1996 Mercury Sable engine coolant

278
*
[SV18100(ALL)01/95]
Adding engine coolant
*
[SV18200(ALL)01/95]
RWARNING
Be careful when adding engine
coolant. Do not put engine coolant or
antifreeze in the container for the
windshield washer fluid. If sprayed
to clean the glass, engine coolant or
antifreeze could make it difficult to
see through the windshield.
[SV18300(ALL)11/94]
RWARNING
Never remove the pressure cap while
the engine is running or hot to avoid
personal injury that can be caused by
escaping steam or engine coolant.
[SV18500(ALL)04/95]
1. Before you remove the cap, turn the engine
off and let it cool. Even when the engine is
cool, be careful when you remove the cap.
[SV18600(ALL)02/95]
2. When the engine is cold, wrap a thick cloth
around the cap and turn it slowly
counterclockwise to relieve pressure.
*
[SV18700(ALL)03/95]
3. Step back while the pressure releases.
*
[SV18800(ALL)03/95]
4. When you are sure that all the pressure has
been released, use the cloth to turn and
remove cap.
*
[SV18900(ALL)02/95]
5. Stand away from the reservoir opening. Hot
steam may blow out or hot engine coolant
may even splash out.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

279
*
[SV19000(ALL)01/95]
RWARNING
Failure to follow these instructions
could result in serious personal
injury from hot engine coolant or
steam blowout and/or damage to the
engine cooling system or engine.
*
[SV19050(ALL)03/95]
To find out how much engine coolant mixture
your vehicle's coolant system can hold, seeRefill
capacities for fluidsin the Index.
[SV19100(ALL)04/95]
Add engine coolant only to the coolant
reservoir.If the coolant level is low, add to the
reservoir a 50/50 mixture of water and the type
of engine coolant that Ford specifies. You may
add water by itself only in an emergency, but
you should replace it with a 50/50 mixture as
soon as possible.
[SV19104(ALL)04/95]
Ford Premium Cooling System Fluid is an
optimized formula that will protect all metal and
rubber elastomers used in Ford engines for four
years or 50,000 miles (80,000 km). It is not
necessary and not recommended to use
supplemental coolant additives in your vehicle.
These additives may harm your engine cooling
system. Follow the recommended service interval
for changing your engine coolant.
*
[SV19106(ALL)04/94]
NOTE: When you change or add engine
coolant, it is important to maintain
your engine coolant concentration
between 40%(-11ÊF [-24ÊC]) and 60%
(-62ÊF [-52ÊC]),depending on your local
climate conditions. Below 40% you will
lose freeze protection and above 60%
your engine may overheat on a warm
day.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

280
*
[SV19107(ALL)02/95]
NOTE: Less than 40% of coolant concentration
may cause engine corrosion and
overheating. Plain water may be used
in an emergency only. Replace it with
the specified coolant as quickly as
possible.
*
[SV19108(ALL)03/95]
NOTE: The use of an improper coolant may
void your warranty for the engine
cooling system. Use only a premium,
nationally recognized brand name
engine coolant. Do not use alcohol,
methanol antifreeze or engine coolant
mixed with alcohol or methanol
antifreeze. If you do not use the proper
coolant, the aluminum engine on your
vehicle will corrode.
*
[SV19110(ALL)08/95]
Ford Motor Company expressly authorizes the
Ford Rotunda engine coolant recycling process
and chemicals. Use only Ford Rotunda recycled
engine coolant or an equivalent recycled engine
coolant that is certified by the supplier to meet
Ford specification ESE-M97B44-A.
*
[SV19112(ALL)04/95]
NOTE: Always dispose of used automotive
fluids in a responsible manner. Follow
your community's standards for
disposing of these types of fluids. Call
your local recycling center to find out
about recycling automotive fluids.
*
[SV19115(ALL)03/95]
Use Ford Premium Cooling System Fluid
E2FZ-19549-AA (in Canada, Motorcraft CXC-8-B)
or an equivalent engine coolant that meets Ford
Specification ESE-M97B44-A.
*
[SV19150(ALL)11/94]
Have your dealer check the engine cooling
system for leaks if:
*
[SV19200(ALL)11/94]
q
you have to add engine coolant more than
once a month, or
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

281
*
[SV19250(ALL)11/94]
q
you have to add more than a quart (liter) at a
time
%*
[SV19300(ALL)04/95]
Engine coolant drain and flush
*
[SV19350(ALL)11/94]
Proper procedures for a complete coolant drain
and flush of the cooling system can be found in
theCar Service Manual. Following these
recommended procedures will ensure that the
specified coolant level and a 50/50 or
appropriate mixture of coolant and water is
maintained.
%*
[SV19400(ALL)02/95]
Engine coolant refill procedure
*
[SV19450(ALL)01/95]
When the entire cooling system is drained and
refilled, the following procedure should be used
to ensure a complete fill:
[SV19500(ALL)04/95]
q
With the engine OFF and cool, remove the
pressure cap, located on the coolant reservoir.
[SV19550(ALL)04/95]
q
Add a 50/50 mixture of specified coolant and
water to the coolant reservoir. Refer toRefill
Capacitieslater in this chapter for the correct
amount.
[SV19600(ALL)02/95]
q
Continue to fill the reservoir until the coolant
is at the top of the cold fill range.
[SV19650(ALL)04/95]
q
Reinstall the pressure cap until it clicks.
*
[SV19700(ALL)03/95]
q
Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and coolant is flowing
through the entire system).
[SV19750(ALL)04/95]
q
Immediately shut off the engine and let cool.
Cautiously remove the pressure cap and add
a 50/50 mixture of specified coolant and
water until the coolant is within the cold fill
range in the coolant reservoir.
[SV19800(ALL)02/95]
q
Reinstall the pressure cap until a click is
heard and felt.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

282
*
[SV19850(ALL)03/95]
q
Check for leaks at the draincock.
*
[SV19900(ALL)03/95]
q
Recheck the engine coolant level, using the
recommended procedure, after one or two
occasions of vehicle use.
[SV19950(ALL)04/95]
About Your Battery
*
[SV20001(ALL)02/95]
Your vehicle may have a Motorcraft
maintenance-free battery. When the original
equipment battery is replaced under warranty, it
may be replaced by a Motorcraft
Low-Maintenance Battery.
[SV20850(ALL)04/95]
Because your vehicle's engine is electronically
controlled by a computer, some control
conditions are maintained by power from the
battery. If you ever disconnect the battery or
install a new battery, you must allow the
computer to ªrelearnº its idle conditions before
your vehicle will drive properly. To begin this
process, put the gearshift in P (Park), set the
parking brake, turn off all the accessories, and
start the vehicle. Bring the engine to normal
operating temperature. Allow the engine to idle
for one minute in N (Neutral) and one minute in
Drive or Overdrive. Perform the previous
procedure with the air conditioning on and off
(conditions permitting). The relearning process
will complete automatically as you drive the
vehicle.
*
[SV21000(ALL)03/95]
If you do not let the engine relearn its idle, the
idle quality of your vehicle may be adversely
affected until the idle is relearned. Your vehicle
will eventually relearn its idle while you drive
it, but it takes much longer than if you use the
previous procedure.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

284
*
[SV22400(ALL)01/95]
RWARNING
Do not add the windshield washer
fluid to the engine coolant reservoir.
This could damage your cooling
system. Do not add engine coolant to
the washer fluid reservoir. This could
damage your wiper/washer system.
*
[SV22500(ALL)01/95]
Use specially formulated windshield washer
fluid rather than plain water, because specially
formulated washer fluids contain additives that
dissolve road grime. For safety reasons, washer
fluids containing an appropriate antifreeze such
as methanol should be used in freezing weather
(temperatures below32ÊF [0ÊC]).State or local
regulations on Volatile Organic Compounds
(VOC's) may restrict use of the most common
antifreeze, methanol. Washer fluids containing
non-methanol antifreeze agents should be used
only if they provide cold weather protection
without damaging the vehicle's paint finish,
wiper blades, and windshield washer system.
[SV22550(ALL)04/95]
RWARNING
Washer solution contains methanol
which is poisonous. Observe all
warnings indicated on label of
washer solution.
[SV22600(ALL)06/94]
Checking the washer fluid for the
liftgate (If equipped)
[SV23100(ALL)04/95]
If your wagon has a rear window wiper, check
the reservoir for its washer fluid regularly. This
is not the same reservoir that your windshield
wipers use. The opening for this reservoir is on
the right side of the liftgate opening, below the
tail lamp. Refill this reservoir with the same
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

301
%*
[SV31200(ALL)03/95]
Power Steering Fluid
*
[SV31300(ALL)01/95]
Check the level of the power steering fluid at
least twice a year (i.e., every Spring and Fall).
%*
[SV31400(ALL)03/95]
Checking and Adding Power Steering
Fluid
*
[SV31500(ALL)02/95]
1. Start the engine and let it run until the
power steering fluid reaches normal
operating temperature. The power steering
fluid will be at the right temperature when
the engine coolant temperature gauge in the
instrument cluster is near the center of the
NORMAL operating temperature range.
*
[SV31600(ALL)01/95]
2. While the engine idles, turn the steering
wheel back and forth several times. Make
sure that the cap assembly is installed at this
time.
*
[SV31700(ALL)01/95]
3. Then turn the engine off.
[SV31800(ALL)04/95]
3.0L Vulcan engine:
%*
[SV31900(ALL)03/94]
4. Check the fluid level on the dipstick (which
is highlighted in yellow in your vehicle). The
fluid level should be between the arrows in
the FULL HOT range, which is marked on
the side of the dipstick, opposite the side
marked FULL COLD. Do not add fluid if the
level is within the FULL HOT range.
*
[SV32100(ALL)07/94]
5. If the power steering fluid is low, add fluid
in small amounts, continuously checking the
level, until you reach the FULL HOT range.
Do not overfill.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

Index 347
Index
A
ABS warning light
(see Anti-lock brake system)....... 83
Accessory position on the ignition..... 61
Additives, engine oil.......... 273
Air bag supplemental restraint system
description............... 23
disposal................ 32
driver air bag............. 23
indicator light............. 79
operation............... 28
proper seating............. 24
tone generator............. 31
wearing safety belts........... 23
Air cleaner filter
location............... 261
replacing............... 296
Air conditioning
electronic automatic temperature control
system............... 95
manual heating and air conditioning
system............... 93
Alarm, activating remote personal.... 135
Antifreeze (see Engine coolant)...... 276
Anti-lock brake system (ABS)
description.............. 204
warning light.............. 83
Anti-theft lug nuts and key....... 230
Anti-theft system
triggering.............. 137
warning light.............. 90
Audio system
(see Electronic sound system)..... 169
Autolamp system (see Headlamps).... 108
File:fcixs.ex
Update:Tue Aug 8 10:58:02 1995