1996 OLDSMOBILE AURORA spare wheel

Turn the spare tire retainer
bolt counterclockwise and
remove the retainer assembly.
Remove the wheel wrench and jack from the jack container.
Remove the spare tire from the trunk.
ProCarManuals.com

Removing the Flat Tire and Installing the
Spare Tire 2. Insert the pointed end of the wheel wrench into the
slot on the jack to create a jack handle.
3. Turn the end of the jack
clockwise
by hand to
raise the jack head a few
inches.
1. Use the wheel wrench to loosen the wheel nuts, but
don’t remove them.
ProCarManuals.com

CF I
II
I 11 INCHES -1 I- (28CM) & -1z INCHES 1
(19CM)
4. Near each wheel well is a notch in the frame to
position the jack head. You'll find the word
JACK
and an arrow stamped into the plastic near each
notch. Position the jack under the vehicle and raise
the jack head until it fits firrnly against the sheet
metal next to the word
JACK. Do not raise the
vehicle
yet. Put the compact spare near you.
1
Getting under a vehicle when it is jacked up is
dangerous.
If the vehicle slips off the jack, you
could be badly injured
or killed. Never get under
a vehicle when it is supported only by a jack.
NOTICE:
Raising your vehicle with the jack improperly
positioned will damage the vehicle or may allow
the vehicle to
fall off the jack. Be sure to fit the
jack lift head into the proper location before raising your vehicle.
ProCarManuals.com

7. Remove any rust or dirt
from the wheel bolts,
mounting surfaces and
spare wheel.
5. Raise the vehicle by rotating the wheel wrench
clockwise
in the jack. Raise the vehicle far enough
off the ground so there’s enough room for the spare
tire to fit.
6. Remove all the wheel nuts and take off the flat tire.
3
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after
a time. The wheel could come
off and cause an accident. When
you change a
wheel, remove any rust or dirt from the places
where the wheel attaches to the vehicle. In an
emergency,
you can use a cloth or a paper towel
to do this; but be sure to use
a scraper or wire
brush later, if you need to, to get all the rust or
dirt off.
ProCarManuals.com

Never use oil or grease on studs or nuts. If you
do, the nuts might come loose.
Your wheel could
fall
off, causing a serious accident.
8. Place the spare on the wheel mounting surface.
9. Replace the wheel nuts
with the rounded end
of
the nuts toward the
wheel. Tighten each nut
by hand until the wheel
is held against the hub.
10. Lower the vehicle by rotating the wheel wrench
counterclockwise on the jack. Lower the
jack
completely.
5-31
ProCarManuals.com

Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel to become loose
and even come
off. This could lead to an accident.
Be sure to use the correct wheel nuts. If you have
to replace them, be sure to get the right kind.
Stop somewhere
as soon as you can and have the’
nuts tightened with
a torque wrench to 100 lb-ft
(140 N-m).
NOTICE:
Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage.
To avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper
torque specification.
12. Then replace the wheel cover. Be sure to position
the alignment pin on the cover with the notch in the
wheel. Apply pressure around the edge of the cap to
snap
it in place.
Don’t
try to put the wheel cover on the compact
spare tire.
It won’t fit. Store the wheel cover in the
trunk until you have replaced the compact spare tire
with
a regular tire.
1 NOTICE:
Wheel covers won’t fit on your compact spare. If
you try to put a wheel cover on your compact
spare,
you could damage the cover or the spare.
5-32 .
ProCarManuals.com

Storing the Spare Tire and Tools
The compact spare tire is for temporary use only.
Replace the compact spare tire with a full-size tire as
soon as you can. See “Compact Spare Tire” later in this
section. See the storage instructions label to replace your
compact spare into your trunk properly.
Compact Spare Tire
Although the compact spare tire was fully inflated when
your vehicle was new, it can lose air after a time. Check
the inflation pressure regularly. It should be
60 psi
(420 Pa).
After installing the compact spare on your vehicle, you
should stop as soon as possible and make sure your
spare tire is correctly inflated. The compact spare is
made to perform well at posted speed limits for
distances up to
3,000 miles (5 000 krn), so you can
finish your trip and have your full-size tire repaired or
replaced where you want. Of course, it’s best
to replace
your spare with a full-size tire as
soon as you can. Your
spare will
last longer and be in good shape in case you
need it again.
NOTICE: -
When the compact spare is installed, don’t take
your vehicle through an automatic car wash with
guide rails. The compact spare can get caught on
the rails. That can damage the tire and wheel,
and maybe other parts
of your vehicle.
ProCarManuals.com

Don’t use your compact spare on other vehicles.
And don’t mix your compact spare tire
or wheel with
other wheels or tires. They won’t fit. Keep your spare
tire and its wheel together.
ITICE:
~
Tire chains won’t fit your compact spare. Using
them can damage your vehicle and can damage
the chains too. Don’t use tire chains on your
compact spare.
If You’re Stuck: In Sand, Mud,
Ice or Snow
What you don’t want to do when your vehicle is stuck is
to spin your wheels too fast. The method known as
“rocking” can help you get out when you’re stuck, but
you must use caution.
If you let your tires spin at high speed, they can
explode, and you or others could be injured. And,
the transaxle or other parts
of the vehicle can
overheat. That could cause an engine
compartment fire or other damage. When you’re
stuck, spin the wheels
as little as possible. Don’t
spin the wheels above
35 mph (55 km/h) as shown
on the speedometer.
ProCarManuals.com