39-44
Note:
Make sure gauge contact surface is precisely installed and free of oil. - Place end gauge on face of pinion shaft.
Note:
For transmissions with drive flange without polygon bearing ( Page 00
-
3 ) use VW385/2 centering disc instead of VW385/3 centering disc
opposite dial indicator. - Remove master gauge and install measuring mandrel into transmission
housing.
Dial indicator extension -A- = 6.5 mm long must be installed VW385/3 centering disc faces cover for final drive
- Install differential cover and tighten 4 bolts to 22 Nm (16 ft lb).
- Using adjustable ring, pull 2nd VW385/3 centering disc out as far as
possible, so mandrel can only just be turned by hand.
Pa
ge 20 of 43 Pinion shaft and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.5
39-57
Measuring friction torque (check
measurement)
Notes:
Tapered roller bearings for differential are low-
friction. Measurement of friction torque only has
a limited use as a check. Correct adjustment is
only possible by determining the total shim
thickness "Stotal."
Do not lubricate new tapered roller bearings for
measuring friction torque. The bearings have
already been treated by a special oil by the
manufacturer.
Pinion shaft removed
Friction torque specified values:
Note: - Install torque gauge 0-600 Ncm -A- on differential.
- Read friction torque.New bearings
Used bearings
200 - 350 Ncm 30 - 60 Ncm
Pa
ge 35 of 43 Pinion shaft and rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.5
