1996 TOYOTA TACOMA fuse

169
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See Fuse locationsº in Chapter 7-1 for
locations of the fuses.
Turn the ignition switch and inopera-
tive component off. Pull a suspected
fuse straight out and check it. Determine which fuse may be causing the
problem. The lid of the fuse box shows the name of the circuit for each fuse. See Part8 of this manual for the functions con-
trolled by each circuit.
Type A fuses can be pulled out by using the pull-out tool. The location of the pull- out tool is shown in the illustration. If you are not sure whether the fuse has
blown, try replacing the suspected fuse with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the CIGº,
RADIOº, DOMEº or A.Cº fuse, whichmay be dispensable for normal driving, and use it if its amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close as
possible to the rating. If the amperage is
lower than that specified, the fuse might
blow out again but this does not indicate
anything
wrong. Be sure to get the correct
fuse as soon as possible and return the
substitute to its original clip.
It is a good idea to purchase a set of spare
fuses and keep them in your vehicle for emergencies.
If the new fuse immediately blows out, there is a problem with the electrical sys-
tem. Have your Toyota dealer correct it as
soon as possible.
Checking and replacing fuses

170
Never use a fuse with a higher am-
perage rating, or any other object, in
place of a fuse. This may cause ex-
tensive damage and possibly a fire. CAUTION
!
If any washer does not work, the wash-
er tank may be empty. Add washer fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
and most auto parts stores. Follow the
manufacturer 's directions for how much
to mix with water.
NOTICE
Do not use engine antifreeze or any other substitute because it may
damage your vehicle's paint.
The following illustrations show how to
gain access to the bulbs and units. When
replacing a bulb or unit, make sure the
ignition switch and light switch are off. Use
bulbs or units with the wattage ratings giv-
en in the table.
NOTICE
Only use a bulb or unit of the listed type.
Light Bulbs and
UnitsBulb and Unit No.WType
Headlight unitsH605965/35Ð
Parking lights1685B
Front turn signal lights115627A
Rear turn signal lights115627A
Stop and tail lights115727/8A
Back-up lights115627A
License plate lights1943.8B
High mounted stop- light1685B
Adding washer fluid Replacing light bulbs and unitsÐ

Normal cab models Xtra-cab models
Overall length mm (in.) 4440 (174.8) *1
4910 (193.3) *1
4590 (180.7) *2
5055 (199.0) *2
Overall width mm (in.) 1690 (66.5) 1690 (66.5)
Overall height mm (in.) 1550 (61.0) *3,
5
1560 (61.4) *5
1555 (61.2) *4,
5
1575 (62.0) *6
1570 (61.8) *3,
6
1575 (62.0) *4,
6
Wheelbase mm (in.) 2625 (103.3) 3095 (121.9)
Front tread mm (in.) 1395 (54.9) *3
1425 (56.1)
1425 (56.1) *4
Rear tread mm (in.) 1415 (55.7) *3
1440 (56.7)
1440 (56.7) *4
Cargo weight rating kg (lb.) 500 (1100) *7
500 (1100)*7
430 (950) *8
430 (950)*8
295 (650) *9
*1 : Without rear step bumper
*2 : With rear step bumper
*3 : With P195/75R 14 tires
*4 : With P215/70R 14 tires
*5 : Unladen vehicle plus two occupants
*6 : Unladen vehicle
*7 : With 1 or 2 occupants
*8 : With 3 occupants
*9 : With 5 occupants
Part 8 Dimensions and weight
177
SPECIFICATIONS
Dimensions and weight
Engine
Fuel
Service specifications
Tires
Fuses
TWO-WHEEL DRIVE MODELS

183
Engine compartment (U.S.A.) Fuses (type A)
1. STOP 15 A: Stop lights, high-
mounted stoplight, cruise control system
2. ALT-S 7.5 A: Charging system
3. STA 7.5 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection sys-
tem, starting system, gauges and meters
4. OBD 10 A: On-board diagnosis sys-
tem
5. EFI 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection system
6. HORN 15 A: Emergency flashers,
horns
P195/75R14 200 (2.0, 29) 240 (2.4, 35) 14 x 5J
P215/70R14 200 (2.0, 29) 200 (2.0, 29) 14 x 6J
14 x 6JJ
P225/75R15 180 (1.8, 26) 200 (2.0, 29) 15 x 6J 15 x 7JJ
31x10.5R15LT 180 (1.8, 26) 200 (2.0, 29) 15 x 7JJ Tire size
Tire pressure
kPa (kgf/cm 2
or bar, psi)
Front RearWheel size
Wheel nut torque, N
m (kgf m, ft lbf):
110 (11.5, 83)
Tires Fuses

185
Fuses (type B)
27. HEATER 40 A:
A.Cº fuse
28. AM1 40 A: All components in STAº,
ECU-Bº, POWERº' RADIOº, CIGº,
GAUGEº, TURNº, ECU-IGº, WIPERº
and 4WDº fuses
29. AM2 30 A: All components in IGNº
fuse
30. POWER 30 A: Power windows, pow-
er door lock control system Fuses (type C)
31. ABS 60 A: Anti-lock brake system
32. ALT 80 A: All components in ABSº,
AM1º, STAº, ECU-Bº, POWERº, RA-
DIOº, CIGº, GAUGEº, TURNº, ECU-
IGº, WIPERº, 4WDº, HEATERº, A.Cº,
TAILº, PANELº, STOPº and ALT-Sº fuses