1996 FORD TAURUS stop start

193
*
[DR04451(ALL)09/95]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
%*
[DR04501(ALL)11/94]
Using a column-mounted gearshift
*
[DR04550(ALL)04/95]
If your gearshift is on the column, you can use
any of the following positions:
[DR04601(ALL)11/94]
one third page art:0000491-E
The column-mounted gearshift
*
[DR04650(ALL)01/95]
Once you place the gearshift securely into
position, gradually release the brake pedal and
use the accelerator as necessary.
%*
[DR05100(ALL)01/95]
R (Reverse)
*
[DR05200(ALL)08/95]
With the gearshift in the R (Reverse) position,
the vehicle will move backward. You should
always come to a complete stop before shifting
into or out of R (Reverse).
*
[DR05250(ALL)01/95]
N (Neutral)
*
[DR05275(ALL)01/95]
With the gearshift in the N (Neutral) position,
the vehicle can be started and is free to roll.
Hold the brake pedal down while in this
position.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

200 [DR08050(ALL)09/95]NOTE: If the O/D OFF indicator light is
flashing on and off repeatedly when
the vehicle is started or does not come
on when the O/D OFF switch is
pushed, it means that there is a
transaxle electronic system malfunction.
You should contact your dealer as soon
as possible or damage to the transaxle
could occur.
*
[DR08075(ALL)10/95]
The transaxle will be in the ªoverdrive onº
mode when the vehicle is started even if the
O/D OFF mode was selected when the vehicle
was last shut off.
*
[DR09025(ALL)01/95]
When to use 2 (Second)
[DR09050(ALL)11/94]
Use Second for start-up on slippery roads or to
give you more engine braking to slow your
vehicle on downgrades.
*
[DR09075(ALL)06/95]
When to use 1 (First)
*
[DR10025(ALL)11/94]
Use 1 (First) when added engine braking is
desired when descending steep hills.
*
[DR10050(ALL)11/94]
The automatic transaxle will shift to the proper
gear to ascend any grade without any need to
shift to 1 (First).
[DR10075(ALL)11/94]
Do not go faster than 38 mph (61 km/h) in this
gear. You can upshift from 1 (First) to D
(Overdrive) at any speed.
*
[DR10125(ALL)01/95]
P (Park)
*
[DR10150(ALL)11/94]
Always come to a complete stop before you shift
into P (Park). Make sure that the gearshift is
securely latched in P (Park). This locks the
transaxle and prevents the front wheels from
rotating.
[DR10160(ALL)04/95]
If your vehicle has a console mounted gearshift,
the gearshift indicator in the cluster is
illuminated in P (Park) only when the gearshift
button is released.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

203
*
[DR17000(ALL)09/95]
NOTE: If you are driving down a long or
steep hill, shift to a lower gear and do
not apply your brakes continuously. If
you apply your brakes continuously,
they may overheat and become less
effective.
%*
[DR17100(ALL)10/95]
Occasional brake squeal during light to moderate
stops does not affect the function of the brake
system and is normal. However, if the squeal
becomes louder or more frequent, have your
brakes inspected by your dealer or a qualified
service technician.
% [DR17350(ALL)02/95]
Anti-lock Brake System (ABS)
(If equipped)
*
[DR17450(ALL)05/95]
If your vehicle is equipped with the anti-lock
brake system (ABS), the wheels will not lock and
slide when you press down hard on the brake
pedal. The ABS automatically starts releasing
and reapplying the front brakes independently
and the rear brakes together whenever your
vehicle's wheels start to lock. When this
happens, you will feel the brake pedal pulsate.
This is an indication that the ABS is working
correctly and is normal.
*
[DR17500(ALL)05/95]
If the brake pedal is applied while the vehicle is
driven over uneven road surfaces, the ABS may
cycle and the driver may sense a pulsation in
the brake pedal, accompanied by a slight up and
down movement of the pedal height and a
clicking sound. This may also happen when
driving on an inclined surface such as a
driveway while making a sharp turn. This is a
normal condition.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

206
*
[DR19000(ALL)06/95]
The parking brake is not designed to stop a
moving vehicle, but you can use the parking
brake to stop your vehicle in an emergency if
the normal brakes fail. However, since the
parking brake applies only the rear brakes, the
stopping distance will increase greatly and the
handling of your vehicle will be adversely
affected.
*
[DR19050(ALL)03/95]
Always check the Brake Warning Light each
time you start your engine. Driving with the
parking brake on will cause the brakes to wear
out quickly and will reduce the fuel economy.
%
*
[DR19100(ALL)01/95]
Driving Under Special Conditions
%*
[DR19200(ALL)01/95]
Tips for Safe Driving
*
[DR19300(ALL)07/95]
As with any new vehicle, yours may drive and
handle differently from your previous vehicle.
Use care until you become accustomed to its
various features and driving characteristics.
*
[DR19400(ALL)03/95]
Operate your vehicle within reasonable limits.
Sudden acceleration, deceleration, turning, or
combinations of these maneuvers can cause a
vehicle to behave differently than anticipated.
%*
[DR19750(ALL)01/95]
Driving in Bad Weather
%*
[DR19800(ALL)01/95]
Slippery roads
*
[DR19900(ALL)03/95]
On some slippery road surfaces, front-wheel
drive may provide better acceleration than
rear-wheel drive. However, this does not mean
that your vehicle can stop any faster or any
better than a vehicle with rear-wheel drive.
Exercise the same caution while driving on
slippery roads with your front-wheel drive
vehicle as you would with a rear-wheel drive
vehicle.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

233
*
[RE14400(ALL)03/95]
Removing the anti-theft lug nut
*
[RE14600(ALL)03/95]
Insert the key over the locking lug nut. Make
sure that you hold the key square to the lug nut.
If you hold the key on an angle, you may
damage the key and the lug nut.
*
[RE14700(ALL)03/95]
Place the lug nut wrench over the lug nut key
and apply pressure on the key with the wrench.
Turn the wrench in a counterclockwise direction
to remove the lug nut.
*
[RE14800(ALL)09/95]
Reinstalling the anti-theft lug nut
*
[RE14900(ALL)03/95]
Insert the key over the locking lug nut. Place the
lug nut wrench over the lug nut key and, while
applying pressure on the key, install the lug nut.
*
[RE15050(ALL)03/95]
If the Engine Cranks But Does
Not Start or Does Not Start After
a Collision
*
[RE15100(ALL)07/95]
The Fuel Pump Shut-off Switch
*
[RE15200(ALL)07/95]
If the engine cranks but does not start or if you
have had a collision, the fuel pump shut-off
switch may have been triggered. The shut-off
switch is a device that stops the fuel pump
when your vehicle has been involved in a
substantial jolt.
*
[RE15250(ALL)07/95]
For information on how to check and reset the
fuel pump shut-off switch, seeFuel pump shut-off
switchin the Index.
%
*
[RE16400(ALL)05/95]
Towing Your Vehicle
[RE16500(ALL)10/95]
If you need to have your vehicle towed, contact
a professional towing service or, if you are a
member, your roadside assistance center. Your
Taurus should be towed from the front unless
conditions do not allow it. It is recommended
that your vehicle be towed with wheel lift or
flatbed equipment.
File:12fcret.ex
Update:Mon Jan 22 16:01:15 1996
ProCarManuals.com

265 [SV06850(ALL)04/95]
RWARNING
The fuel system may be under pressure. If
the fuel cap is venting vapor or if you
hear a hissing sound, wait until it stops
before completely removing the cap.
Otherwise, fuel may spray out and injure
you or others.
*
[SV06900(ALL)05/95]
2. Make sure that you pump unleaded fuel and
put the nozzle all the way inside the fuel
filler pipe.
[SV06950(ALL)09/95]
NOTE: To help reduce early nozzle shutoffs
and fuel spillage, park your vehicle so
that the fuel filler door is not
downhill. Do not tilt or turn the nozzle
upside down when filling. Avoid
excessively fast fuel dispensing rates
(over 10 gallons [38 liters] per minute).
*
[SV07150(ALL)08/95]
NOTE: If you spill any fuel on the body of
your vehicle, clean it off immediately.
The fuel may dull or soften the paint
if you do not wash it off.
[SV07200(ALL)10/95]
3. To replace the fuel cap, align the tabs on the
cap with the notches on the filler pipe. Turn
it clockwise until it stops.
*
[SV07250(ALL)10/95]
4. Push the fuel door closed.
[SV07275(ALL)04/95]
If the Service Engine Soon warning light comes
on and stays on when you start the engine, the
fuel cap may not be properly seated. Turn off
the engine, remove the fuel cap and replace it,
being careful to align the cap properly. For more
information, seeWarning lightsin the Index.
*
[SV07290(ALL)07/95]
If you lose the fuel cap, replace it with an
authorized Motorcraft or equivalent part.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

269
*
[SV10225(ALL)08/95]
Fuels can cause severe eye irritation and possibly
eye damage. If fuel is splashed in the eyes,
remove contact lenses (if worn), flush with large
amounts of water for 15 minutes, and seek
medical attention.
*
[SV10230(ALL)08/95]
If you are taking the medication ªAntabuseº or
other forms of disulfiram for the treatment of
alcoholism, vapor or skin contact with a
gasoline-methanol blend may cause the same
kind of adverse reaction as drinking an alcoholic
beverage. In sensitive individuals, serious
personal injury or sickness could result. Consult
a physician promptly if you experience an
adverse reaction.
[SV10250(ALL)05/95]
Fuel line service
[SV10270(ALL)11/94]
Fuel injection systems operate with pressurized
fuel. The fuel lines are under pressure even
when the engine is off. This system should be
serviced by an authorized dealer using only
Ford approved parts. Using other materials may
be hazardous or allow hydrocarbon emissions
above the legal levels set by the Federal
Government.
%*
[SV11300(ALL)05/95]
Running Out of Fuel
[SV11500(ALL)05/91]
If your vehicle runs out of fuel, try to stop on
level ground away from traffic. Add at least one
gallon (four liters) of fuel to start your vehicle
again. If your vehicle is not on level ground,
you may need as much as five gallons (20 liters)
of fuel to start it.
*
[SV11550(ALL)07/95]
You may need to crank the engine several times
before the fuel system starts to pump fuel from
the tank to the engine.
*
[SV11575(ALL)08/95]
If the engine does not start, check the fuel pump
shut-off switch and reset as required. SeeFuel
pump shut-off switchin the Index.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

326
*
[SV42420(ALL)09/95]
OBD II Drive Cycle
*
[SV42430(ALL)06/95]
The following steps must be run in the order
shown. If any steps are interrupted, repeat the
preceding step. Any safe driving mode is
acceptable between steps.
*
[SV42440(ALL)06/95]
Always drive vehicle in safe manner according
to traffic conditions and obey all traffic laws.
*
[SV42445(ALL)07/95]
The engine must be warmed up and at
operating temperature before proceeding with
the drive modes of the following OBD II Drive
Cycle.
*
[SV42450(ALL)06/95]
1. Start the engine. Drive or idle (in neutral)
the vehicle for 4 minutes.
*
[SV42460(ALL)06/95]
2. Idle the vehicle in drive for 40 seconds.
*
[SV42465(ALL)07/95]
3. Accelerate the vehicle to 45 mph (70 km/h)
at 1/4 to 1/2 throttle for 10 seconds.
*
[SV42471(ALL)07/95]
4. Drive the vehicle with a steady throttle at
45 mph (70 km/h) for 30 seconds.
*
[SV42475(ALL)06/95]
5. Idle the vehicle in drive for 40 seconds.
*
[SV42481(ALL)07/95]
6. Continue to drive the vehicle in city traffic at
speeds between 25 and 40 mph
(40-60 km/h) for 15 minutes. During the 15
minute drive cycle the following modes must
be achieved:
*
[SV42485(ALL)07/95]
a. at least 5 stop and idle modes at 10
seconds each
*
[SV42491(ALL)07/95]
b. acceleration from idles at 1/4 to 1/2
throttle position, and
*
[SV42495(ALL)07/95]
c. choose 3 different speeds to do 1.5
minute steady state throttle drives.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com