1997 AUDI A4 window

01-176

Display
field Display on VAG 1551
scan tool Malfunction cause
Malfunction repair
4 Not 001 10
Closed Throttle Position (CTP) switch -F60 activated or faulty A/C compressor switched on Rear window heating switched on Driving mode selected (automatic
transmission) - Check and adjust -F60- page 24
-
73

- Switch A/C off
- Check A/C compressor shut-off
page 24
-90

- Move selector lever to P or N
Note:
Display field 4 (shift inputs) can be used to recognize whether the components described below are recognized by the Engine
Control Module (ECM) as switched on or off. Display group 023 gives an exact description of the shift inputs. 0
0
1

1
0
Meaning of 5-digit shift inputs

1 = Shifting Signal (0 = not active / 1 = active)

2 = Gear recognition signal (always "1" except that display = "0" for automatic transmission vehicles with
gear engaged)

3 = -----------

4 = Mechanical Closed Throttle Position (CTP) switch (1 = closed / 0 = open)

5 = A/C compressor OFF/ON (0 = off, 1 = on)

6 = Rear window heater signal (always "0" except for vehicles without A/C and with rear window heater
on)
Pa
ge 247 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-205
Display group 023 Display shows
Display/specified value
Designation
Basic setting 23
1 2 3 4 X 1 = Upshift or downshift signal
XX 2 = Gear recognition signal and shifting signal
XX 3 = A/C compressor off/on and rear window heater signal
X 4 = A/C compressor shut-off Notes on display field 1:

The signal for upshift and downshift will only be output by the Transmission Control Module (TCM) for the automatic
transmission 01V. For vehicles without automatic transmission 01V, a "1" is always displayed.
Check upshift and downshift signal page 24
-103
.
X
Meaning of 1-digit display:

With vehicle not running:
Value "0" = Selector lever in R
Value "1" = Selector lever in 2,3,4,D,P,N

When driving-vehicle speed greater than 14 km/h (9 mph):
Value "0" = Ignition angle retarded for downshift selected
Pa
ge 289 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-207
Note on display field 3: X
X
Meaning of the 2-digit display:

1 = A/C compressor off/on (0 = off; 1 = on)
Notes:

On vehicles without A/C "0" is always displayed.
Check A/C compressor page 24
-90
.
The A/C compressor is shut off for approx. 12 sec. by -J192- when accelerating from a stop and from low speed.
If the gas pedal is released sooner, the time is reduced to a minimum of 3 sec. At wide open throttle, the A/C
compressor is switched off by the automatic transmission (kick-down switch).

2 = Rear window heating - Signal (0 = off; 1 = on)
Notes:
The rear window heating signal is only displayed on vehicles without A/C.
On vehicles with A/C "0" is always displayed.
Check rear window heater signal page 24
-88
.
Notes on display field 4:

If the A/C compressor is off display field 3; display field 4 can be used to recognize whether the compressor was
switched off by the engine control module. Meaning of the 1-digit display:
Pa
ge 292 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1