Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-I 89
Antenna going downAntenna going up
16FO203
16F019800002406
REMOVAL SERVICE POINT
+A,REAR SEAT CUSHION REMOVAL
Raise and remove the seat cushion with the lever pulled.
INSTALLATION SERVICE POINT
.AqREAR SEAT CUSHION INSTALLATION
(1) Securely fit the attachment wire of the seat cushion
under the seatback.
(2) Pass the inner seat belt buckles through the cushion.
(3) Securely fit the lock plates of the seat cushion into
the holes in the floor.
INSPECTION
ANTENNA MOTOR INSPECTION
Disconnect the motor antenna control unit connector, connect
the positive terminal of the power supply to terminal (1) and
connect the negative terminal to terminal (4) to check that
the antenna goes up, and that when the connections are re-
versed, the antenna goes down.
MOTOR ANTENNA CONTROL UNIT INSPECTION
(1) Connect the harness connector to the motor antenna.
(Body harness)
(2) Disconnect the antenna motor connector.
(3) With the ignition switch in the ACC or ON position, operate
the radio switch and check the voltage between the termi-
nals during the period when the antenna is going up or
going down.
I
I
Antenna operating
directionTerminals to checkVoltage (V)
I
Down
UPl-310-13
3-410-13
TSB Revision
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player
Ring nut
Tbothsideofrack cable
Rack cable
16LO42700002407,8Loa1
7
Tooth side of rack cable
ANTENNA POLE REPLACEMENT(1) Remove the ring nut.
(2) Set the radio switch to ON. After the antenna pole has
extended, remove the antenna pole and rack cable as
an assembly._.(3) Extend the antenna pole up to its farthest point.
NOTEIf the motor end of the rack cable is bent, straighten it.
(4) Force the rack cable into the motor assembly with the
tooth side of the rack cable toward the luggage compart-
ment.(5) Turn the tooth side of the rack cable toward the rear of
the vehicle
(90” clockwise) to bring the rack cable into
mesh with the motor gear.
(6)Lightly pull the rack cable. If it comes out without resistance,
it means that the rack cable is not in mesh with the motor
gear. Recheck that the rack cable end is not bent before
repeating the above-mentioned steps (2) and (3).(7) With the antenna pole upright and the radio switch at
OFF, take up the rack cable. As the rack cable is takenup, insert the antenna pole toward the motor antenna.
(8) After the ring nut has been tightened, set the radio switchto ON and OFF to check the operation of the antenna
pole.
I
I
I
vi ~
I~
d
TSB Revisidn
Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Radio and Tape Player54-I 91
LCD AUTO CHANGERREMOVAL AND INSTALLATION
Z16FO49500002408
L
Removal steps
1. CD changer coverl Lu gage compartment floor carpet,big\ floor center board.2. CD auto changer
3. CD changer bracket (front)
4. CD changer bracket (rear)
TSB Revision
Downloaded from www.Manualslib.com manuals search engine 54-210CHASSIS ELECTRICAL - Theft-alarm System
CIRCUIT DIAGRAM
FUSIBLE LINK@IGNITIONI
2B-
(I
(
L)
3,t
Q
2)(I
@
i10
c-7’
Ob”
I
x
ObS
AAL,
D
'G0
DZ8
t
z
5
1
'ITCH(IG1)IGNITION SWITCH(ACC)
7_ ------ - ---- Tjj-
-l
0
15A@
15A
2R-B
FOG LIGHT
5TAILLIGHT.bARKING/
SIDE MARKER
LIGHT AND
b;gXySE PLATE
HEAD
LIGHT
RELAY
(A-O1X)16 (c-80)------____3
1
1
WITHOUTWITHACCESSORY ACCESS
SoCKET
0.85L
L 0.85LI--L
CIGARETTE
LIGHTER
\
>)
I
(R-Y‘3D-r2R-L;ORY
B-h
----IBACK-UP LIGHT
3-w
1B-W
RADIO ANDTAPE PLAYER
rFOG
LIGHT
3
>
1
(R-Y
0.85BI
@” L1GHTJGGAGEiyi;tRTMENT
(c-ol)&---------- ____ ,F
0.85B0.85R
* e8
2B,,3 (c-76)J/B'
A
\/ _
3 (c-82)28
n=
(R-Y)
HEADLIGHT
lO(c-65)
(R-Y(I
R-G
I8
Vk
i
LIGHT
AUTOMATIC
SHUT-OFF
UNIT
- -- -= =
(LH)(RH)\*/
DOORSWITCH
2hJ
5(E-17)._i
Y-B56
A
HRlJMOlAA
1 TSB Revision
Downloaded from www.Manualslib.com manuals search engine ALPHABETICAL INDEX0
OIL
Transmission, Replacement
eAWD>...........................................22-15- 1CFwD>............................................22-4-l
COOLER
Engine.............................................
11-36-lTransaxle..........................................23-62-lCOOLER HOSES, Transaxle..........................23-62-l
COOLER TUBES, Transaxle...........................23-62-lFILTER, Engine, Maintenance..........................00-48-l
LEVEL, Gear, Check
PRESSURE SWITCH, Power Steering, Check.........37A-13-l
SCREEN............................................11-23-lOPTICAL HORN LENS..............................54-106-11
P
PARK/NEUTRAL POSITION SWITCHAdjustment.........................................23-53-l
On-vehicle Inspection.........................13A-113,230-l
PARKING BRAKE......................................36-8-l
CABLE..............................................36-5-l
LEVER..............................................
36-5-lStroke Check........................................36-4-l
SWITCH, Check......................................36-4-l
POP-UP SWITCH...................................54-109-11
POSITION DETECTION SWITCH.....................338-19-l
POSITIVE CRANKCASE VENTILATION
SYSTEM, Inspection..................................
17-56-l
VALVE..............................................17-56-l
POWER STEERING
Stationary Steering Effort Check.......................37A-9-lFLUID............................................37A-10-I
GEAR BOX........................................37A-18-l
HOSES...........................................37A-33-l
OIL PRESSURE SWITCH, Check....................37A-13-l
OIL PUMP........................................37A-29-l
Pressure Test.....................................37A-12-l
PRESSURE SWITCH
On-vehicle Inspection.........................13A-121,235-l
POWER WINDOW....................................42-44-l
PROPELLER SHAFT...................................25-3-l
PROPORTIONING VALVE, Function Test.................35-65-l
PURGE CONTROL
SYSTEM, Check
PURGE PORT VACUUM, Check........................17-63-l
R
RADIATOR............................................14-5-l
CAP, Pressure Test....................................14-4-l
RADIO.............................................54-186-11
ANTI-THEFT SYSTEM..............................54-156-11
RADIO REMOTE-CONTROL.........................64-l 86-k
REAR OIL PUMP, 4WS...............................378-11-l
DISCHARGE FLOW VOLUME, Check..................378-5-l
REAR WINDOW DEFOGGER........................54-192-11
SWITCH..........................................54-203-11
REFRIGERANT
Leak Repair Procedure..............................55-28-lLINE
RIGHT MEMBER.......................................32-8-l
S
SEATFront
...........................................
52A-17-lRear . ............................................52A-25-lSEAT BELT.........................................52A-26-ISELECTOR LEVER...................................23-59-l
Operation Check....................................
23-51-lSENSORBarometric Pressure..............................Refer to B
Brake Fluid Level, Check.............................35-64-l
Camshaft Position................................Refer to C
Crankshaft Position...............................Refer to CEGR Temperature................................Refer to E
Engine Coolant Temperature.......................Refer to EFrontlmpact......................................528-68-IGcACTlVE EC%
..................................338-l 8-l
Heated Oxygen..................................Refer to H
Induction Control Valve Position.....................
Refer to IIntake Air Temperature.............................Refer to I
Knock..........................................RefertoKSteering Angular Velocity...........................338-l 8-l
Throttle Position..................................
Refer to T
Vehicle Speed...................................Refer to V
Volume Air Flow..................................Refer to VWheelSpeed....................................Referto WSHIFT LEVER
SHIFT LOCK MECHANISM, Check......................23-52-lSHOCK ABSORBER
Evaporative Emission Purge.......................
Refer to EFuel Pressure...................................Refer to F
Turbocharger Waste Gate.........................Refer to TSPARK PLUGMaintenance.......................................00-46-I
CABLE............................................
16-36-11SPEAKER..........................................54-187-11SPEEDOMETER CABLEReplacement
SPEED SENSOR, Wheel, Output Voltage Measurement....35-75-lSRSMaintenance.......................................00-53-IDIAGNOSIS UNIT (SDU)............................528-71-ISTABILIZER BARFront Suspension.................................33A-12-l
Rear Suspension