13-20
Dual-mass flywheel
Notes:
Only replace oil seal with sealing flange.
Drain coolant before removing sealing flange
page 19
-11
.
If sealing flange is not available, proceed as
follows:
- Remove clutch and dual-mass flywheel or
driveplate.
Notes: - Pry out seal using 10-221 extractor.
- Clean running and sealing surfaces.
- Push seal onto crankshaft using assembly aid.
Do not lubricate sealing lip or outer edge of seal before pressing in.The assembly aid is supplied with the seal.
- Press in seal up to stop using 2003/3 seal installer and bolts for dual-
mass flywheel or driveplate.
Pa
ge 19 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
13-22
Dual-mass flywheel or driveplate,
removing and installing, installation
dimensions
Dual-mass flywheel
Note:
A pilot needle bearing is in the dual-mass flywheel and must be inserted
when dual-mass flywheel is replaced.
Note:
Always replace dual-mass flywheel mounting bolts. - With crankshaft at Top Dead Center (TDC), install 3242 crankshaft
holder.
- Mark position of dual-mass flywheel and engine housing (arrows).
- Remove bolts and replace.Component
Tightening torque
Dual-mass flywheel to crankshaft
60 Nm (44 ft lb) + 180 Clutch to dual-mass flywheel 20 Nm (15 ft lb)
Pa
ge 21 of 33 C
ylinder block, crankshaft and fl
ywheel, servicin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.2
