1996 TOYOTA TACOMA child seat

35
CAUTION!
After inserting the tab, make sure
the tab and buckle are locked.
Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and buckle.
If the seat belt does not function
normally, immediately contact
your Toyota dealer.
2. Fully extend the shoulder belt to put it in the lock mode.3. Place the shoulder belt between the vehicle seatback and the child restraint
system and allow it to retract. To hold the
child restraint system securely, let the
shoulder belt retract as far as it will go
while firmly pushing down the child re-
straint system.

36
CAUTION!
Make sure the the seat belt is secure-
ly locked. Also make sure the child
restraint system is secure by push-
ing and pulling it in different direc-
tions.
4. To remove the child restraint system, press the buckle-release button and al-
low the belt to retract.(B) INSTALLATION ON CENTER SEAT
(normal cab models) OR FRONT CEN-
TER SEAT (Xtra-cab models)
When installing a rear-facing child re-
straint system, follow the same proce-dures as when installing a forward-facing
child restraint system.
With the child restraint system installed, check that your driving position is satis-
factory and that the child restraint system
does not interfere with your driving.
If you driving position is not satisfactory, or the child restraint system interferes with your driving, install it at another position.

37
Split bench seatÐ
Adjust the passenger seat travel and
seatback position so that the child re-
straint system is securely restrained.
CAUTION!
Ignoring the above instructions may
result in a serious injury in case of
an accident.
1. Fasten the lap belt over the child re-
straint system following the instructions
provided by its manufacturer.
CAUTION!
After inserting the tab, make sure the tab and buckle are locked.
Do not insert coins, clips, etc. in
the buckle as this may prevent
you from properly latching the tab
and buckle.
If the seat belt does not function
normally, immediately contact
your Toyota dealer.
2. Make sure the belt is tight by pulling its
free end while you firmly push down the
child restraint system.