28-13
Ignition coil power output
stage, checking
Component locations page 28
-1 .
Fuse for ignition coils OK
Ignition coils OK; checking page 28
-16
Checking voltage supply
If the specified value is not obtained: - Disconnect 3-pin power output stage harness connector.
- Switch Fluke 83 multimeter to voltage range and connect between
Ground (GND) and terminals 1, 2 and 3 in sequence.
- Switch ignition on.
Specified value: approx. battery voltage
- Eliminate open circuit in wiring using wiring diagram.
Pa
ge 1 of 3 I
gnition coil
power out
put sta
ge, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.28.3
