1996 SUBARU LEGACY Replace bulb

B4M0530
5. B.SW SOFT (O)
—Broken brake light switch—
DIAGNOSIS:

Faulty stop light switch

Faulty harness/connector

Faulty stroke sensor

Faulty ABS/TCS control module
TROUBLE SYMPTOM:

TCS does not operate.
NOTE:
Operate the function FA0 in select monitor TCS mode, and
check the stop and brake switches by B1 LED ON/OFF. If
system is normal, LED comes on when depressing brake
pedal, and goes off when not depressing. If so, skip check
steps 2 through 4.
1. Check correct installation of stroke sensor.

OK
Not OK
Repair stroke sensor.
2. Check contact point of stop light switch.

OK
Not OK
Replace stroke sensor.
3. Check input voltage of ABS/TCS control mod-
ule.

OK
Not OK
Repair harness/connector.
4. Check stop light circuit.

OK
Not OK
Repair harness/connector.
Replace stop light bulb and/or fuse.
Replace ABS/TCS control module.




123
4-4bBRAKES
10. Diagnostic Chart with Select Monitor

7A2
CHECK ABS WARNING LIGHT BULB.
1) Turn ignition switch to OFF.
2) Remove combination meter.
3) Remove ABS warning light bulb from combination
meter.
: Is ABS warning light bulb OK?
: Go to step7A3.
: Replace ABS warning light bulb.
B4M0791A
7A3
CHECK WIRING HARNESS.
1) Disconnect connector from ABSCM.
2) Disconnect connector (F50) from relay box.
3) Turn ignition switch to ON.
4) Measure voltage between connector (F49) and chassis
ground.
: Connector & terminal
(F49) No. 54 (+) — Chassis ground ():
Is voltage 12 V?
: Go to next step.
: Repair broken wire in harness or connector.
5) Turn ignition switch to OFF.
6) Measure voltage between ABSCM connector (F49) and
chassis ground.
: Connector & terminal
(F49) No. 54 (+) — Chassis ground ():
Is voltage less than 3 V?
: Go to step7A4.
: Repair battery short of harness.
16
4-4cBRAKES [ABS 5.3 TYPE]
7. Diagnostics Chart for ABS Warning Light Circuit and Diagnosis Circuit Failure

B: CHECK INDICATOR AND CIRCUIT IN
CRUISE CONTROL MAIN SWITCH
DIAGNOSIS:

Bulb failure or open harness of the indicator circuit in the
cruise control main switch.
TROUBLE SYMPTOM:

Cruise control can be set, normally indicator does not
come on. (When main switch is pressed.)
1. Check cruise control main switch.
OK
Not OK
Replace bulb.
2. Check circuit between cruise control module
and cruise control main switch indicator light.
OK
Not OK

Repair or replace wiring harness.

If no output from the cruise control module,
replace the cruise control module.
Failure of the cruise control module.
B6M0275


12
6-2BODY ELECTRICAL SYSTEM
7. Diagnostics Chart for Power Line