133
Your engine is fitted with twin ground electrode spark plugs.
NOTICE
Use only twin ground electrode spark plugs for your engine perfor-
mance.
TANDEM MASTER CYLINDER BRAKE SYSTEM 
The tandem master cylinder brake sys- 
tem is a hydraulic system with two sepa-
rate sub-systems. If either  sub-system 
should fa il, the other will still work. Howev-
er, the pedal will be harder to press, and 
your stopping distance will be longer. 
Also, the brake system warning light may come on.
CAUTION!
Do not drive your vehicle with only a single brake system. Have your 
brakes fixed immediately.
BRAKE BOOSTER 
The brake booster uses engine vacuum to 
power-assist  the brakes. If the engine
should quit while you are driving, you can 
bring the vehicle to a stop with normal 
pedal pressure. There is enough reservevacuum for one or two stopsÐbut no more!
CAUTION!
  Do not pump the brake pedal if the 
engine stalls. Each push on the 
pedal uses up your vacuum re- serve.
 Even if the power assist is com- 
pletely lost, the brakes will still 
work.  But you will have to push the
pedal  hardÐmuch harder than nor-
mal. And your braking distance will
be longer.
ANTI-LOCK BRAKE SYSTEM (with ABSº warning light) 
The anti-lock brake system is designed to prevent lock-up of  the wheels during sud-
den braking or braking on slippery road surfaces. This assists the driver in con- 
trolling the vehicle under these circum-stances. 
The  anti-lock  brake system becomes op- erative after the vehicle has accelerated
to a speed in excess of approximately 10 
km/h (6 mph). It stops operating when the 
vehicle decelerates to a speed below 
approximately 5 km/h (3 mph). 
You may hear a sound in the engine 
compartment for a  few seconds when the
engine is started or just after the vehicleis started. This means that the anti-lock
brake system is in the self check mode, 
and does not indicate a malfunction.
Twin ground electrode spark 
plugs (5VZ-FE engine) Brake system  
137
3RZ-FE  engine
5VZ-FE engineThe engine number is stamped on the 
engine block as shown.
Your new vehicle carries theft preven-
tion labels which are approximately 56 mm (2.20 in.) by 16 mm (0.63 in.). The purpose of these labels is to reduce 
the incidence of vehicle thefts by facilitat- ing the tracing and recovery of parts from 
stolen vehicles. The label is designed so
that 
once it is applied to a surface, any at-
tempt to remove it will result in destroying
the integrity of the label. Transferringthese  labels intact from one part to anoth-
er, will be impossible.
NOTICE
You should not attempt to remove the theft prevention labels as it may
violate certain state or federal laws.
ÐEngine number Theft prevention labels (except for Canada)