COMFORT ADJUSTMENT
64
INSIDE REAR VIEW MIRROR
Pushing the switch changes the mode between
ªAUTOº and ªDAYº.
The indicator comes on when the ªAUTOº mode is selected.
ªDAYº mode: The mirror surface is normal.
ªAUTOº mode: If the mirror detects light from the
headlights of the vehicle behind you, the mirror surface
darkens slightly to reduce the reflected light.
When the inside rear view mirror surface changes, the
outside rear view mirror surfaces will also become darker.
When the ignition key is inserted and turned on, the inside
rear view mirror always turns on in the ªAUTOº mode.
Adjust it before driving so that the rear view is the best.
When the outside air temperature is low, it may take a little
longer for the mirror to darken in response to the detection
of headlights.
SEAT BELTS
Seat belt precautions
Lexus recommends that the driver and passengers in the
vehicle be properly restrained at all times with the seat belts
provided. Failure to do so could increase the chance of injury
and/or the severity of injury in accidents.
Baby or small child. Use a child restraint system which fits
your vehicle. See ªChild restraintº for details.
Child. If a child is too large for a child restraint system, the
child should sit in the rear seat and must be restrained using
the vehicle's seat belts. According to accident statistics, the
child is safer when properly restrained in the rear seat than
in the front seat. Do not allow the child to stand up or kneel
on either rear or front seats. If the shoulder belt falls across
the child's neck or face, have the child sit slightly closer to the
buckle so that the belt lays across the shoulder.
Pregnant woman. Lexus recommends the use of a seat
belt. Ask your doctor for specific recommendations. The lap
belt should be worn securely and as low as possible over the
hips and not on the waist.
Injured person. Lexus recommends the use of a seat belt.
Depending on the injury, first check with your doctor for
specific recommendations.
COMFORT ADJUSTMENT
65
CAUTION!
Persons should ride in their seats properly wearing
their seat belts whenever the vehicle is moving.
Otherwise, they are much more likely to suffer
serious bodily injury in the event of sudden braking
or a collision.
When using the seat belts, observe the following:
Use the belt for only one person at a time. Do not
use a single belt for two or more people ± even
children.
Avoid reclining the seatbacks too much. The seat
belts provide maximum protection when the
seatbacks are in the upright position. (See
ªAdjusting seatback angleº.)
Be careful not to damage the belt webbing or
hardware. Take care that they do not get caught or
pinched in the seat or doors.
Inspect the belt system periodically. Check for cuts,
fraying, and loose parts. Damaged parts should be
replaced. Do not disassemble or modify the
system.
Keep the belts clean and dry. If they need cleaning,
use a mild soap solution or lukewarm water. Never
use bleach, dye, or abrasive cleaners ± they may
severely weaken the belts.
Replace the belt assembly (including bolts) if it has
been used in a severe impact. The entire assembly
should be replaced even if damage is not obvious.
Front seat belt buckle illumination
Opening the driver's door lights up the driver's seat belt
buckle for easy use. The same applies for the front
passenger 's door and seat belt buckle.
The light remains on for 15 seconds after the door is closed,
but goes off immediately when all doors are locked.
