1996 TOYOTA COROLLA fog light

6
Anti-lock brake system warning light *1
Brake system warning light *1
Seat belt reminder light*1
Discharge warning light*1
Low oil pressure warning light*1
Malfunction indicator lamp*1
Open door warning light*1
SRS airbag warning light*1
Turn signal indicator lights
Headlight high beam indicator light
Overdrive-of f indicator light
Cruise control indicator light*
2
Rear window defogger indicator light
*
1: For details, see Service reminder indicators and warning
buzzersº in Chapter 1-5.
*
2: If this light flashes, see Cruise controlº in Chapter 1-6.
Indicator symbols on the instrument panel
ProCarManuals.com

Part 1Headlights and turn signals
59
OPERATION OF
INSTRUMENTS
AND CONTROLSÐ
Chapter 1-4
Lights, Wipers and
Defogger

Headlights and turn signals

Emergency flashers

Instrument panel light control

Interior light

Personal light

Luggage compartment light

Windshield wipers and washer

Rear window wiper and washer

Rear window defoggerTo turn the lights on, twist the knob on
the end of the lever.
Daytime running light system (Canada
only)ÐThe headlights turn on when the
parking brake is released with the engine
started, even with the light switch in the
OFFº position. They will not go off until
the ignition switch is turned off.
To turn on the other exterior lights and in-
strument panel lights, twist the knob to the
first clickstop.
Under the daytime running light system,
the headlights turn on at reduced intensi-
ty. Twist the knob to the second clickstop
to turn to full intensity for driving at night.FIRST CLICKSTOP: Only the parking,
tail, license plate, side marker and instru-
ment panel lights turn on.
SECOND CLICKSTOP: The headlights
also turn on.
If you remove the key with the headlights
left on, a buzzer reminds you to turn the
lights off when you open the driver's door.
NOTICE
To prevent the battery from being
discharged, do not leave the lights
on for a long period when the
engine is not running.
ProCarManuals.com

64
NOTICE
Do not operate the wipers if the
windshield is dry. It may scratch the
glass.
To turn the rear wiper and washer on,
twist the knob at the end of the lever.
The key must be in the ONº position.
The wipers will operate at intervals when
the lever is in the INTº position.
The washer squirts at the two marked knob
positions. The knob will automatically re-
turn from these positions when it is re-
leased.
If the washer does not work, check to see
whether the washer tank is empty. For in-
formation on adding washer fluid, see
Adding washer fluidº in Chapter 7-3.
NOTICE
Do not operate the rear wiper if the
rear window is dry. It may scratch
the glass.
To defog or defrost the rear window,
push the switch.
The key must be in the ONº position.
The thin heater wires on the inside of the
rear window will quickly clear the sur-
faces. An indicator light will illuminate to
indicate the defogger is operating.
Push the switch once again to turn the de-
fogger off.
With timer: The system will automatically
shut off after the defogger has operated
about 15 minutes.
Rear window defogger Rear window wiper and washer
ProCarManuals.com

95 If the indicator light flashes, contact your
Toyota dealer as soon as possible. There
may be a slippage of the drive belt or
trouble in the compressor. If this happens,
the air conditioning is automatically turned
off to avoid damage to the drive belt.
(b) Heating
1. Place the temperature control lever
anywhere except the LOW position.
When dehumidified heating is desired,
place the lever between the HIGH and
middle positions.
If cooler air is desired at face level for bi-
level operation, place the lever around the
middle.
2. Move the air intake control lever to the
OUTSIDE AIR position.
If quick circulation of heated air is desired,
move the lever to the RECIRCULATED
AIR position.
For normal use, it is best to keep the lever
in the OUTSIDE AIR position. Otherwise
the windows will fog up more easily.
3. Move the air flow control lever to the
FLOOR position.
If cooler air is desired at face level for bi-
level operation, place the lever to the BI-
LEVEL position.If the windshield fogs up easily, move the
lever to the FLOOR/WINDSHIELD posi-
tion.
For detailed information on air flow control
including other settings, see (f) Air flow
selectionº.
4. Move fan speed control lever any-
where except the OFFº position.
5. Leave the air conditioning on-off but-
ton in the ºOFFº position.
If dehumidifed heating is desired, press in
the air conditioning on-off button.
(c) Cooling
1. Place the temperature control lever
anywhere between the middle and LOW
positions.
If warmer air is desired at floor level for bi-
level operation, place the lever around the
middle.
2. Move the air intake control lever to the
OUTSIDE AIR position.
If quick circulation of cooled air is desired,
move the lever to the RECIRCULATED
AIR position.
For normal use, it is best to keep the lever
in the OUTSIDE AIR position.3. Move the air flow control lever to the
FACE position.
If warmer air is desired at floor level for bi-
level operation, place the lever to the BI-
LEVEL position.
For detailed information on air flow control
including other settings, see (f) Air flow
selectionº.
4. Move the fan speed control lever any-
where except the OFFº position.
5. Press in the air conditioning on-off but-
ton.
(d) Ventilation
1. Place the temperature control lever at
the LOW position.
2. Move the air intake control lever to the
OUTSIDE AIR position.
3. Move the air flow control lever to the
FACE position.
For detailed information on air flow control
including other settings, see (f) Air flow
selectionº.
4. Move the fan speed control lever any-
where except the OFFº position.
5. Leave the air conditioning on-off but-
ton in the OFFº position.ProCarManuals.com

96(e) Windshield defogging and defrost-
ing
To remove interior fog on the windshield:
1. Place the temperature control lever at
any position.
2. Move the air intake control lever to the
OUTSIDE AIR position.
3. Move the air flow control lever to the
WINDSHIELD position.
For detailed information on air flow con-
trol, see (f) Air flow selectionº.
4. Move fan speed control lever any-
where except the OFFº position.
5. Press in the air conditioning on-off but-
ton.
To remove frost or exterior fog on the
windshield:
1. Place the temperature control lever at
the HIGH position.
2. Move the air intake control lever to the
OUTSIDE AIR position.
3. Move the air flow control lever to the
WINDSHIELD position.
For detailed information on air flow con-
trol, see (f) Air flow selectionº.
4. Move fan speed control lever to the
HIº position.
5. Leave the air conditioning on-off but-
ton in the OFF position.(f) Air flow selection
FACE positionÐThis position directs the
air flow to face level.
BI-LEVELÐThis position directs the air
flow to face level and floor. Except in ven-
tilation, the air to the floor is slightly warm-
er than that to the face level.
FLOOR positionÐThis position directs
the air flow mostly to the floor.
FLOOR / WINDSHIELD position Ð This
position directs the air flow to the wind-
shield and front side windows as well as
the floor.
WINDSHIELD positionÐThis position di-
rects the air flow mostly to the windshield,
front side windows.
Do not use the WINDSHIELD position
during cooling operation in extremely hu-
mid weather. The difference between the
temperature of the outside air and that of
the windshield could cause the outer sur-
face of the windshield to fog up blocking
your vision.
(g) Operating tips

Be sure the air inlet grilles in front of the
windshield are not blocked by leaves
or other obstructions.
If air flow control is not satisfactory,
check the side vents. (See Side
ventsº after Heater controlsº.)

To help cool down the interior after
parking in the hot sun, drive for the first
few minutes with the windows open.
After the excess heat has blown away,
close the windows.

When driving on dusty roads, close all
windows. If dust thrown up by the ve-
hicle is still drawn into the vehicle after
closing the windows, it is recom-
mended that the air intake control le-
ver be set to the OUTSIDE AIR posi-
tion and the fan speed control lever
anywhere except the OFFº position.

If following another vehicle on a dusty
road, or driving in windy and dusty con-
ditions, it is recommened that the air
intake control lever be temporarily set
to the RECIRCULATED AIR position,
which will close off the outside pas-
sage and prevent outside air and dust
from entering the vehicle interior.ProCarManuals.com

99 (b) Heating
1. Place the temperature control lever
anywhere except the NO HEAT position.
If cooler air is desired at face level for bi-
level operation, place the lever around the
middle.
2. Move the air intake control lever to the
OUTSIDE AIR position.
If quick circulation of heated air is desired,
move the lever to the RECIRCULATED
AIR position.
For normal use, it is best to keep the lever
in the OUTSIDE AIR position. Otherwise
the windows will fog up more easily.
3. Move the air flow control lever to the
FLOOR position.
If cooler air is desired at face level for bi-
level operation, move the lever to the BI-
LEVEL position.
If the windshield fogs up easily, move the
lever to the FLOOR/WINDSHIELD posi-
tion.
For detailed information on air flow control
including other settings, see (e) Air flow
selectionº.
4. Move fan speed control lever any-
where except the OFFº position.(c) Ventilation
1. Place the temperature control lever at
the NO HEAT position.
2. Move the air intake control lever to the
OUTSIDE AIR position.
3. Move the air flow control lever to the
FACE position.
For detailed information on air flow control
including other settings, see (e) Air flow
selectionº.
4. Move fan speed control lever any-
where except the OFFº position.
(d) Windshield defogging and defrost-
ing
1. Place the temperature control lever at
FULL HEATING position.
2. Move the air intake control lever to the
OUTSIDE AIR position.
3. Move the air flow control lever to the
WINDSHIELD position.
For detailed information on air flow con-
trol, see (e) Air flow selectionº.
4. Move fan speed control lever to the
HIº position.
(e) Air flow selection
FACE positionÐThis position directs the
air flow to face level.BI-LEVEL positionÐThis position directs
the air flow to face level and floor. Except
in ventilation, the air to the floor is slightly
warmer than that to face level.
FLOOR positionÐThis position directs
the air flow mostly to the floor.
FLOOR / WINDSHIELD position Ð This
position directs the air flow to the wind-
shield and front side windows as well as
the floor.
WINDSHIELD positionÐThis position di-
rects the air flow mostly to the windshield,
front side windows.
(f) Operating tips

Be sure the air inlet grilles in front of the
windshield are not blocked by leaves
or other obstructions.

If air flow control is not satisfactory, check
the side vents. (See Side ventsº.)

When driving on dusty roads, close all
windows. If dust thrown up by the ve-
hicle is still drawn into the vehicle after
closing the windows, it is recom-
mended that the air intake control le-
ver be set to the OUTSIDE AIR posi-
tion and the fan speed control lever
anywhere except the OFFº position.ProCarManuals.com

186
14. FAN-I/UP 7.5 A: Multiport fuel injec-
tion system/sequential multiport fuel in-
jection system
15. SPARE 7.5 A: Spare fuse
16. SPARE 15 A: Spare fuse
17. SPARE 20 A: Spare fuse
18. HEAD (RH) 15 A: Right-hand head-
light
19. HEAD (LH) 15 A: Left-hand headlight
20. ALT-S 7.5 A: Charging system
21. EFI, F-HTR 15 A: Multiport fuel injec-
tion system/sequential multiport fuel in-
jection system, electronically controlled
automatic transmission system
22. DRL 7.5 A: Daytime running light sys-
tem23. HEAD (LH-UPR) 10 A: Left-hand
headlight (high beam)
24. HEAD (LH-LWR) 10 A: Left-hand
headlight (low beam)
25. HEAD (RH-UPR) 10 A: Right-hand
headlight (high beam)
26. HEAD (RH-LWR) 10 A: Right-hand
headlight (low beam)
27. OBD 7.5 A: On-board diagnosis sys-
tem
28. EFI 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system, electronically controlled auto-
matic transmission systemFuses (type B)
29. POWER 30 A: Power windows, pow-
er door lock system, electric sun roof
30. DEF 30 A: Rear window defogger
31. HEATER 40 A: Air conditioning sys-
tem
32. AM 2 30 A: Starting system and IGNº
fuse
33. FAN 30 A: Electric cooling fan and
FAN-I/UPº fuse
34. CDS 30 A: Electric cooling fan
ProCarManuals.com