1996 FORD RANGER key

28
[SR12605(R )05/95]
Passenger Air Bag Deactivate Switch
[SR12610(R )05/95]
If your vehicle is equipped with the passenger air bag option, it
also has a passenger air bag deactivate switch. The switch is
located at the lower center of the instrument panel, next to the
ashtray. The switch must be used to turn off the passenger air
bag when a rear-facing infant seat is installed in the right front
or center front passenger seat position. To turn the passenger air
bag off:
[SR12615(R )05/95]
NOTE: If the yellow peel-off label is still on the switch, pull
the tab to remove it, and discard it.
[SR12620(R )05/95]1.
Insert the ignition key into the switch.
[SR12625(R )05/95]2.
Rotate the ignition key clockwise until the key points to the
word OFF printed on the instrument panel.
[SR12630(R )05/95]3.
Remove the ignition key.
[SR12635(R )05/95]
RWARNING
In order to avoid inadvertent deployment of the
passenger air bag, always remove the ignition key from
the passenger air bag deactivate switch.
[SR12640(R )05/95]4.
Check that the amber OFF light illuminates when the
ignition switch is placed in ON.
[SR12645(R )05/95]
RWARNING
If the light fails to illuminate when the passenger air bag
switch is in the OFF position and the ignition switch is
in ON, have the passenger air bag switch serviced at
your Ford or Lincoln-Mercury dealer immediately.
[SR12650(R )05/95]
The passenger air bag will remain off until it is turned on.
When the infant seat is removed, turn the air bag on. To turn
the passenger air bag on:
File:03unsrr.ex
Update:Wed May 1 13:43:56 1996

Safety Restraints
29
[SR12655(R )05/95]1.
Insert the ignition key into the switch.
[SR12660(R )05/95]2.
Rotate the ignition key counterclockwise until it points to the
ON printed on the instrument panel.
[SR12665(R )05/95]3.
Remove the ignition key from the switch.
[SR12670(R )05/95]4.
Check that the amber OFF light is not illuminated when the
ignition switch is placed in ON.
[SR12675(R )05/95]
RWARNING
If the light is illuminated when the passenger air bag
switch is in the ON position and the ignition switch is in
ON, have the passenger air bag switch serviced at your
Ford or Lincoln-Mercury dealer immediately.
[SR12680(R )05/95]
The amber OFF light warns the driver and any passengers that
the passenger air bag is turned off. The passenger air bag
should be turned off ONLY when the rear-facing infant seat is
installed at the right front or center front seats.
[SR12685(R )05/95]
RWARNING
Keep the passenger air bag turned on unless there is a
rear-facing infant seat installed in the front seat. When
the passenger air bag switch is turned off, the passenger
air bag will not inflate in a collision.
File:03unsrr.ex
Update:Wed May 1 13:43:56 1996

Safety Restraints
31
[SR12900(ALL)06/95]
The driver air bag is in the center of the steering wheel. The
right front passenger seat air bag (if equipped) is in the upper
right hand section of the instrument panel ledge above the
glove compartment.
*
[SR13010(ALL)07/95]
If a collision occurs, the sensors sense the severity of the impact
and activate the air bags if necessary. The air bag system is
designed to deploy in frontal and front-angled collisions more
severe than hitting a parked vehicle (of similar size and weight)
head-on at about 28 mph (45 km/h). Because the system senses
the crash severity rather than vehicle speed, some frontal
collisions at speeds above 28 mph (45 km/h) will not inflate the
air bag.
*
[SR13020(ALL)07/95]
When the sensors activate the system, the air bags inflate
rapidly, filling with non-toxic nitrogen gas in a fraction of a
second. Immediately after inflation, the air bags deflate by
releasing the nitrogen gas through vent holes. The whole
process takes place in a matter of seconds.
*
[SR13030(ALL)07/95]
RWARNING
Air bag system components get hot after inflation. Do
not touch them after inflation.
%*
[SR13050(ALL)05/95]
The air bag system uses a readiness light on the instrument
cluster and a tone to indicate the condition of the system. When
you turn the ignition key to the ON position, this light will
illuminate for approximately six (6) seconds and then turn off.
This indicates that the system is operating normally. NOTE:
Maintenance of the air bag system is not required.
File:03unsrr.ex
Update:Wed May 1 13:43:56 1996

41
Starting Your Ranger
*
[ST01700(ALL)03/95]
Ignition
%*
[ST01800(ALL)01/95]
Understanding the Positions of the Ignition
[ST02000(ALL)04/94]
7-1/2 pica art:0021143-A
The positions of the key in the ignition lock cylinder.
%*
[ST02201(ALL)07/95]
ACCESSORY allows some of your vehicle's electrical accessories
such as the radio and the windshield wipers to operate while
the engine is not running.
*
[ST02301(ALL)01/95]
In order to turn the key from the ON or OFF position to the
ACCESSORY position, you must push the key release button if
your vehicle's manual transmission gearshift is mounted on the
floor.
*
[ST02401(ALL)08/95]
LOCK locks the steering wheel and gearshift lever.
*
[ST02501(ALL)10/95]
RWARNING
LOCK does not lock the gearshift on console or
floor-mounted manual transaxle gearshifts. If the parking
brake is not set and the gearshift is moved out of gear,
your vehicle may move unexpectedly and injure someone.
[ST02600(R )06/95]
A neutral tow feature is available on your vehicle. See your
dealer for more information.
File:04unstr.ex
Update:Wed May 1 13:44:22 1996

42
*
[ST02601(R )05/95]
RWARNING
Do not leave the vehicle unattended with the transfer
case in the N (Neutral) position. Always set the parking
brake fully and turn off the ignition when leaving the
vehicle.
*
[ST02651(ALL)01/95]
LOCK is the only position that allows you to remove the key.
The LOCK feature helps to protect your vehicle from theft.
*
[ST02701(ALL)05/95]
If your key is stuck in the LOCK position and will not turn,
move your steering wheel left or right until the key turns freely.
*
[ST02801(ALL)03/95]
OFF allows you to shut off the engine and all accessories
without locking the steering wheel or the automatic
transmission gearshift lever.
*
[ST02901(ALL)05/95]
ON allows you to test your vehicle's warning lights (except the
brake system warning light) to make sure they work before you
start the engine. The key returns to the ON position once the
engine is started and remains in this position while the engine
runs.
*
[ST02951(ALL)03/95]
START cranks the engine. Release the key once the engine starts
so that you do not damage the starter. The key should return to
ON when you release it. The START position also allows you to
test the brake warning light.
%*
[ST03025(ALL)08/95]
Ignition Key Buzzer or Chime
*
[ST03050(ALL)08/95]
The buzzer or chime will sound if you open the driver's door
while the key is in the ignition. Never leave your vehicle
unattended with the key in the ignition.
File:04unstr.ex
Update:Wed May 1 13:44:22 1996

Starting Your Ranger
43
%*
[ST03076(ALL)02/95]
Removing the Key From the Ignition
*
[ST03100(ALL)08/95]
Procedures for removing your key from the ignition will vary,
depending on the type of gearshift your vehicle has. Gearshift
levers may be mounted on the steering column or on the floor
or console.
[ST03117(ALL)05/91]
If you have a manual transmission, you have a key release lever
which allows you to remove your key from the ignition. The
key release lever is on the upper right of the steering column,
just above the key lock cylinder.
*
[ST03300(ALL)08/95]
If your vehicle's gearshift lever is mounted on the
column:
*
[ST03400(ALL)06/95]1.
Put the gearshift in P (Park).
*
[ST03500(ALL)03/91]2.
Set the parking brake fully before removing your foot from
the service brake. (This will avoid ªbindingº or ªloadingº the
park gear if you park on a grade.)
*
[ST03600(ALL)03/95]3.
Turn the ignition key to LOCK.
*
[ST03700(ALL)03/95]4.
Remove the key.
*
[ST03800(ALL)05/95]
If your vehicle's gearshift lever is mounted on the
floor:
*
[ST03950(ALL)05/95]1.
Put the gearshift in 1 (First).
*
[ST04000(ALL)05/95]2.
Turn the ignition key to OFF.
*
[ST04100(ALL)05/95]3.
Set the parking brake fully before removing your foot from
the service brake.
*
[ST04200(ALL)05/95]4.
Push and hold in the key release button.
*
[ST04300(ALL)05/95]5.
Turn the key to LOCK.
*
[ST04400(ALL)05/95]6.
Remove the key.
File:04unstr.ex
Update:Wed May 1 13:44:22 1996

Starting Your Ranger
45
*
[ST05400(ALL)01/95]
Before you start your vehicle, do the following:
*
[ST05500(ALL)08/95]1.
Make sure all occupants in the vehicle buckle their safety
belts. SeeSafety Restraintsin the Index for more details.
*
[ST05600(ALL)03/95]2.
Make sure the headlamps and other accessories are turned
off when starting.
*
[ST05700(ALL)10/94]3.
If you have an automatic transmission,make sure that the
gearshift lever is in P (Park) and the parking brake is set
before you turn the key.
*
[ST05800(ALL)03/91]4.
If you have a manual transmission,make sure that the
parking brake is fully set, push the clutch pedal to the floor,
and put the gearshift into Neutral before you turn the key.
(Remember, the starter will operate only if the clutch pedal
is pushed in all the way).
*
[ST06000(ALL)03/95]
Before you start your vehicle, you should test the warning lights
on the instrument panel to make sure that they work. Refer to
theWarning Lights and Gaugeschapter.
%*
[ST06200(ALL)02/95]
Starting Your Engine
*
[ST06300(ALL)06/95]
To start your engine:
*
[ST06400(ALL)05/95]1.
Follow the steps underPreparing to Start Your Vehicleat the
beginning of this section.
*
[ST06425(ALL)03/95]2.
Turn the ignition key to the ON position.
*
[ST06451(ALL)06/95]3.
DO NOT depress the accelerator pedal when starting your
engine. DO NOT use the accelerator while the vehicle is
parked.
*
[ST06475(ALL)02/95]4.
Turn the key to the START position (cranking) until the
engine starts. Allow the key to return to the ON position
after the engine has started.
*
[ST06501(ALL)02/95]
If you have difficulty in turning the key, rotate the steering
wheel slightly because it may be binding.
File:04unstr.ex
Update:Wed May 1 13:44:22 1996

46
%*
[ST06510(ALL)04/95]
For a cold engine:
*
[ST06515(ALL)06/95]
n
At temperatures10ÊF (-12ÊC) andbelow:If the engine does
not start infifteen (15) secondson the first try, turn the key
to OFF, wait approximately ten (10) seconds so you do not
flood the engine, then try again.
*
[ST06520(ALL)04/95]
n
At temperaturesabove10ÊF(-12ÊC):If the engine does not
start infive (5) secondson the first try, turn the key to OFF,
wait approximately ten (10) seconds so you do not flood the
engine, then try again.
%*
[ST06521(ALL)05/95]
For a warm engine:
*
[ST06522(ALL)04/95]
n
Do not hold the key in the START position for more than
five (5) secondsat a time. If the engine does not start within
five (5) seconds on the first try, turn the key to the OFF
position. Wait a few seconds after the starter stops, then try
again.
*
[ST06575(ALL)08/95]
Whenever you start your vehicle, release the key as soon as the
engine starts. Excessive cranking could damage the starter.
*
[ST06601(ALL)09/95]
After starting, allow the engine to idle for a few seconds before
driving away.
%*
[ST06775(ALL)04/95]
If the engine does not start after two attempts:
*
[ST06825(ALL)04/95]1.
Turn the ignition key to the OFF position.
*
[ST06851(ALL)04/95]2.
Press the accelerator all the way to the floor and hold it.
*
[ST06876(ALL)04/95]3.
Turn the ignition key to the START position.
*
[ST06900(ALL)04/95]4.
Release the ignition key when the engine starts.
*
[ST06925(ALL)04/95]5.
Release the accelerator gradually as the engine speeds up.
Then drive away in the normal manner.
*
[ST06951(ALL)04/95]
If the engine still does not start, the fuel pump shut-off switch
may have been triggered. For directions on how to reset the
switch seeFuel Pump Shut-Off Switchlater in this chapter.
File:04unstr.ex
Update:Wed May 1 13:44:22 1996