Vehicle Symbols
These are some of the symbols you may find on your vehicle.
For example,
these symbols are used on an
original battery:
POSSIBLE A
CAUTION
INJURY
PROTECT EYES BY
SHIELDING
CAUSTIC
BURNS
SPARK
OR ,\I/,
COULD FLAME
EXPLODE BAllERY
These symbols are important for you and
your passengers
whenever your
vehicle is
driven:
DOOR LOCK
UNLOCK
SEAT
BELTS
These symbols have to
do with
your lights:
SIGNALS TURN
FOG LAMPS
# 0
These symbols
are
on some of
your controls:
WINDSHIELD
WIPER
WINDOW
DEFOGGER
VENTILATING FAN
These symbols are used on
warning and
indicator lights:
ENGINE k
COOLANT - t6
TEMP -
CHARGING I-1
BAllERY
SYSTEM
BRAKE
(0)
h
COOLANT
ENGINE OIL
e,
PRESSURE
ANTI-LOCK
(@)
BRAKES
Here are some
other symbols
you may see:
FUSE
P
LIGHTER n
HORN b
SPEAKER
b
FUEL e3
V
ProCarManuals.com
Safety Belt Use During Pregnancy Servicing Your Air Bag-Equipped Oldsmobile
The air bag affects how your Oldsmobile should be
Safety belts work for everyone, including pregnant
serviced. There
are Parts of the air bag system in several
women. Like all occupants, they are more likely to be
places around your vehicle. You don’t want the system
seriously injured if they don’t wear safety belts.
I to inflate while someone is working on your vehicle.
I Your Oldsmoblle retailer and the Silhouette Service
1 Manual have information about servicing your vehicle
1 and the air bag system. To purchase a service manual,
see “Service and Owner Publications” in the Index.
For up to two minutes after the ignition key is
turned off and the battery is disconnected, an air
bag can still inflate during improper service. You
can be injured
if you are close to an air bag when
it inflates. Avoid wires wrapped with yellow tape,
or yellow connectors. They are probably part
of
the air bag system. Be sure to follow proper
service procedures, and make sure the person
performing work for you
is qualified to do so.
The air bag system does not need regular maintenance.
A pregnant woman should wear a lap-shoulder belt, and
the lap portion should be
worn as low as possible, below
the rounding, throughout the pregnancy.
1-30 ~
ProCarManuals.com
Remote Lock Control (Option)
If your Oldsmobile has this option, you can lock and unlock
your doors and liftgate from up to
30 feet (9 m) away using
the key chain transmitter supplied with your vehicle. Your
Remote Lock Control operates
on a radio
frequency subject to Federal Communications
Commission (FCC) Rules.
This device complies with
Part 15 of the FCC Rules.
Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Should interference to this system occur, try this:
Check to determine if battery replacement is necessary.
See the instructions
on battery replacement.
Check the distance. You may be too far from your
vehicle. This product has a maximum range.
blocking the signal.
Check the location. Other vehicles or objects may be
See your Oldsmobile retailer or a qualified
technician for service.
Changes
or modifications to this system by other than an
authorized service facility could void authorization
to
use this equipment.
2-8
ProCarManuals.com
If you have the optional power sliding door (see “Power
Sliding Door” later
in this section), your remote
transmitter will have
a third button that has a van
symbol on
it. Press it to open or close the sliding door.
If the sliding door is locked, first press the unlock
symbol twice to unlock all doors, then press the van
symbol
to open the sliding door.
You can operate the power sliding door with
the remote
transmitter only when the power sliding door
ON/OFF
switch on the overhead console is in the ON position.
atchin- n-.smitter(s) To Your Vehicle -
Each
key chain transmitter is coded to prevent another
transmitter from unlocking your vehicle.
If a transmitter
is lost or stolen, a replacement can be purchased through
your retailer. Remember
to bring any remaining
transmitters with you when you go to your retailer.
When
the retailer matches the replacement transmitter to
your vehicle, any remaining transmitters must also be
matched. Once the new transmitter is coded, the lost
transmitter will not unlock your vehicle. Each vehicle
can have only four transmitters matched to it.
n 1tt acement
Under-normal use, the battery in your key chain
transmitter should last about two years.
You can tell the battery is weak if the transmitter won’t
work at the normal range in any location.
If you have to
get close to your vehicle before the transmitter works,
it’s probably time to change the battery.
ProCarManuals.com
Replacing the Battery in the Remote Transmitter
1. Insert a coin into the slot in the back of the transmitter,
and
turn it counterclockwise to open the cover.
2. Remove the cover.
3. Remove and replace the 3-volt battery (CR2032).
4. Reassemble the transmitter.
5. Check the transmitter operation.
Illuminated Entry System (Option)
This option comes with the optional Remote Lock
Control system.
When
you open the driver’s door (by itself or in
combination with any passenger door or
the liftgate) the
interior lamps will come on and then gradually dim to
off, 10 seconds after the last door is closed. (If the
driver’s door has not been opened, the interior lamps
will immediately dim to off.)
When you press the unlock symbol on your remote
transmitter, the lamps inside your vehicle will go on,
then gradually dim to off after about
40 seconds, unless
a door or the liftgate is opened.
When you turn on the ignition, the interior lamps will
immediately dim to off.
2-11
ProCarManuals.com
To manually close the power sliding door when the
sliding door
ON/OFF switch is in the ON position, pull
the inside or outside latch release or the edge
of the
door. Move the door about
4 inches (10 cm) toward the
closed position and release. The door will close
completely and latch for
you.
To manually close the power sliding door when the
ON/OFF switch is
in the OFF position, pull the inside or
outside latch release and slide the door
all the way
forward to the latch position.
Resetting the rower diding Door
The power sliding door may operate incorrectly or not
all because of the following conditions:
0 A low voltage or dead battery
0 Disconnecting the battery
0 If the GUAGES, TAIL or TURN B/U fuse is
removed or blown.
See “Fuse Panel”
in the Index for more information
about your fuse panel.
If any of these conditions occur, the power sliding door
will need to be reset. To do this, follow the directions
listed here. It will be easier
if you read through them
once before beginning this procedure.
1.
2.
3.
4.
5.
6.
Check to be sure the power sliding door is unlocked
and securely closed.
Turn the ignition switch to the
OFF position.
Turn
the power sliding door ON/OFF switch to OFF.
Remove the TAIL fuse from the fuse panel. Leave it
out for 30 seconds.
Reinstall the fuse and wait 10 seconds.
Move the
ON/OFF switch to the ON position.
2-
ProCarManuals.com
NOTICE:
Holding your key in START for longer than
15 seconds at a time will cause your battery to be
drained much sooner. And the excessive heat can
damage your
starter motor.
2.
3.
If it doesn’t start right away, hold your key in
START. If it doesn’t start in three seconds (or starts
but then stops), push the accelerator pedal about
one-quarter
of the way down for 12 more seconds, or
until it starts.
If your engine still won’t start (or starts but then
stops), it could be flooded with too much gasoline.
Try this:
Wait
15 seconds to let the starter motor cool down.
Then push your accelerator pedal all the way to the
floor. Hold it there. Then hold the key
in START.
This clears the extra gasoline from the engine. When
the engine starts, let go of the key and the accelerator
pedal.
If the engine still doesn’t start, wait another
15 seconds and repeat this step.
NOTICE:
Your engine is designed to work with the
electronics in your vehicle.
If you add electrical
parts or accessories, you could change the
way
the engine operates. Before adding electrical
equipment, check with your retailer.
If you don’t,
your engine might not perform properly.
If you ever have to have your vehicle towed, see
the part
of this manual that tells how to do it
without damaging your vehicle. See “Towing
Your Vehicle” in the Index.
2-25
ProCarManuals.com
Fog Lamps
Slide the lower lever on the lights control panel up to
turn on the fog lamps, down to turn them off.
An
indicator light next to the control will glow when the fog
lamps are on.
Your headlamps must be on for your fog lamps to go on.
Although your fog lamps will go
off when your high
beams are on, high beams are not recommended for
driving in fog.
Interior Lamps
Instrr--- Bt Panel Intensity Control
Slide the upper lights control all the way up to increase
the brightness of the instrument panel lights, down to
decrease the brightness. Slide the control all
the way
down to turn them off.
Interior Lights Control
Slide the upper lights control (located to the left of the
instrument panel cluster) all the way up to turn on the
interior lamps.
Interior Lights Override Switch
This switch is located to the left of the cigarette lighter
in the center instrument panel console. It has two
positions,
DOOR (on) and OFF, and overrides all
interior lamps except the reading lamps.
The interior lamps
go on each time you open the doors.
You can turn off these lamps
so that the doors may be
left open without running down the battery by turning
the interior lights override switch to
OFF.
2-49
ProCarManuals.com