Page 292 of 388

Federal Motor Vehicle Safety Standard No. 109. Grades
B and A represent higher levels of performance on the
laboratory test wheel than the minimum required by law.
Warning: The temperature grade for this tire is
established for a tire that is properly inflated and not
overloaded. Excessive speed, underinflation, or
excessive loading, either separately or in combination,
can cause heat buildup and possible tire failure.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced
carefully at the factory to give
you the longest tire life
and best overall performance.
In most cases,
you will not need to have your wheels
aligned again. However, if you notice unusual tire wear
or your vehicle pulling one way or the other, the
alignment may need to be reset.
If you notice your
vehicle vibrating when driving on a smooth road, your
wheels may need to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted
or corroded. If wheel
nuts keep coming loose, the wheel,
wheel bolts and wheel nuts should be replaced. If the
wheel leaks air, replace it (except some aluminum wneels, which
can sometimes be repaired). See
your
Aurora retailer if any of these conditions exist.
Your retailer will know the kind of wheel you need.
Each new wheel should have the same load carrying
capacity, diameter, width, offset and be mounted the
same way as the one it replaces.
If you need to replace any of your wheels, wheel bolts
or wheel nuts, replace them only with new GM original
equipment parts. This way, you will be sure to have
the right wheel, wheel bolts and wheel nuts
for your
Aurora model.
I
Using the wrong replacement wheels, wheel bolts
or wheel nuts on your vehicle can be dangerous.
It could affect the braking and handling of your
vehicle, make your tires lose air and make you
lose control. You could have
a collision in which
you or others could be injured. Always use the
correct wheel, wheel bolts and wheel nuts for replacement.
ProCarManuals.com
Page 300 of 388

Tires
To clean your tires, use a stiff brush with a tire cleaner.
NOTICE:
When applying a tire dressing always take care
to wipe off any overspray or splash from all
painted surfaces on the body or wheels of the
vehicle. Petroleum-based products may damage
the paint finish.
Sheet Metal Damage
If your vehicle is damaged and requires sheet metal
repair or replacement, make sure
the body repair shop
applies anti-corrosion material to the parts repaired or
replaced to restore, corrosion protection.
Finish Damage
Any stone chips, fractures or deep scratches in the finish
should be repaired right away. Bare metal will corrode
quickly and may develop into a major repair expense.
Minor chips and scratches can be repaired with touch-up
materials available from your retailer or other service outlets. Larger areas of finish
damage
can be corrected
in your retailer’s body and paint shop.
Underbody Maintenance
Chemicals used for ice and snow removal and dust control
can collect
on the underbody. If these are not removed,
accelerated corrosion (rust) can occur on the underbody
parts such as fuel lines, frame, floor pan, and exhaust system even though they have corrosion protection.
At least every spring, flush these materials from the underbody\
with plain water. Clean any areas where mud and other debris
can collect.
Dirt packed in closed areas of the frame should be
loosened before being flushed. Your retailer or an underbody
vehicle washing system can do this for you.
Chemical Paint Spotting
Some weather and atmospheric conditions can create a
chemical fallout. Airborne pollutants can fall upon and attack painted surfaces on your vehicle. This damage can
take two
forms: blotchy, ringlet-shaped discolorations, and
small irregular dark spots etched into the paint surface.
Although no defect in the paint job causes this,
Oldsmobile will repair, at no charge
to the owner, the
surfaces of new vehicles damaged
by this fallout
condition within
12 months or 12,000 miles (20 000 km)
of purchase, whichever occurs first.
6-54
ProCarManuals.com
Page 312 of 388
ENGINE COMPARTMENT
FUSE BLOCK
I II 11 FOGLAMP2 I II I
COOLING
FAN #2
ji
COOLING
FAN #3
Fuse
4
5
6
7
8
9
10
11
12
13
14
Usage
Air Conditioning Center
Open
Open
Horn
Open
Fog Lamp 2
Cooling Fan #2
Cooling Fan #3
Cooling Fan
ABS Main
ABS Pump
Motor
Fog Lamp
Horn
Flash to Pass
6-66
-
ProCarManuals.com
Page 314 of 388

Capacities and Specifications
Automatic Transaxle (Overdrive)
When draining or replacing torque converter, more fluid may be needed.
Pan Removal and Replacement .......................................... 6.5 quarts (6.0 L)
After Complete Overhaul .............................................. 11 quarts (10.5 L)
Cooling System ....................................................... 13 quarts (12.0 L)
Engine Crankcase ...................................................... 7 quarts (6.6 L)
When changingfilter, up to 0.5 quart (0.5 L) more oil may be needed.
Fuel Tank ......................................................... 19.4 gallons (73.4 L)
Windshield Washer Fluid Tanks ........................................ 3.8 quarts (3.6 L)
Windshield Wiper Blades (6.32 Pin Type) ............................... 22 inches (565 mm)
Power Steering
Pump Only ............................................................. 1 pint (0.5 L)
Complete System ..................................................... 1.5 pints (0.7 L)
Tire Pressures, Sizes ....................... See Tire-Loading Information label on driver’s door.
Wheel Nut Torque .................................................. 100 lb-ft (140 Nam)
Refrigerant (R-l34a), Air Conditioning .................. See refrigerant change label the hood.
ProCarManuals.com
Page 315 of 388

Air Conditioning Refrigerants
Not all air conditioning refrigerants are the same.
If the air conditioning system in your vehicle needs
refrigerant, be sure the proper refrigerant is used.
If you’re not sure, ask your Aurora retailer.
Vehicle Dimensions
Length ................ 205.4 inches (5 217 mm)
Width
.................. 74.4 inches (1 890 mm)
Height
.................. 55.4 inches (1 407 mm)
Wheelbase
............. 11 3.8 inches (2 89 1 mm)
Front Tread
.............. 62.5 inches (1 587 mm)
Rear Tread
.............. 62.5 inches (1 587 mm)
Engine Specifications
VIN Engine Code ........................... C
Type
.................................... V8
Displacement ........................ 4.0 Liters
Horsepower
............................. 250
Compression Ratio
...................... 10.3: 1
Firing Order
.................... -2-7-3-4-5-6-8
Thermostat Temperature
Specification
.................... 180°F (82°C)
Normal Maintenance
Replacement Parts
Air Cleaner Element .......... AC Type A- 1096C
Engine
Oil Filter ................ AC Type PF-58
Spark Plugs
................... AC Type041 -900
uap: 0.050 inch (1.52 mm)
ProCarManuals.com
Page 316 of 388
Engine Accessory Belt The 4.0L Aurora engine uses an engine accessory belt.
This diagram shows the features connected
by the belt
routing. See"Maintenance Schedu1e"in the Index for
when to check the belt.
1.
2.
3.
4.
5.
6.
Tensioner Arm Pulley
Power Steering Pump Pulley
Idler Pulley
Alternator Pulley
Air Conditioner Compressor Pulley
Harmonic Balancer
ProCarManuals.com
Page 319 of 388
I
KEEP ENGINE OIL
I AT THE PROPER I
I I
LEVEL AND CHANGE AS
RECOMMENDED
This section covers the maintenance required for your
Aurora. Your vehicle needs these services to retain its
safety, dependability and emission control performance.
n
Protection
Introduction
Your Vehicle and the Environment
Proper vehicle maintenance not only helps to keep your
vehicle in good working condition, but also helps the
environment. All recommended maintenance procedures
are important. Improper vehicle maintenance can even
affect the quality
of the air we breathe. Improper fluid
levels or the wrong tire inflation can increase the level
of emissions from your vehicle.
To help protect our
environment, and to keep your vehicle in good
condition, please maintain your vehicle properly.
Have you purchased th.e GM Protection Plan? The Plan
supplements your new vehicle warranties. See your Warranty and Owner Assistance booklet,
01- your Aurora
retailer
for details.
ProCarManuals.com
Page 320 of 388

How This Section is Organized
The remainder of this section is divided into five parts:
“Part
A: Scheduled Maintenance Services” shows
what to have done and how often. Some
of these
services can be complex,
so unless you are technically
qualified and have the necessary equipment, you should
let your retailer’s service department or another
qualified service center do these jobs.
Performing maintenance work on
a vehicle can
be dangerous. In trying to do some jobs, you can
be seriously injured.
Do your own maintenance
work only if you have the required know-how
and the proper tools and equipment for the job.
If you have any doubt, have a qualified
technician do the work. “Part
B: Owner Checks and
Services” tells you what
should be checked whenever you stop for fuel.
It also
explains what you can easily do
to help keep your
vehicle in good condition.
“Part
C : Periodic Maintenance Inspections’’
explains important inspections that your Aurora
retailer’s service department or another qualified service
center should perform.
“Part
D: Recommended Fluids and Lubricants” lists
some products
GM recommends to help keep your
vehicle properly maintained. These products,
or their
equivalents, should be used whether you do the work
yourself or have it done.
“Part
E: Maintenance Record” provides a place for
you to record the maintenance performed on your
vehicle. Whenever any maintenance is performed, be
sure to write
it down in this part. This will help you
determine when your next maintenance should be done.
In addition, it is a good idea to keep your maintenance
receipts. They may be needed to qualify your vehicle for
warranty repairs.
If you are skilled enough to do some work on your
vehicle, you will probably want to get the service
information
GM publishes. See “Service and Owner
Publications” in the Index.
7-2
ProCarManuals.com