Page 254 of 338
Downloaded from www.Manualslib.com manuals search engine Checking Engine Oil
Pull out the dipstick and clean it with a paper towel or
cloth, then push it back in all the way. Remove it again,
keeping the tip down, and check the level. NOTICE:
Don’t add too much oil. If your engine has so
much oil that the oil level gets above the upper
mark that shows the proper operating range, your engine could be damaged.
The oil fill cap is located
behind the engine oil dipstick and next to the
engine block on the driver’s
side of the engine. Turn the
cap counterclockwise to
remove it.
When to Add Oil
If the oil is at or below the MIN mark, then you’ll
need to add at least one quart of oil. But you must use
the right kind. This part explains what kind of oil to use.
For crankcase capacity, see “Capacities and
Specifications” in the Index. Be sure
to fill
it enough to put the level somewhere in
the proper operating range. Push the dipstick all the way
back in when you’re through.
Page 274 of 338
Downloaded from www.Manualslib.com manuals search engine c
2. On the outboard side of each low-beam headlamp,
you will find the turn signal bulbs. Turn the lamp
assembly clockwise to remove. 3. Twist the bulb out to replace and then reassemble.
6-31
Page 280 of 338
Downloaded from www.Manualslib.com manuals search engine Wiper Blade Replacement
It’s a good idea to clean or replace the wiper blade
assembly on a regular basis or when worn. For proper
windshield wiper blade length and type see “Normal
Maintenance Replacement Parts” later in this section.
To replace the wiper blade assembly:
1. Position the wipers on the windshield in the “mid”
wipe position.
2. Press the tabs together and pull the wiper blade
assembly down enough to release it from the
“J”
hooked end of the wiper arm. Slide the assembly
away from the arm.
3. Replace the blade.
4. To reinstall the wiper blade assembly, slide it over
the wiper arm
to engage the “J” hooked end on the
wiper blade assembly. Pull up on the assembly to
lock it into place.
I
6-37
Page 299 of 338

Downloaded from www.Manualslib.com manuals search engine Headlamp Wiring
The headlamp wiring has an individual fuse which is
powered by a MaxiFuse@. An electrical overload will
cause the lamps to
go on and off, or in some cases to
remain
off. If this happens, have the headlamp wiring
checked right away.
MaxiFuseRelay Center
MaxiFuse is a registered trademark of Little
Fuse Incorporated.
Windshield Wiper Fuses
The windshield wiper motor is powered by a MaxiFuse.
If the motor overheats due to heavy snow, etc., the
wipers will stop until the motor cools.
If the overload
is caused by some electrical problem, be sure to have
it fixed.
Power Windows and Other Power Options
Circuit breakers protect the power windows and other
power accessories, When the current load is too heavy,
the circuit breaker opens and closes, protecting the
circuit until the problem
is fixed or goes away. The MaxiFuseRelay
center is attached to the engine
compartment fuse block on top of the battery. Simply
lift the lid
to open. If you have any questions about the
MaxiFuseRelay Center, consult your Catera dealer.
6-56
Page 300 of 338

Downloaded from www.Manualslib.com manuals search engine Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
the short circuits by a combination of fuses and circuit
breakers. This greatly reduces the chance of fires caused
by electrical problems.
Look at the silver-colored band inside the fuse.
If the
band is broken or melted, replace the
fuse. Be sure you
replace a bad fuse with a new one of the identical size
and rating.
If you ever have a problem on the road and don’t have
a spare fuse, you can “borrow” one that has the same
amperage. Pick some feature of your vehicle that you
can get along without
-- like the radio or cigarette
lighter
-- and use its fuse, if it is the correct amperage.
Replace it as soon as you can.
There
are two fuse blocks in your vehicle: the instrument
panel fuse blocks and the engine compartment relay center.
Instrument Panel Fuse Block (Driver’s Side)
The fuse block is located below the steering wheel on
the driver’s side. Using a screwdriver, loosen the two
trim fasteners under the trim panel and pull the trim
panel away from the instrument panel to access.
6-57
Page 302 of 338

Downloaded from www.Manualslib.com manuals search engine Fuse
15
-
16
17
18
19
20
21
22
23
Usage
Rear Suspension Leveling Air Compressor
Relay, Instrument Cluster, Gage Cluster,
Cruise Control Switch and Module, Headlamp
Switch, Multifunction Relay Module,
Passenger and Driver Heated Seat Relay,
BCM, Sunroof Actuator, Automatic Level
Control Sensor, RH and LH Heated Rear Seat
Switch and Cushion Relay, Driver Seat
Adjuster Memory Module, LH Front Side
Door Window Switch, Inside Rearview Mirror
Transmission Control Module
Horn #I and
#2
Fuel Pump
Electronic Brakemraction Control Module Passenger and Driver Heated Seat Relay
Daytime Running Lamp (DRL) Relay, LH
High-Beam Headlamp Relay
Headlamp Switch and LH Low-Beam
Headlamp
Multifunction Relay Module, LH Park/T.urn
Signal Lamp, LH StopRaillamp, LH Rear Side
Marker Lamp
Fuse
24
25
26
27
28
29 30
31 32
33
34
35
Usage
Lifting Magnet, BCM, Gage Cluster
Sunroof Actuator
Headlamp Switch, RH and LH Front Side
Marker Lamp, Middle Taillamp, RH and LH
Rear License Plate Lamp, Radio, Automatic
Transmission Control Indicator, Heater and
A/C Control
Automatic Level Control Sensor, Rear
Suspension Leveling Air Compressor and Relay
Remote Control Door Lock Receiver, Door
Lock Relay, Rear Compartment Lid Release
Connector (Not Used)
Multifunction Relay Module
RH Park/Turn Signal Lamp and RH
StopRaillamp, RH Rear Side Marker Lamp
Turn Signal Switch and RH Low-Beam
Headlamp
RH High-Beam Headlamp Relay
Blower, A/C Compressor Relay
Heated Outside Rearview Mirror and Rear
Window Defogger Relay Passenger and Driver Seat Adjuster Switches,
Driver Seat Adjuster Memory Module
6-59
Page 303 of 338
Downloaded from www.Manualslib.com manuals search engine Instrument Panel Fuse Block (Passenger’s Side)
f I I[: rn
m
PRK LP
RR WDO DEFOG
m
FLASHER HTD MIRROR 7x
HI BEAM LH ALC
Ip LO BEAM
P IZI x
HI BEAM RH HORN x
DRL
Fusemelay
I
I1
I11
IV V
VI
VI1
VI11
IX
X
XI
Usage
High-Beam Headlamp - LH
Automatic Level Control
Heated Rear Window, Heated
Power Mirrors
Hazard Warning Flashers
High-Beam Headlamp
- RH
Horn
Parking Lamps
Low-Beam Headlamps
Daytime Running Lamps
6-60
Page 315 of 338
Downloaded from www.Manualslib.com manuals search engine Emergency Road Service is performed on site for the
following situations:
0 Towing Service
0 Battery Jump Starting
0 Lock Out Assistance
Fuel Delivery
0 Flat Tire Change (Covers change only)
0 Trip Interruption -- If your trip is interrupted due
to a warranty failure, incidental expenses may
be
reimbursed during the 48 months/50,000 miles
(80 000 km) warranty period. Items covered are
hotel, meals and rental car.
7-6