Page 26 of 455
04GENERAL SPECIFICATION DATA
8
INFORMATION Fuses
Type Autofuse (blade type) blow ratings to suit individual.................................................................................
circuits
Horns
Make/type Mixo TR99........................................................................
Starter motor
Make and type Bosch 12v.................................................................
BULBS
REPLACEMENT BULBS TYPE
Headlamps 12V 60/55W Halogen
Front side lamps 12V 5W bayonet
Side repeater lamps 12V 5W capless
Tail lamps 12V 5/21W bayonet
Direction indicator lamps 12V 21W bayonet
Number plate lamp 12V 5W capless
Reverse lamp 12V 21W bayonet
Rear fog guard lamp 12V 21W bayonet
Interior roof lamps 12V 10W festoon
Instrument illumination 12V 1.2W capless
Warning light panel 12V 1.2W bulb/holder unit
Hazard warning switch 12V 1.2W capless
CAUTION: The fitting of new bulbs with wattages in excess of those specified will result in damage
to vehicle wiring and switches.
Page 419 of 455

ELECTRICAL
7
DESCRIPTION AND OPERATION ALARM SYSTEM FUSES
When the vehicle immobilisation and alarm system is
fitted, three fuses are used to protect the circuit:
·Alarm system 15 amp fuse, main harness, located
behind instrument binnacle.
·Alarm sounder 20 amp fuse No.10, located in main
fuse box.
·Alarm system 5 amp fuse No.20, located in main
fuse box.
The main fuse box is positioned in the centre of the
fascia, in front of the main gear lever. A label in the
fuse box cover shows the circuits protected, the fuse
rating and their locations. They are also listed below.
MAIN FUSE BOX
Fuse No. Value (amps) Electrical circuit
1 15 Hazard warning lights
2 20 Interior lamp, horn
3 15 Wipers & washers - rear
4 10 Wipers & washers - front
5 15 Heater
6 7.5 Rear fog guard lamps
7 5 Radio/cassette player
8 15 Heated rear window
9 10 Cigar lighter
10 20 Alarm sounder
11 7.5 Headlamp - RH, dipped beam
12 7.5 Headlamp - LH, dipped beam
13 7.5 Headlamp - RH, main beam
14 7.5 Headlamp - LH, main beam
15 5 Side lamps - LH
16 5 Side lamps - RH
17 15 Stop & reverse lamps
18 20 Air conditioning
19 5 Air conditioning
20 5 Alarm system
Page 446 of 455

ELECTRICAL
21
REPAIR MAIN LIGHT SWITCH
Service repair no - 86.65.10
Remove
1.Remove steering column nacelle
See
STEERING, Repair, Steering column nacelle.
2.Disconnect main light switch multi-plug from
main harness.
3.Slacken locknut and release light switch from
slot in mounting bracket.
Refit
4.Fit light switch in mounting bracket.
5.Reconnect switch multi-plug.
6.Fit steering column nacelle
See STEERING,
Repair, Steering column nacelle.
HEATED REAR SCREEN, REAR FOG LAMP AND
HAZARD WARNING SWITCHES
Service repair no - 86.65.36 - Heated rear screen
Service repair no - 86.65.65 - Rear fog lamp
Service repair no - 86.65.50 - Hazard warning
Remove
1.Remove 2 screws and withdraw switch panel
from lower fascia.
2.Disconnect multi-plug from rear of switch.
3.On hazard warning switch only, remove 2
separate leads.
4.Press in spring retainers and withdraw switch
from switch panel.
Refit
5.Fit new switch into switch panel.
6.Reconnect switch multi-plug, and leads if
applicable.
7.Fit switch panel to lower fascia.