1997 AUDI A4 automatic transmission

19

Diagnostic Trouble Code (DTC) Memory
interrogating, with VAG 1551 Scan Tool


Connecting Scan Tool (ST) VAG 1551- (up to
m.y. 1996)

- Move shift lever into position "P" or "N", and
apply parking brake (vehicles with Automatic
Transmissions).

- Open rear ashtray (center console) and remove Data Link Connector
(DLC) cover.

- With ignition turned OFF connect Scan Tool (ST) VAG 1551 to Data
Link Connector (DLC) with Adapter Harness VAG 1551/3.
Pa
ge 13 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6

39

Automatic Transmission Fluid (ATF),
checking (01V transmission)


Requirements for check:

Vehicle standing on level surface.
Transmission must not be in fail-safe mode.
Shift lever in "P" position, parking brake
applied.
Engine idling.
Air Conditioner and heater OFF.
ATF temperature must not exceed 40 C
(104 F) at start of test.

CAUTION!

Part numbers are for reference only. Always
check with your Parts Dept. for the latest
parts information.

Notes:

Only ATF with designation ESSO LT 71 141
Pa
ge 35 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6

may be used. Do not use any lubricant
additives.
Automatic transmission fluid: ATF, part
number G052 162 A2 (1 liter)
An ATF level check when transmission oil
temperature is too low results in overfilling;
when too high results in underfilling.
Pa
ge 36 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6

43

Final drive oil level, checking


Automatic transmission 01V all wheel drive

CAUTION!
If the oil level is too low, the transmission must be checked for leaks
and be repaired. It is not sufficient to just top off oil. - Remove oil filler plug -arrow- and check level.
Specification: oil level must be at bottom of filler hole.
- If there are no leaks, fill to correct level using gear oil: SAE 75 W 90
(synthetic oil), part number G 052 145 S2 (1 liter)
- Replace sealing ring on plug.
- Install plug and tighten to 30 Nm.
Pa
ge 41 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6

83

Scan Tool (ST) VAG 1551 Connecting

- Move shift lever into position "P" or "N" and
apply parking brake (vehicles with Automatic
Transmissions).

- Open rear ashtray (center console) and remove Data Link Connector
(DLC) cover.

Service Reminder Indicator (SRI) Programming - With ignition turned OFF connect Scan Tool (ST) VAG 1551 to DLC
with Adapter Harness VAG 1551/3.
- Turn ignition ON.
- Press key -1- for "Rapid Data Transfer" mode.
- Press keys -1- and -7- for address word "Dash Panel Insert"; confirm
with key -Q-.
-
Advance program with key.- Press keys -1- and -0- for "Adaptation" function; confirm with key -Q-.
Pa
ge 84 of 111 Descri
ption of wor
k
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.ME01.01.6