Page 167 of 274
the way and turn to the left-see
wheel bolts about one turn.
Do
not yet r e move th e bolt s.
Position the vehicle jack under the ve
hicle:
There are two impressions at the front
and back under the body to show you
where to posit ion the
jack-see arrows in the illustration. The
f
ront impress ion is located approxi
ma te ly 6 inches (1 5 em) behind the front
wheel house. The rear impression is located
approximately
11 inches (27 em) in front of
t he rear wheel house.
An unstable surface under th e jack may cause the vehicle to s lip off the jack. A lways provide a firm base for the jack on the ground. necessary , use a board under the jack.
Page 168 of 274
Turn the handle on the jack until the jack
Do not raise the vehicle until you
are sure the jack is securely engaged.
Passengers must not remain in the
vehicle when it is jacked up.
Make sure that passengers wait in a safe place away from the vehicle
and well away from the roadway and
traffic .
- Adjust the jack and then contin ue to raise
the jack.
To raise the turn the handle raise the
Remove the wheel bolts using the han
d le of th e sc rewdriver from the
Mount the spare tire and remount the
wheel bolts lightly using the screwdriver
handle . The wheel
must be
Lower the Then go crossw ise
from one bolt to another tighteni ng them
firm ly .
Page 169 of 274
Notes
Please read the informatio n on pages
148 and 157 if you are going to be using the spare wheel or a spare tire which is
di fferen t from the tires on your vehicle .
After you change a tire:
Check the tire air pressure immediately.
Have the wheel
tightening torque
steel and wheel rims, the should have a torque of 80ft
you notice while changing a tire that the
wheel bolts are corroded and difficult to turn
then they should be replaced before
check the tightening torq ue.
Until then, drive with extra care and
at
the flat tire re paired as quickly as poss1ble and remounted on your Remou nt the wheel cover.
jack and tools securely in luggage compartment.
for temporary use only!