1996 Mercury Villager battery

Roadside Emergencies
257
%*
[RE02100(ALL)05/95]
Connecting the jumper cables
*
[RE02200(ALL)03/95]1.
Connect one end of the first jumper cable to the positive (+)
terminal of the discharged battery. (You can connect either
jumper cable to the positive (+) terminal, as long as you use
the same cable for both positive terminals.) Most jumper
cables have a red cable and a black cable. The red cable is
generally used for the positive terminals and the black for
the negative ones.
*
[RE02300(ALL)04/95]2.
Connect the other end of the first cable to the positive (+)
terminal of the booster battery.
*
[RE02400(ALL)05/95]3.
Connect one end of the second cable to the negative (s)
terminal of the booster battery Ð NOT to the discharged
battery.
*
[RE02500(ALL)04/95]4.
Connect the other end of the second cable to a good metallic
surface on the engine or frame of the disabled vehicle.
*
[RE02600(ALL)05/95]
RWARNING
Do not connect the end of the second cable to the
negative (-) terminal of the battery to be jumped. A spark
may cause an explosion of the gases that surround the
battery.
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

Roadside Emergencies
259
*
[RE02800(ALL)03/95]
Jump-Starting
*
[RE02900(ALL)03/95]1.
Make sure that the jumper cables are not in the way of
moving engine parts, then start the booster vehicle. Run the
engine at a moderate speed.
*
[RE03000(ALL)03/95]2.
Let the discharged battery charge for a few minutes and then
start the disabled vehicle. It may take a couple of tries before
the vehicle starts. If the vehicle does not start after several
attempts, there may be a different problem.
*
[RE03100(ALL)03/95]3.
When both vehicles are running, let them idle for a few
minutes to charge the discharged battery.
*
[RE03200(ALL)03/95]
Removing jumper cables
*
[RE03300(ALL)03/95]1.
Always remove the jumper cables in the reverse order.
Remove the negative (s) end of the jumper cable from the
metallic surface on the engine or frame of the disabled
vehicle.
*
[RE03400(ALL)05/95]2.
Remove the negative (s) cable from the booster battery.
*
[RE03500(ALL)06/95]3.
Remove the positive (+) cable from the booster battery.
*
[RE03600(ALL)05/95]4.
Remove the other end of the positive (+) cable from the
discharged battery.
[RE03750(ALL)02/95]
If you need to replace your battery, seeBatteryin theServicing
Your Villagerchapter.
*
[RE03800(ALL)01/93]
Changing a Flat Tire
*
[RE03900(ALL)01/95]
If you get a flat tire while you are driving, do not apply the
brake heavily. Instead, gradually decrease the speed. Hold the
steering wheel firmly and slowly move to a safe place on the
side of the road. Park on a level spot, turn off the ignition, set
the parking brake, and turn on the hazard flashers.
File:12vxren.ex
Update:Tue Jun 4 11:42:14 1996

275
Customer Assistance
%*
[HS00710(ALL)06/94]
Roadside Assistance
[HS00715(ALL)05/96]
Ford Motor Company has set up a 24-hour, seven-day-a-week
hotline with trained operators that put you in touch with the
help you need if you experience a problem with your vehicle.
This complimentary service is provided to you throughout your
warranty period of 3 years or 36,000 miles (60,000 km),
whichever comes first. To purchase Roadside Assistance
coverages beyond this period (available through Ford Auto Club
in the United States or Ford and Lincoln-Mercury dealers in
Canada), contact your Ford or Lincoln-Mercury dealer.
Additional Roadside Assistance coverage is unavailable in
Puerto Rico and the Virgin Islands.
*
[HS00720(ALL)06/94]
Roadside Assistance will cover the following:
*
[HS00725(ALL)06/94]
n
Mount your spare if you have a flat tire.
*
[HS00730(ALL)06/94]
n
Jump-start your battery if it is dead.
*
[HS00735(ALL)06/94]
n
Unlock your vehicle if you are locked out.
*
[HS00740(ALL)06/94]
n
Bring you fuel if you run out.
*
[HS00745(ALL)06/94]
n
Tow your vehicle if you are stranded. Even non-warranty
related tows, like accidents or getting stuck in mud or snow,
are covered (some exclusions apply, such as impound towing
and repossession).
*
[HS00750(ALL)06/94]
How to use Roadside Assistance
*
[HS00755(ALL)06/94]
Your Roadside Assistance identification card can be found in the
Owner Guide portfolio in your glove compartment. Complete
the card and place it in your wallet for quick reference.
*
[HS00760(ALL)04/95]
To receive roadside assistance in the United States call
1-800-241-FORD (in Canada call 1-800-665-2006).
*
[HS00765(ALL)04/95]
Should you need to arrange for roadside assistance yourself,
Ford Motor Company will reimburse the reasonable cost. To
obtain information about reimbursement call 1-800-241-FORD (in
Canada call 1-800-665-2006).
File:13vxhsn.ex
Update:Mon Jun 3 08:32:10 1996

296
*
[SV02250(ALL)09/93]
Use only recommended fuels, lubricants, fluids, and service
parts that meet Ford Motor Company specifications. Motorcraft
parts are designed and built to provide the best performance in
your vehicle. Using these parts for replacement is your
assurance that Ford-built quality stays in your vehicle.
%*
[SV02260(ALL)09/95]
NOTE: Always dispose of used automotive fluids in a
responsible manner. Follow your community's
standards for disposing of these types of fluids. Call
your local recycling center to find out about recycling
automotive fluids.
%*
[SV02300(ALL)06/95]
Precautions When Servicing Your Vehicle
*
[SV02400(ALL)06/95]
Be especially careful when inspecting or servicing your vehicle.
Here are some general precautions for your safety:
[SV02450(ALL)07/95]
n
Your vehicle is equipped with an automatic cooling fan. It
may come on at any time without warning. To avoid injury,
always disconnect the negative (-) terminal of the battery
before working near the fan.
*
[SV02600(ALL)06/95]
n
Do not work on a vehicle in an enclosed space with the
engine running, unless you are sure you have enough
ventilation.
*
[SV02700(ALL)08/95]
n
Never get under a vehicle while it is supported only by a
jack. If you must work under a vehicle, use safety stands.
*
[SV02800(ALL)06/95]
n
Keep all lit cigarettes and other smoking materials away
from the battery and all fuel-related parts.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

Servicing Your Villager
329
%*
[SV29650(ALL)04/95]
Cleaning the Wheels
*
[SV29675(ALL)05/95]
Wash the wheels with the same detergent you use to wash your
vehicle's body. Do not use acid-based wheel cleaners, steel wool,
abrasives, fuel, or strong detergents. These substances will
damage protective coatings. Use tar and road oil remover to
remove grease and tar.
*
[SV29700(ALL)04/95]
If you have whitewall tires that are difficult to clean with
regular detergent, use whitewall tire cleaner. Follow the
directions on the container and rinse the tires with plenty of
clean water.
*
[SV29725(ALL)09/95]
NOTE: Before going to a car wash, find out if the brushes are
abrasive.
%*
[SV29800(ALL)03/95]
Battery
[SV29900(ALL)05/96]
The Motorcraft low-maintenance battery requires periodic
service as detailed below. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed. For longer, trouble-free operation, keep
the top of the battery clean and dry. Also, make certain the
battery cables are tightly fastened to the battery terminals.
[SV30000(ALL)05/96]
If you see any corrosion on the battery cables or terminals,
remove the cables from the terminal and clean them both with a
wire brush. You can neutralize the acid with a solution of
baking soda and water. Reinstall the cables when you are done
cleaning them, and apply a small quantity of grease to the top
of each battery terminal to help prevent corrosion.
*
[SV30100(ALL)07/95]
Battery replacement
[SV30200(ALL)05/96]
If your original equipment battery requires replacement while
under warranty, it may be replaced by a Motorcraft
low-maintenance battery. The low-maintenance battery has
removable vent caps for checking the electrolyte level and for
adding water, if needed.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

ServicingYou rVillager
331
WARNING
To protec tyoursel fwhe nchargin gabattery ,always
WARNING
Batterie scontai nsulfuri caci dwhic hburn sskin ,eyes,
WARNING
Applyin gtoo muc hpressur eon theend swhe nliftin ga

364
*
[SV44300(ALL)01/95]
Do not drive your vehicle if it does not operate properly. See
your dealer if the engine runs on for more than five seconds
after you shut it off or if it misfires, surges, stalls, or backfires.
*
[SV44400(ALL)11/93]
Information about your vehicle's emissions control system is on
the Vehicle Emission Control Information decal located on or
near the engine. This decal identifies engine displacement and
gives some tune-up specifications.
%*
[SV44405(ALL)07/95]
Readiness for Inspection/Maintenance Testing
*
[SV44410(ALL)07/95]
In some localities it may become a legal requirement to pass an
Inspection/Maintenance (I/M) test of the On-Board Diagnostic
(OBD) II system. If the vehicle's powertrain system or its battery
has just been serviced, the OBD II system is reset to a not ready
for I/M testing condition. To prepare for I/M testing, the law
specifies a ªneed for additional mixed city and highway driving
to complete the checkº of the OBD II system. As soon as all of
the OBD II system checks are successfully completed, the OBD
II system is set to the ready condition. The amount of driving
required to reach the ready condition varies with individual
driving patterns. To complete this requirement in the minimum
amount of time, refer to the OBD II Drive Cycle defined below.
If the vehicle owner cannot or does not want to do the
additional driving required by law, a service center can perform
this drive cycle as it would any other type of repair work.
*
[SV44415(ALL)09/95]
OBD II Drive Cycle
*
[SV44420(ALL)06/95]
The following steps must be run in the order shown. If any
steps are interrupted, repeat the preceding step. Any safe
driving mode is acceptable between steps.
*
[SV44425(ALL)06/95]
Always drive vehicle in safe manner according to traffic
conditions and obey all traffic laws.
*
[SV44430(ALL)07/95]
The engine must be warmed up and at operating temperature
before proceeding with the drive modes of the following OBD II
Drive Cycle.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

370
%*
[SV46500(ALL)01/95]
Engine
*
[SV46600(ALL)01/93]
n
Start the engine every fifteen days. Run it at fast idle until it
reaches normal operating temperature.
*
[SV46700(ALL)01/93]
n
With your foot on the brake, shift the transaxle into all gears
while the engine is running.
%*
[SV46800(ALL)01/95]
Fuel system
%*
[SV47000(ALL)07/94]
n
Fill fuel tank with high-quality unleaded fuel until the first
automatic shutoff of the fuel pump nozzle.
*
[SV47100(ALL)09/95]
NOTE: During extended periods of vehicle storage (60 days or
more), fuel may deteriorate due to oxidation. This can
damage rubber and other polymers in the fuel system
and may also clog small orifices.
*
[SV47200(ALL)01/95]
Ford Gas Stabilizer should be added whenever actual or
expected storage periods exceed 60 days. Follow the instructions
on the label. The vehicle should then be operated at idle speed
to circulate the additive throughout the fuel system.
*
[SV47300(ALL)01/95]
A volatile corrosion inhibitor added to the fuel system will
protect the fuel system's inner surfaces from corrosion. Follow
the instructions packaged with the product.
%*
[SV47400(ALL)01/95]
Cooling system
*
[SV47500(ALL)01/93]
n
Protect your vehicle against freezing temperatures.
%*
[SV47600(ALL)01/95]
Battery
*
[SV47700(ALL)01/93]
n
Check and recharge the battery as necessary.
*
[SV47800(ALL)01/95]
n
Keep connections clean and covered with a light coat of
grease.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996