Page 1 of 13
70-40
 
  
Instrument panel Instrument panel (with cross member), 
removing and installing
 
1 - 
Cap for instrument panel (2x) 
Unclip cap
2 - 
Bolt (4x) 12 Nm (9 ft lb)
3 - 
Bolt (4x) 12 Nm (9 ft lb)
4 - 
Bracket Remove bolts -2- and -3-.
Pa
ge 1 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 2 of 13
70-41
 
  
5 - 
Instrument panel with cross member 
  Removing:
 - Position windshield wipers to upper-most 
position. 
 - Remove steering column brace   Fig. 
2 . 
 - Remove steering wheel  page 69
-57
 .
 - Remove driver-side airbag unit   page 
69
-54
 . 
 - Remove driver-side knee bolster   page 
68
-8 . 
 - Remove passenger-side knee bolster   
page 68
-1 . 
 - Remove rear center console   page 68
-
13
 . 
 - Remove front center console   page 68
-
30
 . 
 - Remove instrument panel center piece 
 page 68
-31
 . 
 - Remove airbag control module   page 
69
-74
 . 
 - Disconnect left and right-rear heating 
ducts in floor well. 
 - Disconnect coolant hoses and A/C lines 
(evacuate refrigerant). 
Pa
ge 2 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 3 of 13
 Repair Manual, Heating & Air Conditioning, 
Repair Group 87
   
  - Remove rubber grommet.
 - Remove lower A-pillar trim   page 70
-
72
 . 
Pa
ge 3 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 4 of 13
70-42
 
  
 Repair Manual, Electrical Equipment, Repair 
Group 97.
     - Disconnect wiring at connector stations 
in left and right A-pillars (item -A-). 
 - Disconnect electrical harness connectors 
in item -B-. 
 - Disconnect positive wiring at relay station 
(item -C-). 
 - Disconnect negative connection (item -C-
). 
 - Disconnect wiring in area of center 
tunnel. 
 - Disconnect electrical and vacuum 
connections for brake light switch and 
cruise control system at pedal assembly. 
 - Remove bolts -2- and -3- as well as 
bracket -4-. 
  - Remove nuts -8- and bracket -9-.
 - Disconnect pedal assembly from 
instrument panel cross member   Fig. 
1 . 
 - Disconnect lower part of steering column 
from steering gear and secure   Fig. 1
 . 
  - Remove nuts -12- and -13-.
Pa
ge 4 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 5 of 13
 - Cover both seats to protect them from 
damage. 
 - Pull instrument panel forward and pull 
out clips -7- with help from second 
technician. 
Pa
ge 5 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 6 of 13
70-43
 
  
  Installing:
Installation is the reverse of removal
  Adjusting:Instrument panel with cross member must 
be centered in vehicle 
6 - 
Angle bracket With felt base
7 - 
Retaining clip (2x) 
8 - 
Nut (2x) 
9 - 
Bracket 
10 - 
Angle bracket 
11 - 
Bolts (5x) Left-side (3x)Right-side (2x)23 Nm (17 ft lb)
12 - 
Nut (2x) 45 Nm (33 ft lb)
13 - 
Nut (2x) 45 Nm (33 ft lb)
Pa
ge 6 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 7 of 13
70-44
 
    
Fig. 1  Disconnecting pedal assembly
- Remove bolt -1-.
   Tightening torque: 25 Nm (18 ft lb)
    
Note:  
The steering column joint can only be attached in one position when Removing 
lower 
section 
of 
steering 
column 
-  Remove bolt -5- and fold down joint.
   Tightening torque: 40 Nm (30 ft lb)
Pa
ge 7 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3 
         
        
        
     
        
        Page 8 of 13
installing. 
 Repair Manual, Suspension, Wheels, Steering, Repair Group 48.
   
CAUTION! 
Do NOT under any circumstances pull steering column -4- out 
completely or push it in completely (   Repair Manual, Suspension, 
Wheels, Steering). 
-  Push back steering column (lower section) -4- until hole 2 in steering 
column (upper section) covers hole in steering column (lower section). 
-  Insert welding wire -3- in hole -2- and secure by wrapping once around 
steering column. 
Pa
ge 8 of 13 Instrument 
panel
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD03.70.3