front seat. It
provides additional support
to your lower back and it
works independently of the
other seat controls. Use the
power seat control first to
get the proper position.
Then proceed with the
lumbar adjustment.
To reshape the lower seatback, move the LUMBAR
switch forward to increase support and rearward to
decrease support. Move the LUMBAR switch side to
side to raise or lower the support mechanism to suit
your preference.
Keep in mind that as your seating position changes, as
it may during long trips,
so should the position of your
lumbar support. Adjust the seat as needed.
If you have the optional personalization package, the
power lumbar control can be programmed for memory
recall. For more information, see “Memory Seat and
Mirrors” later
in this section.
Memory Seat and Mirrors (If Equipped)
Adjust the driver’s seat (including lumbar adjustments)
and both outside mirrors to a comfortable position and
then press the
SET button. Within five seconds, press
button
“l.’, A second mirror and seating position may be
programmed by repeating the above steps and pressing
button
“2” instead of button 1.
Note that each time a memory button is pressed, a single
beep will sound through the left front speaker.
1-3

Downloaded from www.Manualslib.com manuals search engine If your vehicle is in PARK (P), you can recall mirror
and seating positions by briefly pressing button
1 or 2.
This will adjust the seat and mirrors to where you
have previously programmed them. If you have
accidentally pressed one
of the memory recall buttons
and want to stop seat or mirror movement, press one
of the manual seat or mirror control buttons. This
cancels a memory recall.
You can also recall a seat and mirror position if your
vehicle is not in PARK (P). Press and hold either the
1 or 2 button until seat and mirror movement is
complete. Releasing the buttons will stop adjustment.
The EXIT button can be programmed to allow easy exit
for up to two drivers. Adjust the seat to a comfortable
“exit” position and then press the
SET button followed
by the EXIT button. While your vehicle is in PARK (P),
briefly press the EXIT button to recall your programmed
exit position. Automatic seat, mirrors, comfort controls and radio
movement will occur
if the Remote Keyless Entry
(RE) transmitter is used
to enter the vehicle. The
number on the back of the transmitter corresponds to
the
1 or 2 seat, mirror, comfort controls and radio
positions. After the unlock button is pressed on the
RKE transmitter (the ignition must be in lock) or
when the key is placed in the ignition, the seat, mirrors,
comfort controls and radio will automatically adjust to
the appropriate positions.
Automatic seat, mirrors, comfort controls and radio
movement are programmed through the Driver
Information Center
(DIC) so that the driver can select
whether or not movement will occur using the RKE
transmitter
or by placing the ignition key in the ignition.
For more information, see “Remote Recall Memory” in
the Index.
1-4

Downloaded from www.Manualslib.com manuals search engine 5. Reinstall the headlamp housing socket back into the
headlamp assembly.
Headlamp Aiming
Your vehicle has the 55 x 135 mini-quad headlamp
system. These headlamps have horizontal and vertical
aim indicators. The aim has been pre-set at the factory
and should need
no further adjustment.
If your vehicle is damaged in an accident and the
headlamp aim seems to be affected, see your
Cadillac dealer. Headlamps
on damaged vehicles
may require recalibration of the horizontal aim by
your Cadillac dealer.
To check the aim, the vehicle should be properly
prepared as follows:
The vehicle must have all four tires on a perfectly
level surface.
The vehicle should not have any snow, ice or mud
attached to it.
0 There should not be any cargo or loading of the
vehicle, except it should have a full tank of gas and
one person or
160 lbs. (75 kg) on the driver’s seat.
0 Tires should be properly inflated.
The horizontal indicator should read “0.”
6-33

Downloaded from www.Manualslib.com manuals search engine Replacement Bulbs
...................................... 6-69
Normal Maintenance Parts
...................... 6-70
Wheel
...................................... 6-46
Replacing Safety Belts
........................... 1-48
Reporting Safety Defects
.................... 7- 12. 7. 13
Restraints Checking
................................... 1-48
Child
....................................... 1-37
Head
........................................ 1-7
Replacing Parts After a Crash
................... 1-48
Retained Accessory Power
........................ 2-21
Reverse. Automatic Transaxle
..................... 2-26
Right Front Passenger Position
.................... 1-22
RKE
.......................................... 2-7
RKE Personalization Features
...................... 2-9
Roadside Service
................................ 7-5
Rocking Your Vehicle
........................... 5-37
Rotation. Tires
................................. 6-42
Safety Belt Extender
............................ 1-48
SafetyBelts
.................................... 1-7
Adults
...................................... 1-13
Care
....................................... 6-52
Center Passenger Position
...................... 1-30
Children
.................................... 1-35
Driver Position
............................... 1-13
Extender
.................................... 1-48
How to Wear Properly
......................... 1- 13 Incorrect Usage
.................... 1.17. 1.46.
1-47
Lap Belt
.................................... 1-30
Larger Children
.............................. 1-45
Rear Seat Outside Passenger Positions
............ 1-32
Rear Seat Passengers .......................... 1-31
Reminder Light
.......................... 1.8. 2.74
Replacing After a Crash
........................ 1-48
Right Front Passenger Position
.................. 1-22
Shoulder Belt Height Adjuster
................... 1-15
Shoulder Belt Tightness Adjustment
.............. 1-16
Smaller Children and Babies
.................... 1-35
Use During Pregnancy
......................... 1-21
WhyTheyWork
............................... 1-9
Safety Chains
.................................. 4-36
Safety Defects. Reporting
................... 7- 12. 7.13
Safety Warnings and Symbols
....................... xi
Seatback. Reclining Front
......................... 1-5
Seats
Heated
...................................... 1-5
Lumbar Control ............................... 1-3
Memory Function .............................. 1-3
Power
....................................... 1-2
Restraint Systems
.............................. 1 . 1
Seatcontrols ................................. 1-2
Securing a Child Restraint
............ 1-39, 1-41, 1-43
Second Gear, Automatic Transaxle
................. 2-27
Security Override
............................... 2-18
Lap-Shoulder
........................... 1 . 13. 1.32
Questions and Answers
........................ 1 . 12
8-9