Downloaded from www.Manualslib.com manuals search engine 40-78
1 - Triple-rotor joint housing
2 - Triple-rotor star
3 - Axle shaft
Note:
CAUTION!
Do not let the rollers slide off the triple-rotor star
and fall to the floor. - Remove O-ring -arrow- from groove. - Mark installation positions of parts -1-, -2- and -3-. Noises while driving may result if the indicated
parts are not reassembled to their prior positions. Use a waterproof felt-tipped pen for marking
parts.
- Remove rubber gasket (arrow) from groove. - With triple-rotor joint housing clamped in vise, pull
axle shaft together with triple-rotor star upward out
of housing.
- Hold axle shaft in straight alignment to triple-rotor
joint and slowly push back triple-rotor joint housing
with other hand. - Mark installation position of rollers -1- on triple-
rotor star -2- using felt-tipped marker. Page 78 of 82Front Wheel Suspension, Shafts and Axle12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1
Downloaded from www.Manualslib.com manuals search engine 47-27
Brake system, bleeding
Brake system, bleeding (vehicles with
and without ABS, ABS/EDL)
Changing brake fluid
Repair Manual, Maintenance
Note:
Bleeding the brake system on vehicles with
ABS, ABS/EDL is performed as for vehicles
with conventional braking systems.
Only use new brake fluid conforming to US
standard FMVSS 116 DOT 4.
Genuine VW/Audi brake fluid conforms to this
specification.
Brake fluid is poisonous. Also due to its
corrosive effect brake fluid must not come into
contact with paintwork.
Brake fluid is hygroscopic, which means it
absorbs moisture from the ambient air and
should always be stored in air tight containers.
Rinse off spillages using plenty of water. Repair Manual, Brake System On Board Diagnostic (OBD), Repair Group 01 Page 1 of 3Brake system, bleeding12/7/2004http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.47.6
